Sudden loss engine shut down without warning collision averted. Ford f-30 2005,a failed ficm. Had already replaced previously 8 month earlier. Part must be defective.
2005 Ford F-350 SD fuel system complaints
Page 2 of 2: complaints 11 to 29 of 29, newest first, as owners wrote them.
Fuel tank lining is peeling off causing failure to injectors/ pump and filters. Causes power loss in traffic which is unsafe. This has happened to me three times since august 2010 in interstate traffic. Ford claims bio-diesel is to blame, bio-diesel makers blame ford. Personally this has cost me $2600 since aug 2010. (replaced filters twice and 5 fuel injectors) truck is not running at this time due to the same problem. Estimated cost to repair $1200 minimum if injectors are okay. This is a problem that ford is well aware of and should be sending notices to affected customers. Owners of these trucks have no way of knowing what percentage of bio-diesel or if any bio-diesel is in the fuel since it is not marked on the pumps. Fords solution is for the owner to buy a new fuel tank that is compatible with 5% bio-diesel.
Tl*the contact owns a 2005 ford f-350 superduty. While driving at approximately 5 MPH the vehicle stalled. The vehicle was towed to an independent mechanic where she was informed the fuel injection control module burned out. The vehicle was repaired. The failure and current mileages were 37,000. Updated 12/21/10*bf updated 12/30/10.
My 2005 ford f350 with the 6.0 litre diesel broke down due to significant leakage in the high pressure oil system. When being repaired, the technician recommended that standpipes and orings be replaced with upgraded parts. This was very costly and could have caused the vehicle to stall and created a dangerous situation.
I have a 2005 ford f-350 with approximately 50,000 miles on it. Over the past 4 months my truck has been not starting after it has been driven and occasionally stalling while being driven. I have had the cam sensor, crank sensor, & fuel sending unit all replaced to no avail. I brought it to the ford dealer and they were unable to "reproduce the not starting", told me to change all filters to ford brand and change the oil. After spending $350 on just filters the truck is still broken, I can not drive it. There is a campaign for this problem #05v270000, unfortunately ford says they can not fix my vehicle because my VIN# was not included. I had a friend look at my truck who has a computer to look up the codes, while the truck is plugged in. He reproduced the not starting while the computer was plugged in and the code came up for the ficm which is what the recall from the federal safety agency is for. I went to the dealer and was told basically to bad. The truck will not start after being driven on a daily basis. Because of the safety concerns with the truck leaving me stranded or even worse stalling while I drive it and causing an accident, I do not drive the truck. Ford should be responsible for fixing these problems.
Engine filters get clogged up and cause the truck to run erratically and stall, caused from debris from a faulty fuel tank.
I am uncomfortable with the dependability and safety of this 2005 ford f350 6.0 diesel truck. The high pressure oil lines, valves, pump, coupler and injector ends where the high pressure oil connect are failing in a large number of these 6.0 diesel engines. Mine has had the valve and coupler replaced in seperate events. Both repairs cost over $1000.00. Ford needs to be forced into designing a fix for these oil systems and recall them them. When any component of this high pressure oil system fail the engine quits running and the driver and occupents are sitting ducks. I wonder how many injuries or deaths have been related to these failures. No one should pay in excess of $40.000.00 for a truck and have to spend thousands ot dollars in repairs just after 100,000 miles and still have to worry about when and where the next failure will happen. I dont know if you can do anything for me but if I can help you in any way to get ford to do the right thing, let me know. Thanks
2005 ford f350 fuel tank lining peeled clogging total fuel system caused truck to breakdown and loose powersteering at high speed. Ford claims there is nothing wrong with gas tank but there has been thousands of the same incident.
I own a 2005 f350 4x4 crew cab power stroke diesel truck. I had the truck in for some warranty work just before it reached over 100.00 miles. I had to have injectors replaced. I later found out that the fuel tank was delaminating. Silver particle and rust is getting into the injecters and clogging filters. I been told that ford is not covering this problem at all. The truck now has 109,000 miles and I no longer have a warranty on the injector. They never told me till after the warranty was up that the fuel tanks where failing. Now from what I can tell everyone is having problems with there fuel tanks. Ford has claimed that it is the caused from bio-fuels but I have never put a drop of bio-fuel in my truck before. I also been told that if you buy a new tank it will have the same problem. My truck will not run all the time and dies on me often. I have been changing filters and now the injectors are acting as if they are damaged. Can you please help? Rick
Vehicle has been difficult to start, running rough and bucks and often stalls while driving. Vehicle was recently taken to ford certified service department for forementioned issue, and was told the fuel tank liner has delaminated and released particles causing damage to the fuel pump, eight injectors, and clogged all filters. Cost of repairs are $5600.00. Service dept. Advised there is no recall for this issue even though this is a common problem with many of these trucks. I have also searched many discussion forums and found there are many people who are having same issues some who have replaced 3 or 4 tanks and other fuel related parts in the same type vehicles.
