The worst 2007 Gillig Low Floor problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 8
Exterior lighting: turn signal: flasher unit
- What is wrong
- Gillig LLC (Gillig) is recalling certain 2001-2018 Gillig Low Floor transit buses. The turn signals may flash slowly, reducing their visibility to other drivers. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
- Risk
- The reduced visibility of the turn signals can increase the risk of a crash.
- Remedy
- Gillig will notify owners, and dealers will update the software that controls the turn flash rate, free of charge. The recall began on August 2, 2018. Owners may contact Gillig customer service at 1‑510‑264‑5073 or 1‑800‑735‑1500.
Recall number 18V418000 · Recall details
Exterior lighting: turn signal
- What is wrong
- Gillig LLC (Gillig) is recalling certain model year 1997-2017 Low Floor transit buses. The front turn signals installed on standard profile (non-BRT) buses may not be sufficiently visible to other drivers or pedestrians. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment."
- Risk
- The reduced visibility of the turn signals may increase the risk of a crash.
- Remedy
- Gillig will notify owners, and dealers will install turn signals that have increased visibility. The recall began June 7, 2019. Owners may contact Gillig customer service at 1‑510‑264‑5073 or 1‑800‑735‑1500.
Recall number 17V119000 · Recall details
Engine and engine cooling: engine
- What is wrong
- Gillig, LLC (Gillig) is recalling certain model year 2007-2014 Lowfloor transit buses manufactured September 26, 2007, through January 24, 2014. In the affected vehicles, the engine oil sampling hose may leak oil due to being routed too closely to hot engine exhaust components.
- Risk
- If the sampling hose leaks oil in the presence of hot engine engine exhaust components, there is an increased risk of fire.
- Remedy
- Gillig will notify owners, and dealers will inspect the oil sampling hose. If the hose is routed too closely, the hose will be removed, replaced and rerouted to provide appropriate clearance of the hot components. The recall is expected to begin in early August 2014. Owners may contact Gillig customer service at 1‑800‑735‑1500.
Recall number 14V358000 · Recall details
Interior lighting
- What is wrong
- Gillig corporation is recalling certain model year 2001 through 2009 transit buses manufactured between january 2001 and september 2009 equipped with luminator horizon LED side destination signs. The connector board can corrode due to an accumulation of moisture under the connector.
- Risk
- A short could occur, possibly causing smoke and fire.
- Remedy
- Gillig will notify owners and luminator will repair the buses free of charge. The safety recall began on spetember 29, 2009. Owners may contact luminator at 1‑972‑516‑3033 or gillig field services at 1‑800‑735‑1500.
Recall number 09V368000 · Recall details
Suspension
- What is wrong
- Gillig is recalling 31 my 2007 29 foot low floor transit buses equipped with saf- holland adl series rear suspensions. In some instances the transverse beam was not properly welded which could result in a failure of the weld.
- Risk
- If the weld fails, vehicle stability while cornering could be affected resulting in loss of vehicle control, possibly resulting in a crash. In addition, the transverse beam could drop to the ground causing sparks that could cause a fire hazard.
- Remedy
- Gillig is working with saf holland to have a visual inspection of the adl transverse beam performed. If a weld defect is identified, saf holland will provide a service replacement kit that contains a new transverse beam, all necessary installation hardware, beam replacement and instructions free of charge (please see 08e031). The recall began on april 29, 2008. Owners may contact gillig at 1‑510‑264‑5031 or saf-holland at 1‑231‑773‑3271.
Recall number 08V175000 · Recall details
Service brakes, air
- What is wrong
- On certain transit buses equipped with graham-white air dryers, the air dryer timer modules may allow sufficient quantities of moisture to enter and affect the operation of the vehicle air brake system.
- Risk
- Failure of the air brake system due to moisture could result in a crash.
- Remedy
- Gillig, in conjunction with graham-white, will replace the air dryer timer module on the affected vehicles. The recall began on january 29, 2008. Owners may contact gillig at 1‑510‑785‑1500 or graham-white at 540‑387‑5620.
Recall number 08V008000 · Recall details
Engine and engine cooling
- What is wrong
- On certain transit buses built with cummins ism c876 engines, the electronic control module fails to recognize inputs of the vehicle electronic control unit or from a driver actuated dash switch thereby increasing the risk of unintended (or unexpected) elevated exhaust temperatures.
- Risk
- While this condition does not involve a risk of fire in the vehicle itself, it could present a fire hazard in a situation where the vehicle's exhaust is in close proximity to materials or substances that can melt, burn, or explode.
- Remedy
- Cummins, in conjunction with gillig, will conduct the remedy campaign. The recall began on july 31, 2007. Owners can contact cummins at 1‑800‑343‑7357 or gillig at 1‑510‑785‑1500.
Recall number 07V265000 · Recall details
Steering: hydraulic power assist: hose, piping, and connections
- What is wrong
- On certain transit buses, the hydraulic hose located in the engine compartment was manufactured incorrectly which could cause a hydraulic fluid leak.
- Risk
- Hydraulic fluid leakage could lead to a loss of fluid which could affect vehicle steering or create the conditions for a potential engine compartment fire.
- Remedy
- Gillig will provide correct hoses to their customers for replacement or will replace the hoses for them. The recall began on june 27, 2007. Owners may contact gillig at 1‑510‑785‑1500.
Recall number 07V259000 · Recall details
Technical service bulletins for the 2007 Gillig Low Floor 15
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Because of a supply issue with the blue hose covering, Eaton is temporarily making FC-300 hose using black...
- A procedure to properly adjust the draglink so the socket won't over articulate, causing increased wear.
- It was found that an earlier Bulletin spec'd bolts that could be too long due to variances in bolt...
- This field service bulletin is informing vehicle owners and aftermarket part purchasers that Neway®, a...
- Gillig has received reports of partial cracking in the steering gear mounting plate in some Low Floor buses
- This field service bulletin provides new information from borg warner (DELCO) revising the maintenance...
- This field service bulletin applies to all non-hybrid low floor buses with 480 volt HVAC systems
- This field service bulletin applies to all low floor buses with skf air dryers
- This field service bulletin applies to all low floor buses
- This field service bulletin applies to all low floor buses with aeroquip FC-300 coolant hoses
Compare the 2007 Gillig Low Floor
Other model years
Questions about the 2007 Gillig Low Floor
Is the 2007 Gillig Low Floor reliable?
Owners have filed 0 complaints about the 2007 Gillig Low Floor.
What is the most common problem with the 2007 Gillig Low Floor?
There are not enough complaints to tell.
How many recalls does the 2007 Gillig Low Floor have?
8 recalls, covering exterior lighting, engine and engine cooling and interior lighting.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 Gillig Low Floor?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history