Exiting off freeway ramp in indianapolis brake pedal went to the floor without notice and no brake fluid loss, nearly crashed crossing 5 lanes of cross traffic just lucky I wasn't broadsided by cross traffic. I received no notice of hazard from gm, no recall and only learned of this problem once researching on web. I am lucky to be alive.
2003 GMC Sierra brakes problems
83 complaints (40% of all complaints for this car). Typical mileage when it fails: 78,244. 6 crashes reported.
- owner complaints
- 83
- of this car's complaints
- 40%
- typical mileage
- 78,244
- crashes
- 6
- recalls
- 2
Which part fails
- Antilock/traction control/electronic limited slip11
- Foundation components: hoses, lines/piping, and fittings4
- Foundation components: disc: rotor3
- Foundation components: disc: pads2
- Fluid1
- Antilock/traction control/electronic limited slip: wheel speed sensor/tone ring1
- Antilock/traction control/electronic limited slip: control unit/module1
At what mileage
Complaints by mileage at the time of the problem.
GMC Sierra brakes problems in other years
Specific symptoms reported on the 2003 GMC Sierra brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Parking brake
- What is wrong
- On certain pickup trucks equipped with manual transmissions and built with either pbr parking brake systems or trw parking brake systems, the parking brake friction linings may wear to an extent where the parking brake can become ineffective in immobilizing a parked vehicle.
- Risk
- If the parking brake does not hold, unintended vehicle movement could occur, which could result in a crash.
- Remedy
- Dealers will install a low-force spring clip retainer for vehicles equipped with a pbr parking brake system. On vehicles equipped with the trw parking brake system, dealers will install a redesigned parking brake cable assembly. The recall began on july 29, 2005. Owners may contact chevrolet at 1‑800‑630‑2438 or gmc at 1‑866‑996‑9463.
Recall number 05V161000 · Recall details
Service brakes, hydraulic
- What is wrong
- Certain sport utility vehicles, pickup trucks, and passenger vans fail to comply with the requirements of federal motor vehicle safety standard no. 135, ?passenger car brake systems.? Some of these vehicles were produced with an out-of-specification brake hydro-boost housing relief valve bore.
- Risk
- Consequently, the valve o-ring seal may fracture. Steering efforts may be slightly increased while braking or parking. Under certain driving conditions, a fractured seal may require a slight increase in the applied brake pedal effort to achieve the same vehicle deceleration rate as prior to the seat fracture.
- Remedy
- Dealers are to replace the hydro-boost relief valve. The recall began on june 18, 2004. Owners should contact cadillac at 1‑866‑982‑2339; chevrolet at 1‑800‑630‑2438; gmc at 1‑866‑996‑9463; or hummer at 1‑866‑486‑6376.
Recall number 04V045000 · Recall details
Related investigations
Brake line corrosion failure
The Office of Defects Investigation (ODI) received Defect Petition DP10-003 on March 2, 2010, requesting the investigation of model year (MY) 2003 Chevrolet Silverado 2500HD 4WD pickup trucks for corrosion failures of the vehicle brake lines.DP10-003 was granted and on March 30, 2010, Preliminary Evaluation PE10-010 was opened on more than six million model year 1999 through 2003 light trucks and sport utility vehicles manufactured and sold by General Motors Corporation (GM).On July 2, 2010, ODI received GM's response to an information request, which included GM's assessment of the frequency and safety consequences of the alleged defect. GM stated that:(1) the brake system of the subject vehicles is split front/rear and should a brake pipe suddenly fail for any reason, the affected vehicle would be capable of stopping with the pressure supplied by the remaining circuit; (2) the subject vehicles were designed to meet the hydraulic circuit partial failure requirements of Federal Motor Vehicle Safety Standards 105 and 135, Light Vehicle Brake Systems; and (3) should a brake fluid leak occur for any reason, the brake system malfunction indicator lamp (MIL) would illuminate and warn the driver before the brake fluid level was low enough to cause a loss of line pressure.ODI's and GM's analysis indicates that 85 percent of the complaints occurred on vehicles used primarily in States that use salt on the roads during Winter months (Connecticut, Delaware, District of Columbia, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia and Wisconsin).Overall the complaint rates per 100,000 vehicles for Salt Belt States is 43.0 and Non-Salt Belt is 3.0.In approximately 25 percent of the complaints the brake pipe failure occurred suddenly, with no warning (i.e., no MIL, Brake Fluid Loss Warning), and resulted in extended stopping distances.In 30 of these the increase in stopping distance that resulted was a factor in the crash and in 10 others the vehicle was intentionally steered off the road or into another lane of travel in order to avoid a crash.This investigation has been upgraded to an Engineering Analysis (EA11-001) for subject vehicles sold or currently registered in Salt Belt States to further assess the scope, frequency and safety risks associated with sudden failures of corroded brake pipes that can result in decreased brake effectiveness. ODI will continue to gather information on subject vehicles outside the Salt Belt as well.
