Consumer stated the factory installed wiring harness which is coming out of the engine compartment fuse box began having electrical problems which was causing the turn signal and brake lights to be inoperative.
1996 Ford F-250 suspension problems
14 complaints (8% of all complaints for this car). 1 crash reported.
- owner complaints
- 14
- of this car's complaints
- 8%
- crashes
- 1
- recalls
- 0
Which part fails
- Front8
- Rear1
- Front: springs: torsion bar1
- Front: springs: coil springs1
At what mileage
Complaints by mileage at the time of the problem.
Ford F-250 suspension problems in other years
Related recalls
No recalls on record for this model year.
Related investigations
Separated front suspension
Consumer complaints report that bolts which retain the axle pivot bracket to the frame cross member can loosen or fail, causing the inboard end or the axle to become detached from the vehicle.owners allege that this could result in loss of steering control, however the complaint data shows only one incident where the vehicle left the roadway following axle separation, with no damage to the vehicle.in addition to the 225 consumer complaints, there were 4,315 warranty claims related to the front suspension and members, and 22 vehicles were replaced for goodwill.documents submitted by ford, under request for confidential treatment indicate that the bolts were inadequate for the durability requirements of the vehicle.also, bolts were found to have been inadequately torqued at one or more assembly plants.other factors, such as wax treatment of the frame, contributed to the problem.increased bolt diameter and increased torque apparently corrected the problem.a service bulletin, 96-20-13, was issued to advise dealers of this corrective action.in these documents, ford also reported that a vehicle, equipped for simultaneous catastrophic failure of all pivot bracket fasteners, was evaluated resulting in a slight vehicle pull to one side with no loss of vehicle control.odi has not replicated ford's vehicle testing, however analysis of the design of the front suspension indicates that even if the inboard end of theaxle became disconnected from the frame, the outboard end would remain firmly attached to the leaf spring with two u-bolts.this would retain the wheel in its approximate position, although the wheel alignment would be greatly in error.therefore it is unlikely that control of the vehicle would be lost.owners reprot many significant noises in the suspension, such as creaking, groaning, clunking, and squeaking, prior to noticing any separation of the axle.this provides warning of the loosening of the bolts to the driver, and should not be ignored.ford has stated that repairs will be covered under the vehicle's bumper warranty.complaints about warranty coverage by a ford dealer should be addressed to ford, or to appropriate state and local agencies.a safety-related defect trend has not been identified at this time and further use of agency resources does not appear to be warranted.the closing of this investigation does not constitute a finding by the federal safety agency that no safety-related defect exists.the agency reserves the right to take further action if warranted by the circumstances.
PE96052
What 1996 Ford F-250 owners say
Most recent owner complaints, unedited.
When driving at about 25 MPH there is heavy vibration within steering. Consumer has to use both hands to keep control of the steering, or steering wheel will fall into consumer's hand without prior warning.
While driving e steering column vibrates, almost causing loss of control. The dealer has been contacted.
Vehicle has had continued problems with suspension/alignment, repairs several times and still experiences problems. Mjs
After both hubs have been replaced, there is still a clicking in the front which occurs during backing that has yet to be corrected.
Barrier has come apart, causing the rear end to drop. Consumer has contacted the dealer . Please provide any further details.
When the tensioner was lost, I lost powersteering, brakes etc. I was negotiating a turn with a trailer attached and lost substantial control of the vehicle. The dealer was aware of the problem but did not know of a recall etc. This problem could be a major safety concern.
Loose front suspension bolts, causing clunking noise in front end when turning.
Alignment cannot corrected. Vehicle has had 6 alignments.
Pe96-052 active, suspension failure, front began unbolting and came loose while driving, in for repair, will provide voucher for the repair.
Questions about the 1996 Ford F-250 suspension
Does the 1996 Ford F-250 have suspension problems?
Owners have filed 14 complaints about the suspension of the 1996 Ford F-250, 8% of all its complaints.
At what mileage do 1996 Ford F-250 suspension problems start?
Not enough complaints include the mileage to tell.
Was there a recall on the 1996 Ford F-250 suspension?
There is no recall for this problem on this model year.
What year does the Ford F-250 have bad suspension?
The Ford F-250 model years with the most suspension complaints are 2012 (125 complaints), 2011 (111 complaints) and 2006 (85 complaints).
Other 1996 Ford F-250 problems
Tires 34Engine 28Transmission 19Steering 17Acceleration 16Brakes 15Fuel system 15Electrical 11Body 5Seat belts 5Seats 4Wheels 3Lights 2Visibility 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Ford F-250?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history