2022 GMC Savana problems

What is wrong

General Motors, LLC (GM) is recalling certain 2022-2023 Chevrolet Express and GMC Savana vehicles. Incorrect software in the transmission control module (TCM) may result in harsh shifting, reduced power, unintended deceleration, rear wheel lockup, or cause the vehicle to move in an unintended direction.

Risk

Rear wheel lock-up or moving in an unintended direction can increase the risk of a crash.

Remedy

Dealers will update the transmission control module software calibration, free of charge. Owner notification letters were mailed December 9, 2024. Owners may contact GM customer service at 1‑888‑988‑7267, Chevrolet customer service at 1‑800‑222‑1020 or GMC customer service at 1‑800‑462‑8782. GM's number for this recall is N242471620.

Recall number 24V839000 · Recall details

What is wrong

General Motors, LLC (GM) is recalling certain 2003-2023 Chevrolet Express Cutaway and GMC Savana Cutaway incomplete vehicles equipped with wiring for an optional rear heating, ventilation, and air-conditioning (HVAC) system. When the HVAC blower motor circuit is left unused with exposed connectors and wiring, the circuit can corrode and overheat.

Risk

An overheated electrical circuit increases the risk of a fire.

Remedy

Dealers will properly seal the rear HVAC blower motor circuits at the left side B-pillar, free of charge. Owner notification letters were mailed May 2, 2023. Owners may contact Chevrolet customer service at 1‑800‑222‑1020 or GMC customer service at 1‑800‑462‑8782. GMC's number for this recall is N222386050.

Recall number 23V247000 · Recall details

The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) after receiving one Vehicle Owner Questionnaire (VOQ) complaint related to four school buses built on General Motors (GM) van chassis. The VOQ alleged transmission failure resulting in a loss of all forward gear. In ODI's pre-investigative discussions with GM, ODI learned that valve body separator plates had been machined out of tolerance during production periods between October 2016 to April 2017 and February 2021 to April 2021. This out of tolerance machining may create excessive wear to the valve body check balls, possibly resulting in an inability to engage drive or reverse. The potential loss of drivability only begins when shifting from a park or neutral transmission selection and does not occur during a functional drive cycle. The average failure mileage of vehicles which experienced this condition is within warranty and related claims or complaints did not include any accidents, injuries, or fatalities. After discussions with GM, Technical Service Bulletin (TSB) 23-NA-142 (the federal safety agency ID number 10243753) was released in September 2023. This technical service bulletin provides a procedure for technicians to replace the forward check ball and separator plate if found to be the cause of a customer's concern. During the course of the investigation, GM also released a Customer Satisfaction Program (CSP) N232428780 (the federal safety agency ID 10253316) in February 2024, to notify school bus and ambulance fleets of the concern and to proactively mitigate the risk in these essential-operation vehicles. Recently, ODI contacted multiple school bus fleets, verifying that there have not been any stranded buses mid-route from this condition. Additionally, ODI has not received any additional VOQ complaints since the opening of this investigation. Based on the available information, including GM's TSB and CSP, this PE is closed. The closing of this investigation does not constitute a finding by the federal safety agency that a safety-related defect does not exist. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI report cited in the Closing Resume ODI Report Identification Numbers document, go to

PE23016