I smelled a strong order of gas when driving, when I checked under the hood there was a constant dripping fro the fuel rail supplying the fuel injectors...first , it was a small dripping on the front valve cover and after 2-3 months its a strong continuous dripping filling up the valve cover spilling into the manifold area. I have restricted driving my car to 5-7 miles at a time to prevent possible fires. My mechanic called the dealership to see how much they cost and this u-shaped aluminum tubing about 14" long ,8" connecting tube where it is leaking from to another piece of aluminum 14" tubing that goes underneath the manifold is $300.00 and $150 to install it. I think it is a factory defect that the manufacturing dealer is gouging almost punishing them for needing the part by charging 3xs what the piping/tubing really should cost. My mechanic and I have been all over the web looking for the same part but all of them say its a discontinued parts and can only be bought by the dealership. What a rip off they know its a factory defect and in high demand but they are not making anymore than that want to make to keep the demand high and to make a big profit on a design mistake in their fuel system design that they sold to the public. They probably knew it was a defective design but pushed it through anyway.
The worst 1991 Dodge Dynasty problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Fuel system24
- Transmission22
- Brakes18
- Electrical17
- Steering13
- Airbags7
- Engine7
- Seat belts5
- Acceleration2
- Suspension2
- Visibility2
- Body1
- Tires1
- Wheels1
Specific symptoms reported on the 1991 Dodge Dynasty
Recalls 5
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- The ABS hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.
- Risk
- If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
- Remedy
- Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
Recall number 96V099000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
- Risk
- Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
- Remedy
- Replace the ABS high pressure hose with a hose of different design and construction.
Recall number 91V191000 · Recall details
Visibility: defroster/defogger/HVAC system: fan/motor
- What is wrong
- Water leaking under windshield cowl in area above heater blower motor resistor block results in corrosion of the resistor terminals.
- Risk
- Corrosion of the resistor terminals increases electricalresistance, leading to overheating and possble ignition of the wiring connectorsand insulation, causing a fire in the cowl area.
- Remedy
- The blower motor resistor block will be replaced, and a mastic patch applied to seal the cowl against water entry. Damaged wire connectors will be replaced.
Recall number 91V004000 · Recall details
Seat belts: front: anchorage
- What is wrong
- Front outboard safety belt may become difficult to latch and or unlatch due to a webbing stiffener entering the buckle housing and dislodging the buckle latch guide.
- Risk
- Latch may open during accident or sudden stop, exposingseat occupant to increased risk of injury.
- Remedy
- Replace buckle latch engagement.
Recall number 91V122000 · Recall details
Service brakes, hydraulic: foundation components: disc: caliper
- What is wrong
- Front disc brake caliper guide pin bolts may not have been adequately torqued and could loosen.
- Risk
- This could cause reduced braking effectiveness and couldresult in an accident.
- Remedy
- Properly torque front brake caliper guide pin bolts to 250 pounds.
Recall number 90V162000 · Recall details
See all 5 recalls for the 1991 Dodge Dynasty
Defect investigations
Abs braking malfunction
There is no summary currently available
EA95016
Technical service bulletins for the 1991 Dodge Dynasty 33
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Subject regarding airbag / clock spring service for various models including 2002 model year jeep liberty
- Automatic transmission fluid usage ATF+4
- Subject regarding wire splice repairs
- Subject regarding child seat tether anchors
- Subject regarding non-deployed airbag handling procedures
- This bulletin provides a revised wire splice procedure and related parts
- Daimlerchrysler corporation is now offerinb airbag on / off switches for selected vehicles
- Subject on the child seat tether anchors
- This bulletin announces the availability and installation of a resuable automatic transmission oil pan gasket
- Information on child seat tether anchors
1991 Dodge Dynasty fuel economy
Official EPA estimates in miles per gallon (MPGe for electric). Ranges cover trims that share the same engine.
| Engine | Drive | City | Highway | Combined |
|---|---|---|---|---|
| 2.5L 4‑cyl | FWD | 18 | 24 | 20 |
| 3.0L 6‑cyl | FWD | 18 | 24 | 20 |
| 3.3L 6‑cyl | FWD | 17 | 24 | 19 |
What 1991 Dodge Dynasty owners say
Most recent owner complaints, unedited.
Abs anti-lock system warning light goes on at times, then off other times. Followed by ABS anti-lock system functions to fail totally reduced brakes to stop vehicle by 95% used parking brake to achieve stop.
Leakage of fuel at the fuel rail connections, above the valve covers, which drains onto the manifold and could start a fire. I am told it will cost over $700 to replace the parts which cannot be bought anywhere else.
