The contact owns a 2009 Ford Escape. The contact stated while driving 45-55 MPH and depressing the brake pedal, the brake pedal traveled down to the floorboard and the vehicle failed to respond. The contact depressed the brake pedal harder, and the vehicle came to a complete stop. The contact drove to the residence, where the ABS warning light was illuminated. The vehicle was taken to an independent mechanic, who referred the contact to the dealer for assistance. The vehicle was taken to the dealer, where it was diagnosed that the ABS module had failed and needed to be replaced; however, the part was on backorder. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the federal safety agency Hotline for assistance. The failure mileage was approximately 160,000. The VIN was not available.
Ford Escape spongy pedal problems
26 of the 27,615 owner complaints about the Ford Escape describe soft or spongy brake pedal, most of them for the 2009 model year.
- owner complaints
- 26
- worst model year
- 2009
- typical mileage
- 99,500
By model year
Often reported together
ABS 15Brake failure 3Won't start 1Loss of power 1Jerking 1Engine failure 1Check engine light 1Grinding brakes 1
Trouble codes mentioned
U0418 1P0685 1C1524 1C1480 1C1313 1
What owners say
The contact owns a 2020 Ford Escape. The contact stated while driving at an undisclosed speed, the brake pedal was depressed; however, the vehicle failed to stop as intended. The contact stated that the brake pedal felt spongy. The contact stated that the brake pedal had to be pushed unusually hard to activate the brakes. In addition, the contact stated that several unknown warning lights were illuminated. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The manufacturer was made aware of the failure but provided no assistance. The contact was informed of Customer Service Program: 21B19; however, the contact was informed that the VIN was not associated with the Customer Satisfaction Program. The contact was advised to report the failure to the federal safety agency Hotline. The failure mileage was approximately 34,000.
ABS brake light goes on and off and regen system disabled appeared. Brake pedal goes between being spongy and going to floor. I took it to an independent service center and the mechanic almost lost control of the car when test driving. There was no braking except to one wheel, which is why he almost lost control. They thought they fixed the problem by bleeding the brakes, but soon after I got it back on April 8, 2024 the ABS and brake lights came back on April 10, 2024. I am afraid that it will cause an accident if the brakes go out. The car is back at the mechanics and they are going to inspect the brake system. Not sure when the car will be fixed and returned back to me.
In Jan 2019, we bought this certified pre-owned car. Recently, we received a recall noticed that involved the timing system. We took it in and was told that the system was resolved and there was no further issues. Two days after leaving the dealer, the check engine light came on. The car began having the same issues that where present before taking it in for the recall timing issues. When I called to return the car, I was told that there was no further issues to address and I was responsible for any further concerns. Shortly after my brake pedal became stiff and was difficult to stop. I was able to get it stopped safely. The next day the engine died and would not start. After taking it to a mechanic, I was told the the engine would need to be replaced due to the timing belt snapping. The car had less than 70,000 miles on it and if there were any issues with the timing belt they should have been caught during the time the recall issues were addressed.
We are having the same problems with this vehicle as others are having under Ford recall 19S54 the federal safety agency identifier 19V904. Three times after applying the brakes hard the brake system required servicing because the pedal would slowly go to the floor while sitting at a traffic light. Other symptoms would be sluggish or spongy braking. The last service was at a Goodyear where the service tech commented - left front inlet abs valve sticking, activated it three times with scanner before it started to work. He informed us that there was a recall for this problem that may be applicable to out Escape. I called Ford to report it, Case number [XXX]. Will use this Goodyear appt date to answer following questions. INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).
The contact owns a 2013 Ford Escape. The contact stated while driving 40 MPH, the brake pedal was hard while being depressed. The contact placed both feet on the brake pedal and shifted the vehicle into neutral(N) and was able to safely pull to the side of the roadway while the vehicle slowed down. The vehicle was towed to the dealer and the contact was informed that the vacuum pump needed to be replaced. The vehicle was not repaired. The manufacturer was not contacted. The failure mileage was 113,000.
When the car was started in a shopping center parking lot, the emergency brake light and the abs warning light were displayed and remained displayed. When driven, the brakes were "spongy" and then "regenerative braking disabled" appeared in the odometer display. I pulled over briefly, turned the car off for a short period and then restarted it. The same messages and odometer display remained, and brakes were still spongy. As I continued to drive (carefully), the situation resolved itself, though the "regenerative braking disabled" continued for another minute or two. Normal braking then resumed. This issue just occurred so it has not yet been taken to a dealer, nor has it been inspected by mfr, police, etc. THIS PROBLEM HAS BEEN DOCUMENTED MANY TIMES BY OTHERS WITH ALMOST IDENTICAL SYMPTOMS AT THIS WEBSITE https://www.carproblemzoo.com/ford/escapehybrid/2008/service-brakes-problems.php THIS IS CLEARLY A SAFETY ISSUE THAT HAS GONE IGNORED BY FORD FOR SEVERAL YEARS AND DESERVES the federal safety agency's IMMEDIATE ATTENTION.
