I replaced the rear brakes on my 1995 ford f250. I put on new duralast brake shoes (part #358) from autozone. Afterwards, the emergency/parking brake failed. I took everything apart and took a while before I found the problem. At the top of the brake shoes there is a half circle where the front and back shoe meets and that is where the emergency/parking brake cam pushes the shoes apart. The oem shoes have a tall shoulder at the very tip top where the cam pushes against the rear shoe, the duralast shoe has a shorter shoulder and allowed the cam to slip over the top of the rear shoe causing the unexpected emergency/parking brake failure.
1995 Ford F-250: brake failure
13 of the 184 complaints about the 1995 Ford F-250 describe brake failure.
- owner complaints
- 13
- of this car's complaints
- 7%
- recalls
- 0
Brake failure by model year
What owners say
Tl* the contact owns a 1995 ford f-250. The contact stated that the parking brake failed. The contact stated that they were able to drive the vehicle with the parking brake engaged. The vehicle was taken through state inspection and did not pass because the parking brake was inoperable. The contact referenced the federal safety agency campaign id number: 02v068000 (parking brake) and was told by the manufacturer that the recall was only for vehicles with manual transmissions. The vehicle was not repaired. The VIN was not available. The failure and the current mileage was 202,000.
Recently when I got in my 1995 f250 w/manual transmission I depressed the clutch pedal to start it up & the pedal went to the floorboard & stayed there. What I found after inspecting the clutch pedal was that the end of the rod that goes into the master clutch cylinder broke (this is connected to the peddle). This rod appears to be plastic on the end & metal going into the master cylinder. My concern is that this seems to be a safety issue. If I was driving this truck and this rod broke while I was trying to stop quickly (or stop at any time) then it would have been very difficult to stop since the clutch wouldn't have engaged. I have photos of this part as evidence if needed.
Rear brake failure/ on 4th set front roters,calapers with 45,000 on truck when jack up with both feet on brake on brakerear brakes only work to stop wheels at very slow applacation at 12,000 master cylinder,buster,absvalve by pa ford deler.20, at courtesy ford pt wash/last two I did,{kang repair}
Ongoing / intermittent problem with brake pedal going to the floor and causing loss of braking. Vehicle been in / out of dealer shop on nine occasions, and problem still reoccurring. Feel free to provide any further details on this matter.
Intermittently while driving and all of a sudden there were no brakes/ steering, and no control. Engine continued to run when this happened. It has happened 3 times within the last four months. Dealer was not able to duplicate problem. Ford was aware of this problem. *ak the vehicle's ignition switch is a major problem that ford company has to recall.
Front brakes failed causing them to smoke and catch fire.
While driving braking sysytem malfunctioned, which could have caused an accident. Pedal went to the floor. Also, both front brake rotors cracked in two places. Dealer replaced front brake rotors and pads.
Brake failure, while driving at speed of 15mph, front caliper overheated and caught on fire.
Due to a broken bolt that holds the front frame in place the consumer is experiencing loss of steering column and loss of brakes.
Front brake failure.
Abs brake system failure, brake pedal goes to the floor in a panic stop. Tt
Service bulletins that may apply
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Rear brake drag or excessive wear on rear brakes
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Service tip information regarding elimination of sanding rotors and drums
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- A comprehensive pull and drift diagnostic procedure has been developed to assist technicians in helping to...
- A vibration or shudder may be felt during braking on some vehicles
- Procedures on caliper-mount lathe machining setup
Related recalls
No recalls on record for this model year.
Questions about the 1995 Ford F-250 brake failure
Is brake failure a common problem on the 1995 Ford F-250?
13 of 184 owner complaints about the 1995 Ford F-250 (7%) mention brake failure. The model year with the most reports is 1999.
Is there a recall or service bulletin for this on the 1995 Ford F-250?
There are 0 recalls and 20 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1995 Ford F-250
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Ford F-250?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history