PE10010
Parking brake failure
Odi's review of complaint data received since the close of ea04-011 revealed no indication that the investigation should be re-opened.more details can be found in the federal register notice enclosed in the dp05-009 public file.odi reserves the right to reopen the investigation in the future should conditions warrant.
DP05009
Parking brake failure
In a letter dated april 20, 2005, gm notified the federal safety agency that it had decided that defects that relate to motor vehicle safety exist in certain model year (my) 1999-2002 c/k 1500 series (pbr parking brake system) and my 2001-2005 c/k 2500 and 3500 series (trw parking brake system) pickups with manual transmissions.according to gm, some of these vehicles may have conditions that cause the friction linings to wear to an extent where the parking brake can become ineffective in immobilizing a parked vehicle.gm's action covers an estimated total of 142,585 vehicles.dealers will install a low-force spring clip retainer for vehicles equipped with the pbr parking brake system and install a redesigned parking brake cable assembly on vehicles equipped with the trw parking brake system. A total of 58 non-duplicative complaints were received by odi and gm concerning the approximately 59,000 my 1999-2002 c/k 1500 series pickup trucks with the pbr parking brake system.these included 22 alleged rollaway incidents, resulting in a rate of 38.5 rollaway incidents per 100,000 vehicles.odi is aware of 24 complaints regarding the my 2001-2005 c/k 2500 and 3500 series manual transmission trucks recalled by gm, including 5 alleging rollaway incidents.though the conditions described in gm's letter are also present in the c/k trucks with automatic transmissions, the rollaway rate in those vehicles was similar to those observed in peer vehicles studied by odi in this investigation.this engineering analysis is closed. For additional information, see the attached closing report.
EA04011
Parking brake failure
Odi opened pe03-057 to assess parking brake ineffectiveness in the subject vehicles.these vehicles are equipped with four wheel disc brakes that incorporate a single-shoe drum-in-hat parking brake independent of the service brakes.complaint and warranty data indicate that the parking brake linings tend to wear out early in the life of the vehicle (at an average of 24 months in service), reducing the parking brake system's torque below that needed to immobilize the vehicle.gm has attributed this accelerated wear to foreign material intrusion and a failure of the brake shoe to properly self-center within its brake drum.effective with the start of my 2003 production, a newer reduced force hold-down clip was introduced to facilitate brake shoe disengagement from the drum surface.this part is also available at the service level for the my 1999-2002 vehicles.gm has indicated that the paking brake is intended to operate in conjunction with the transmission to immobilze parked vehicles, and that in many cases, accelerated parking brake lining wear is caused by rough use, vehicle modifications, and driving with the parking engaged. Odi has upgraded the preliminary evaluation to an engineering analysis to gather further information concerning parking brake usage factors and the circumstances surrounding the seventeen reported vehicle crashes.
PE03057
What 2003 GMC Sierra owners say
Most recent owner complaints, unedited.
I was approaching a stop light driving on a 4 lane 55 MPH speed zone. As I was approaching the stop light I starting pressing on the brake pedal. The pedal had no resistance it kept going to the floor. I started pumping the pedal trying to slow my truck down, no use. I pushed pedal all the way to the floor. This slowed a little. But not enough. I down shifted the automatic lever and starting guiding the truck off the road to avoid the stopped vehicles. I missed the vehicles. Luckily I was only 3 miles from home. I managed to limp home by driving very, very slow and using the gear shifter to slow me down. When investigating the cause at home I found the brake line on the right front had rusted through and there was a leak. All the brake lines on this truck are rusted and in bad shape. I called the dealer glenn buick gmc where I purchased the truck new in 2003. I spoke to the service personal "corey" about repairing the rusted lines. He said gmc was not standing behind this "failure" ! I was on my own ! Seems gmc knows of these failures and so do you and you have agreed not to make them stand behind it and you have chosen to allow more accidents to happen ! You = national highway safety what a shame ! Shame on you and gmc ! Had I not been "lucky" this could have been a terrible accident! Any help in resolving this issue would be appreciated! This issue will only get worse ! As I am sure there are other trucks with this potential problem waiting to happen!
