The contact owns a 2012 Ford Fusion. The contact stated that while starting the vehicle, the power steering assist fault message was displayed. The power steering function was inoperable. The check engine warning light was illuminated due to a possible canister purge valve failure. Upon investigation, the contact linked the failure to the federal safety agency Campaign Number: 15V340000 (Steering). The local dealer was not contacted, and the vehicle was not diagnosed or repaired. The manufacturer was not contacted. The failure mileage was approximately 165,461.
2012 Ford Fusion engine problems
116 complaints (5% of all complaints for this car). Typical mileage when it fails: 51,700. 1 crash reported.
- owner complaints
- 116
- of this car's complaints
- 5%
- typical mileage
- 51,700
- crashes
- 1
- recalls
- 0
Which part fails
Owners did not name a specific part.
At what mileage
Complaints by mileage at the time of the problem.
0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+
Ford Fusion engine problems in other years
Specific symptoms reported on the 2012 Ford Fusion engine
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Loss of power 232Engine failure 112Stalling 77Check engine light 50Won't start 15Knocking 9Overheating 7
Related recalls
No recalls on record for this model year.
Related investigations
Electronic Throttle Body Malfunction
On February 21, 2013, the Office of Defects Investigations (ODI) opened Preliminary Evaluation PE13-003 to investigate allegations of electronic throttle body (ETB) failures resulting in sudden reduction of engine power in model year (MY) 2009-2013 Ford Escape, Fusion, Mariner and Milan vehicles. During this investigation, Ford identified a condition in subject vehicles equipped with 2.5L and 3.0L engines that may result in a sudden reduction of engine power.According to Ford, the ETB internal motor contacts may develop a high resistance material buildup condition on the commutator, resulting in intermittent electrical connectivity and reduced engine power. When this condition occurs, the Malfunction Indicator Lamp (MIL) or Wrench light will illuminate and the vehicle may enter a limited limp home mode.Ford?s trade name for the feature is Failure Mode Effects Management (FMEM) mode.In this mode, engine power and vehicle speed are reduced, while full function of the power steering, power braking, lighting, and climate control systems are maintained.ODI?s complaint analysis indicate that the predominant failure mode involved reduced motive power associated with the limited limp home mode with engine speeds limited to approximately 900 RPM. Analysis of warranty claims provided by Ford identified 59,807 claims related to ETB replacements and approximately 50 percent of claims are associated with diagnostic trouble codes (DTC) P2111, Throttle Body Stuck Open, and P2112, Throttle Body Stuck Closed.Ford described several factors where the ETB motor may fail resulting in DTCs P2111 or P2112 but the failure is not an existing stuck open or closed ETB valve position.According to Ford, the ETB control strategy provides the driver with three FMEM modes that allow varying degrees of vehicle mobility depending on the severity of the fault detected.DTCs associated with stuck open or closed throttle valves are designated the highest failure severity resulting in engine speeds limited to high idle corresponding to the limited limp home mode.Vehicles are not likely to unexpectedly stall as a result of this condition, but drivers may characterize the reduced functionality as a stall, even though their vehicle may still has motive capability.Other FMEM limp modes may result in reduced engine performance but will maintain vehicle speed above 20mph. During this investigation, Ford and its suppliers, Delphi and Igarashi, updated the powertrain control module (PCM) software to include a throttle body motor cleaning cycle during key-on and modified the ETB internal motor components design, surface finish and material composition to improve durability. Additionally, Ford developed a remedy procedure and issued a special Customer Satisfaction Program (CSP) 13N03 extending the ETB warranty coverage and instructing dealers to update the powertrain calibration to improve vehicle performance in the event that intermittent electrical connectivity of the throttle body motor contacts occurs. The program extends the coverage for up to 10 years of service or 150,000 miles from the warranty start date of the vehicle, all vehicles are eligible for the program through January 31, 2015 regardless of mileage.Owners of the affected vehicles will be contacted by mail to take their vehicle to a Ford dealer who will reprogram the PCM to the latest calibration. The bulletin was sent to dealers on January 17, 2014 and the owner letter mailing began on January 27, 2014. See the investigative file for copies of Ford's bulletin and owner letter. This preliminary evaluation is closed. The closing of this investigation does not constitute a finding that
PE13003
What 2012 Ford Fusion owners say
Most recent owner complaints, unedited.