Purchased said vehicle in sept. 2006 used. Was just driving at posted speed limits in a community area of phoenix, when all of a sudden a loud clacking noise started as I pulled up to my designation, so I turned off the motor, lifted the hood and immediately noticed that the tension pulley had nearly completely came off the motor. It did cause the serpintine belt to come off of all the pullies of the motor. I had to have the vehicle towed home, again for the second time since sept. 2006. Hen the vehicle was at my home I finished removing the pulley that was loose, causing it to bent enough to throw it totally off of its tension purpose. Upon removal a bolt was also broken which may have caused the total problem because it was not tightened to torque specs. Had to replace both parts attached to this pulley.
For the third time within a 3 year period my car will start and run for about 2 seconds and turn off, I had it towed and the mechanics would replaced the main computer, or say they did, and charge me a great deal of money. I searched recently on the internet to see if others have had the same problem, and I found that it is a defective part problem found at this site---http://autorepair.about.com/library/a/1f/bl111f.htm I should not have to pay for a defective part which is tied in to an anti theft feature.
Both rear set belts have trouble being pulled out. They seem to get stuck and cannot be used. This could result in serious injury or death to rear passengers. I have yet to fix the problem.
Purchased vehicle used oct. 2006. Near mint condition. Power everything & everything functions perfect. Vehicle emissions perfect. Approx. 4 days after final registration was switched, plated, & insured, I hopped onto the freeway, doing about 65 MPH. When suddenly in a matter of seconds, I was totally overwhelmed by the smell of gas. I became seriously nauseous and light headed and had to immediately exit the freeway to find somewhere to pull over as fast as I possible could without causing an accident or more serious a fatality. Once, I managed to pull over I pulled the hood latch, jumped out to get a breath of fresh air, I popped the hood to try to see where this gas was coming from. All I could see was gas spaying out all over the place, in massive amounts just like a high pressure hose at a car wash. 1\4 tank leaked out all over the top of the engine & all over the intake manifold of my car. I thanked god, that the engine was not hot enough to ignite the whole car, with me inside. After getting the vehicle towed home, we found out it was the fuel rail feeder that distributes gas to the fuel injectors. The after researching other dodge vehicles I found out there was an undocumented recall for this part, this car year, make and model when it first came out, and that chrysler/dodge continued to install this same part on other years, makes & models & daimler chrysler/ dodge was, very well aware of this. Last year they grossed $16.63 million dollars in 2005 with $1.5 million in losses & they can't afford to repair this for $700.00 just makes my stomach turn. Now knowing that I could have been killed or could have possibly caused a serious or even fatal injury to someone else, because of daimler chrysler's neglect in admitting this is a defective manufactured part, and them taking full responsibility for this is outrageously unbelievable to say the least.
1991 dodge dynasty, 3.3l engine. Fuel rail leaking, at crossover tube connection. Fuel leaking down onto vavle cover, which then leaked onto hot exhaust manifold. Minor fire, but thank god I was in my driveway when I smelled the fuel. Opening the hood revealed the small fire that started. The dodge dealer wants 300.00 for the part, and I feel chrysler should pay for this part since it is not a "wear" item, nor is it a moving part, or in a location prone to wear. Had my wife or myself been driving and the fire occured, this could have been a very dangerous situation, and I would have considered a law suit. Any help you can provide me would be great. If you can provide a complaint number to call for chrysler, I will do so. I feel they should at least pay for the part. Vehicle is currently parked, as I cannot locate a used replacement. This is creating a major headache, as we need 2 vehicles, and cannot afford to replace the dynasty at this time, nor can we afford (or justify) 300+ for the repair. Thank you.
I own a 1991 dodge dynasty, 3.3 liter. The fuel rail started leaking at the joint on the front, behind the valve cover.
While driving at any speed and without warning, the transmission failed. *ak *tt
Compare the 1991 Dodge Dynasty
Other model years
Questions about the 1991 Dodge Dynasty
Is the 1991 Dodge Dynasty reliable?
Owners have filed 108 complaints about the 1991 Dodge Dynasty, 2.0 times a typical Dynasty model year.
What is the most common problem with the 1991 Dodge Dynasty?
Fuel and propulsion system, with 24 complaints. Next is transmission (22).
How many recalls does the 1991 Dodge Dynasty have?
5 recalls, covering service brakes, hydraulic, visibility and seat belts.
What year does the Dodge Dynasty have the most fuel system problems?
The Dodge Dynasty model years with the most fuel system complaints are 1991 (24 complaints) and 1990 (10 complaints).
What gas mileage does the 1991 Dodge Dynasty get?
Official estimates for the 1991 Dodge Dynasty range from 19 to 20 mpg combined. The most efficient version (2.5L 4-cyl, FWD) gets 18 city and 24 highway.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1991 Dodge Dynasty?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history