Abs and master cylinder causing an unsafe braking condition hard brake pedal making it very difficult to stop the car. I replaced the entire brake system including the master cylinder assembly with pedal travel sensor attached. As recommended by Ford dealership. Then I was told that the brake system system had to be bled 2 times. Well after doing this 3 times and replacing the calipers and pads and rotors again. The same situation exists. Now I am told that this car has a different problem and a bulletin was issued by Ford stating that this is a problem with Ford Escape hybrid has to be reprogrammed to allow the master cylinder assembly to link up with the computer to rectify the issue. My car has 42000 miles on the vehicle and I is very dangerous to drive because of the unreliable braking action. Ford does not acknowledge the problem. But there are many people who have had this same issue. What can I do ? Please help me.
All of a sudden soft pedal to floor after ABS event. Replaced master cylinder, caliper, bleed multiple times - no success. Abs module identified as faulty but no code. Brakes are completely gone after service with dealer. Can not buy $1200 part to repair. Seems to be a bunch of these reports piling up in 2008-2009 generation over past 24 months. Ford fusion of same generation has recall for this part. Would drive this with out ABS if I could but the design seems to cause all braking to be lost. Very dangerous! Multi-generation ford owner about to jump ship because no support.
It started early thanksgivings(11/26/2020) drive as I was coming to my 4th/5th stop of the morning, I went to apply the brakes and felt my brake pedal sink with slight to no pressure, no response. I panicked and I remember pumping the brake rapidly to build pressure, but the brake did not respond as expected, I did feel I slight jerk and heard a growling sound coming from the bottom engine area. I must of gone over a pothole that made my truck feel like I jumped the curve, I was going about 35-45mph. After a few rapid brake pedal pumps my vehicle did come to a stop on time before running the light, luckily I was alone in the street that early morning. As of today the brake pedal still feel mushy/spongy lack of pressure and scary unsafe.
Related recalls
Service brakes, hydraulic: foundation components: disc: pads
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2020 Escape vehicles. The rear brake pads may have been manufactured incorrectly, which can reduce brake function in the event of a brake booster malfunction. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 135, "Light Vehicle Brake Systems."
- Risk
- Reduced brake function can require the driver to apply more brake pedal force, and the distance required to stop the vehicle may be extended, increasing the risk of a crash.
- Remedy
- Dealers will replace the front brake pads, free of charge. Owner notification letters were mailed on November 5, 2025. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 21C31. Vehicle Identification Numbers (VINs) involved in this recall became searchable on on October 13, 2025. This recall is an expansion of the federal safety agency recall number 21V922.
Recall number 25V693000 · Recall details
Service brakes, hydraulic: foundation components: disc: caliper
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2021-2022 Bronco Sport and Escape vehicles. The rear brake linings may have been manufactured incorrectly, which can affect braking performance. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 135, "Light Vehicle Brake Systems."
- Risk
- During certain situations, the driver may have to apply more brake pedal force, and the distance required to stop the vehicle may be extended, increasing the risk of a crash.
- Remedy
- Dealers will replace the front brake pads, free of charge. Owner notification letters were mailed August 17, 2022. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 21C31.
Recall number 21V922000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2018 Ford Escape and Lincoln MKC vehicles. These vehicles may be equipped with incorrect front brake hoses that may chafe against other components, possibly resulting in a brake fluid leak.
- Risk
- A brake fluid leak may lengthen the distance needed to stop the vehicle, increasing the risk of a crash.
- Remedy
- Ford will notify owners, and dealers will inspect the brake hoses, replacing any that are incorrect, free of charge. The recall is expected to begin March 2018. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 18S04.
Recall number 18V104000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip: control unit/module
- What is wrong
- Ford is recalling certain model year 2001-2002 escape vehicles manufactured from october 22, 1999, through july 19, 2002, equipped with a brake master cylinder reservoir cap that could leak brake fluid. If brake fluid leaks from the cap, it could come in contact with the antilock brake system (ABS) module wiring harness connector.
- Risk
- Corrosion can develop in the electrical connector leading to melting, smoke or a fire.
- Remedy
- Dealers will replace the brake master cylinder reservoir cap and the ABS electrical system will be modified. An interim letter was mailed on january 20, 2012. Due to a parts delay, however, the remedy may not be available currently. If parts are not available, ford will instruct owners to park their vehicles outside until such time as parts become available. Owners may contact the ford motor company customer relationship center at 1‑866‑436‑7332. This recall campaign is related to 07v‑156.
Recall number 12V005000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip: control unit/module
- What is wrong
- On certain sport utility vehicles equipped with antilock brakes (ABS), the ABS module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.
- Risk
- An electrical short might cause an ABS malfunction that would illuminate the ABS warning light, and in some cases, the module may overheat resulting in burning odor, smoke, and/or fire. This condition could occur either when the vehicle ignition switch is in the off position or while the vehicle is being operated.
- Remedy
- Dealers will inspect the wire harness connector to the ABS module for missing or dislodged wire seals, and repair or replace the harness connector as appropriate. The dealer will also inspect the connector on the ABS module and replace it if it is found to be corroded or damaged. The recall began on april 23, 2007. Owners may contact ford at 1‑800‑392‑3673.
Recall number 07V156000 · Recall details
Questions about the Ford Escape spongy pedal
Which Ford Escape years have soft or spongy brake pedal problems?
The model years with the most reports are 2009 (8 complaints), 2008 (7 complaints) and 2001 (2 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Ford Escape?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history