The contact owns a 2012 Ford Fusion. The contact stated that while driving under 35 MPH, the vehicle was shaking abnormally. The vehicle was shaking abnormally while idling as if the vehicle would shut off. The contact had replaced the battery 8 times; however, the failure persisted. While driving approximately 65 MPH and overtaking other vehicles, the check engine warning light began flashing temporarily. The failure had occurred twice. The vehicle was taken to the dealer who diagnosed the vehicle that the oil was leaking from the valve cover gasket, oil pan, and front seal and needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure. The manufacturer referred the contact to the federal safety agency Hotline to file a complaint. The failure mileage was unknown.
2012 Ford Fusion is having issues similar to the Ford Focus recall, 18S32, that pertains to the canister purge valve and powertrain issue. Current fusion has a 2.5L motor in it. Have replaced the canister purge valve 3 times in a 2-year span and is currenting giving codes (as well as engine light being on) of another failure. Do believe it is affecting the powertrain as well, as it is jerks under workload.
Vehicle loses power while driving, with no response when accelerator is depressed further. The engine continues to run but no throttle response. No engine warning light came on. No codes stored. Must stop, turn off engine and perform an engine restart to continue driving again.
My steering assist system goes of at odd times, and the acceleration it does tiny tugs, and my suspension it rattles, over street bumps,, can it be fixed by a dealership, cause it’s my only vehicle 🚗 I have and plus I’m on ssdi income and I can’t afford major repairs, like these, and if so have the car fully inspected just in case I’m missing something, oh and also there’s a popping noise coming from the front of the car..
Transmission issues. Jerks and shudders and loss of power, broken motor mounts, PCM issues, misfire issues and etc. Car threw codes, many expensive trips to Ford dealerships, excessive undriveable down time, unsafe to be on a highway or go up a hill when it shifts (automatic), 6F35 Transmission in my 2012 Ford Fusion
The contact owns a 2012 Ford Fusion. The contact stated while driving at high speeds the vehicle shut off, restarted, and shut off again. The contact was able to drive, but the vehicle shut off. The power steering assist fault warning light was illuminated. The vehicle was taken to the local dealer but was not diagnosed or repaired. The manufacturer was contacted, and the contact was informed that the warranty had expired. The contact was referred to the federal safety agency Hotline for assistance. The failure mileage was approximately 160,000.
Pulled out of a side street Taylor onto a main highway 39 beach Blvd and car jolted and didn’t have much go. Seemed sluggish. Transmission mount bolt had snapped off and I could have been in a major accident because I had oncoming traffic coming at me when I merged into the street and lost power because of the incident.
Their is a recall for Ford Abs Module yet their needs to be one for 2012 Ford Fusions Se as well I have paid over 3200 dollars for my brakes alone . I have had 2 near misses and was in an unreported incident today from power loss on my breaks . Very unsafe for me and those around
The power steering assist randomly went out and caused me to almost crash into a wall when I was on the freeway taking the car home. The previous owner had gotten into an accident with the vehicle which had also resulted from the power steering randomly going out, and the power steering is now out completely on the vehicle and yet seems to come on randomly while having to manually steer the vehicle. I just got the vehicle and am the most recent owner, but since the vehicle has over 150,000 miles on it and it has been over 10 years, Ford and its dealerships are saying there’s nothing they can do to fix it. However, I know that these issues going on with the car (power steering assist and electronic throttle body issues) are related to the recall on the vehicle. There are apparently no active recalls on the vehicle, but I know that the previous owners may have taken the car in for problems related to the recall. However, I also know that the company is required to fix problems related to the recall no matter how many years the warranty is or how many miles the vehicle has on it, so I’m unsure why both Ford and its dealerships are saying there’s nothing they can do and that I’ll have to pay for a diagnostic fee and then the repair fees associated with the problem, and I just got the vehicle. I don’t feel that it’s fair that I pay for repair costs associated with a recall on several other Ford Fusion vehicles as well (2011-2012) when those recall related problems almost killed me, and upon researching it no other cars have power steering assist, electronic throttle body and airbag problems like the ford fusion.
Questions about the 2012 Ford Fusion engine
Does the 2012 Ford Fusion have engine problems?
Owners have filed 116 complaints about the engine of the 2012 Ford Fusion, 5% of all its complaints.
At what mileage do 2012 Ford Fusion engine problems start?
The typical (median) mileage in owner complaints is 51,700 miles.
Is there a recall for the 2012 Ford Fusion engine?
There is no recall for this problem on this model year.
Other 2012 Ford Fusion problems
Steering 1,476Airbags 404Electrical 165Transmission 158Brakes 113Body 99Driver assistance 90Acceleration 86Fuel system 65Suspension 36Wheels 28Locks 24Lights 21Seats 11Tires 11Visibility 11Seat belts 8
VIN decoder
See the problems and recalls for an exact car
Buying a used 2012 Ford Fusion?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history