Tl*the contact owns a 2005 ford f-350 sd. When attempting to start the vehicle, it would not start. While driving at various speeds, the contact noticed white smoke. She took the vehicle to the dealer on numerous occasions, but they could not determine the cause of the failures. The VIN was excluded from the federal safety agency campaign id number 05v270000 (electrical system:wiring); therefore, she would have to replace the fuel injection control module at the cost of $1,133.52. The vehicle was repaired. The failure mileage was 69,000 and current mileage was 119,000.
My vehicle has been to the ford service dept. Serveral times this year for a problem with my acelerator. If I decelerate or stop and go to give it gas again the pedal pushes down but the vehicle will not accelerate.
(1) truck would not start (2) potential of traveling and fuel pump stops providing fuel to motor; potential to loose control of vechicle (3) high pressure (r&r ipr sensor,flex pipe an dconnector) was replaced
Dt*: the contact stated while traveling at various speeds, the vehicle losses power. The vehicle was towed to the dealership and the injector was replaced.
Vehicle had just returned home after being driven a considerable distance. Vehicle shut off for a few minutes when fire started under the hood and moved into cab. Insurance company hired a fire origin and cause analyst and it was determined that fire was caused when fuel leaked from the banjo fitting on the fuel filter onto the hot surface of the engine. The banjo fitting on the lower portion of the fuel filter was covered with a heavy layer of fuel varnish. The bolt in the banjo fitting was checked and found to be extremely loose. This occurred on 6.0l diesel engine. There looks to have been similar problem on gasoline engines which had a recall date of 6/7/05 and the federal safety agency id number of 05v266000. Would like to know if ford has seen problem on diesel engines?
The failure of diesel fuel injectors in the '05 ford f-350 super duty trucks with the power stroke 6.0l diesel engine. Vehicle had approx. 14,800 miles on it at the time of the incident. Did not lead to an accident, I feel that it could in another case. There were no warnings that this was going to happen and occurred suddenly without warning. I was driving into town(about 17 miles). On the interstate highway traveling at approximately 75 MPH. My vehicle lost most of it's power and began to jerk and sputter as I pulled to the side of the road. Shut vehicle off, did a basic check of the vehicles components and then restarted . Started and ran fine. I began to merge into traffic only to loose significant power and was forced to return to the side of the road. I was seriously slowing the oncoming traffic. I began to limp my truck to the nearest exit ramp. Exited the interstate, my truck died and left me stranded, not able to restart. Vehicle towed to the dealership for repair. At the repair shop, the #1 cylinder injector was determined to have failed and was replaced with a new or rebuilt part. (this is not specified by ford.) I did/do not have access to the failed part(s). Approx. 3 weeks after this incident, my truck experienced the same failure (an injector on cylinder #7) with similar results. Ford is well aware of this problem and considers it an "acceptable" design flaw and puts the blame on poor fuel (all other diesel engines will run on fuel station grade fuel, which is only to be expected.). I know that many others have experienced this problem in the 2003 to the 2006 powerstroke 6.0l engines. It is a very common problem. In the case of two injectors failing at once, the vehicle would be inoperable with failed braking, steering and power loss. If one injector fails, the vehicle could have erratic power surges and partial or full loss of power with failed or reduced braking and steering. At highway speed, and with no warning this could spell disaster.
Dt: the contact stated the vehicle stalled intermittently. The first time the vehicle stalled it immediately restarted. The second time the vehicle stalled it was towed to the dealership. During both incidents the vehicle was traveling at 70 MPH. The dealership replaced the fuel system injectors and modules. After the replacements the engine blew out. Additionally, the dealer diagnosed a problem with the transmission at 8,000 miles, and repairs were made. Based on all the problems with this vehicle, it has been at the dealership for three months.
Dt: consumer reports: he bought a 2005 f-350 and he got a recall letter in the mail. He called the dealer to schedule an appt. To get it fixed and they refused to schedule him an appt. They refused to schedule an appt. With him. The recall letter was concerning the fuel jumper line.
Ford lariat f350 diesel dually truck 2005 hfcm drain valve problem. *bf the consumer also discovered thee was no heater cord to keep the engine warm. The dealer informed the consumer the engine block heater was an option. Upon inspecting the vehicle, the consumer there was indeed an engine heater element plug installed in the vehicle, but there was no wiring harness connected to the front of the vehicle in the position indicated in the owners manual. The consumer stated it was an option, but actually standard equipment on the vehicle. The consumer went to another dealer purchased the wiring harness and installed it himself.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2005 Ford F-350 SD?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history