Rearview camera was recalled almost 2 years ago and still no replacement parts available and the rearview camera in my vehicle does have the issue described. Whenever I put my car in reverse 1 of the following happens every time - Blue screen - Black screen - Image upside down - Distorted image with lines through it and upside down - Distorted image with lines through it and rightside up - No image with "Camera unavailable" message
Ford Flex screen failure problems
37 of the 1,955 owner complaints about the Ford Flex describe screen or infotainment failure, most of them for the 2019 model year.
- owner complaints
- 37
- worst model year
- 2019
- typical mileage
- 80,000
Is there a fix? There is 1 recall for this area of the car. See below
By model year
Often reported together
What owners say
The contact owns a 2019 Ford Flex. The contact stated that while in reverse(R), the rear-view camera displayed a blank screen or a distorted image. The contact then received notifications of the federal safety agency Campaign Numbers: 24V951000 (Back Over Prevention) and 25V829000 (Structure); however, the parts to do the recall repairs were unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the repairs. The dealer was notified of the failure several times, and the contact was informed that parts were not yet available. The failure mileage was approximately 45,000.
The contact owns a 2019 Ford Flex. The contact received notifications of the federal safety agency Campaign Numbers: 24V951000 (Back Over Prevention) and 25V829000 (Structure); however, parts for the recall repairs were unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for parts to be available. The contact stated that while driving approximately 45 MPH, the B-pillar trim on the front driver's side door detached from the top of the door, causing the top half of the trim to separate from the rest of the trim. The contact stated that the same trim on the rear driver's side door had slightly detached. The back over prevention camera was inoperable and only displayed a black screen and made a beeping sound while in reverse. The dealer was contacted and failed to confirm when parts would be available. The failure mileage was approximately 80,000.
The contact owns a 2015 Ford Flex. The contact stated that while the vehicle was in reverse, the rear-view camera displayed a blank screen with the message “Camera Unavailable” displayed. The contact received notification of the federal safety agency Campaign Number: 25V695000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was contacted by phone and made aware of the failure. The failure mileage was approximately 15,500.
My backup camera is not working intermittently or will display a grainy image or black and blue lines. Sometimes it will just be a black screen. Other models of my vehicle had the backup camera recalled but my dealer is saying my vin isn’t included in the recall.
Radio making crackling noises, screen goes blank, cannot control a/c from touch screen and causes the a/c not to work on front vents. Vehicle inside died while the engine was still running in traffic and was unable to start/stop vehicle from running, a/c ran hot then vehicle stop running.
The contact owns a 2015 Ford Flex. The contact stated that upon reversing the vehicle the rearview camera display would display upside down and then display blank and no warning lights were illuminated, however the following warning message would display on the instrument panel "camera unavailable, please contact your local dealer". The local dealer was contacted however the vehicle was not repaired as the contact was advised that the remedy for the federal safety agency campaign number :25V695000 (BACK OVER PREVENTION) was not yet available. The manufacturer was not notified of the failure. The failure mileage was 120,000.
My 2019 Ford Flex is experiencing a complete factory rearview backup camera failure. When I place the vehicle into reverse, the center display screen regularly goes completely blank/black or blue or severe image distortion or black with warning "camera is unavailable". This is now happening almost every time I drive the vehicle and started about eight months ago but is now getting more frequent. This failure eliminates my rearward line of sight, creating an immediate back-over crash risk and a severe pedestrian safety hazard. This vehicle is part of the model pool affected by the Ford Safety Recall 24S75 (the federal safety agency Campaign 24V951000) and the expanded 25SB8 camera recall. I am filing this to document the active failure of this safety component on my specific VIN [XXX]. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The contact owns a 2016 Ford Flex. The contact received notification of the federal safety agency Campaign Numbers: 25V695000 (Back Over Prevention) and 25V829000 (Structure); however, parts for the recall repairs were unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that while in reverse, the back over prevention camera failed to display an image of the rear of the vehicle. A black screen was displayed on the screen while in reverse. The dealer was contacted and confirmed that the parts were not yet available. The contact paid out of pocket for the dealer to replace the camera. The manufacturer was not made aware of the failure. The approximate failure mileage was 68,000.
The contact owns a 2019 Ford Flex. The contact received notifications of the federal safety agency Campaign Numbers: 25V695000 (Back Over Prevention) and 25V732000 (Structure); however, the parts for the recall repairs were unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that while in reverse, the back over prevention camera displayed a black screen. The dealer was contacted and confirmed that parts for the recall repairs were not yet available. The dealer confirmed that the manufacturer was currently only providing parts for the Mustang vehicles. The manufacturer was not made aware of the issue. The failure mileage was 111,600.
Related recalls
Electrical system: starter assembly
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2018 Ford Edge, Lincoln MKX, 2019 Ford Flex, and Lincoln MKT vehicles. The power supply cables at the starter and the alternator may not have been properly secured, possibly resulting in an electrical arc.
- Risk
- An electrical arc can increase the risk of a fire.
- Remedy
- Ford will notify owners, and dealers will inspect the alternator and starter motor power supply cables to verify that they are properly secured, correcting them as necessary, free of charge. The recall began September 26, 2018. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 18S25.
Recall number 18V548000 · Recall details
Questions about the Ford Flex screen failure
Which Ford Flex years have screen or infotainment failure problems?
The model years with the most reports are 2019 (16 complaints), 2015 (6 complaints) and 2013 (4 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Ford Flex?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history