Tl* the contact owns a 2003 gmc sierra. While driving at 60 MPH, the brake pedal was depressed but took a longer distance to stop the vehicle. The vehicle was taken to an independent mechanic multiple times who diagnosed that the brake lines needed to be replaced. The vehicle was repaired; however, the failure recurred. The manufacturer was notified of the failure. The failure mileage was 46,000. The VIN was unavailable.
Tl* the contact owns a 2003 gmc sierra. While driving approximately 60 MPH, the brakes were depressed and traveled abruptly to the floor. The vehicle failed to come to a stop until the emergency brake was engaged as the brake pedal was applied. The vehicle was towed to the residence. The contact discovered that the entire brake lines fractured due to corrosion. The vehicle not repaired. The manufacturer was notified of the problem. The approximate failure mileage was 73,000.
While traveling in my 2003 gmc sierra truck at approximately 45 MPH I stepped on the brake pedal to stop at a stop sign and the pedal went 3/4 of the way down to the floor, then the brake light came on and the truck did not stop as quickly as it usually does ( glad I was not going any faster) . Upon checking the truck it was discovered that the front drivers side steel brake line had a hole in it due to corrosion and there was no brake fluid in the master cylinder .
On 11/11/2014, truck suddenly veered to left, crossed middle of road and went halfway into ditch, road did have a small amount of snow[1/2 inch], this happened just as I topped a small hill. On 11/16/2014 again as I topped a hill on a curve the truck suddenly veered to the left, crossed the middle of the road and did go completely in the ditch. On 11/30/2014 as I backed out of the garage, the brake pedal went to the floor and had a horrible noise when I applied the brake. I made an appointment with my mechanic and he found the brake caliper was froze up and sheared off the brakepad and this ruined the brake rotor, this of course caused the loss of brakes on the right rear side, which must have been pulling me off the road. Luckily we suffered no serious injuries and no other vehicles were on the road.
I was traveling in rule area of mich. After dark,a deer jump out in front of me! I hit the brakes,a brief brake surge, then the pedal went to the floor! No brakes! The brake lines under the drivers seat area were rusted through! I stop at a gas station. I found brake fluid all over and a man asked me what had happened,I told him what I found , he and I couldn't believe they were so rusted out ! My truck is in very good shape! Except for the brake lines! It's got a stainless steel exhaust system but they scrimp on one of the most critical systems for safety ! Unbelievable! By the grace of god I didn't hit the deer! But what if it had happened in town or if the deer was a child! Thank god it happened the way it did and no one got hurt!
Tl* the contact owns a 2003 gmc sierra. While driving approximately 25 MPH, the brake lines fractured when the brake pedal was depressed. The contact used the parking brake to stop the vehicle. The vehicle was not diagnosed or repaired. The manufacturer was not notified. The failure mileage was unknown.
Tl* the contact owns a 2003 gmc sierra. While attempting to reverse out of the driveway, the brake pedal depressed to the floor and the brakes failed to engage. The brake system malfunction indicator illuminated on the instrument panel. After stopping the vehicle, the contact noticed that there was a trail of brake fluid leaking from underneath the vehicle. The contact determined that the rear brake lines were excessively corroded and needed to be replaced. The contact repaired the vehicle himself. However, the failure recurred. The dealer and manufacturer were not made aware of failure. The vehicle was not repaired. The failure mileage was 160,000.
As I stated pulling out of my parking space. I pressed down on the brake pedal and it went to the floor. I quickly put it in park. Then checked under the truck to find brake fluid leaking all over. The line had rusted apart.
Questions about the 2003 GMC Sierra brakes
Does the 2003 GMC Sierra have brakes problems?
Owners have filed 83 complaints about the brakes of the 2003 GMC Sierra, 40% of all its complaints, more than any other problem.
At what mileage do 2003 GMC Sierra brakes problems start?
The typical (median) mileage in owner complaints is 78,244 miles.
Was there a recall on the 2003 GMC Sierra brakes?
Yes, 2 recalls: 05V161000, 04V045000. Check your VIN to see if your car still needs the free repair.
What year does the GMC Sierra have bad brakes?
The GMC Sierra model years with the most brakes complaints are 1999 (338 complaints), 2000 (228 complaints) and 2001 (150 complaints).
Other 2003 GMC Sierra problems
Electrical 31Transmission 29Steering 27Acceleration 12Engine 12Fuel system 7Body 6Suspension 6Airbags 5Tires 5Seats 3Seat belts 2Visibility 2Lights 1Wheels 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2003 GMC Sierra?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history