Tl* the contact owns a 1998 gmc yukon. The contact stated that when he attempted to brake at low speeds, the ABS brake module activated and the vehicle would not stop. The contact disconnected the fuse for the ABS braking system to temporarily remedy the failure. As a result, the vehicle no longer had ABS braking ability. The failure occurred numerous times. The manufacturer was notified of the failure and informed the contact that there was a recall addressing the failure, but the vehicle was not included. The vehicle had not been repaired. The failure mileage was 85,000 and the current mileage was 156,000.
1998 GMC Yukon: ABS light or ABS activating
9 of the 80 complaints about the 1998 GMC Yukon describe ABS light or ABS activating.
- owner complaints
- 9
- of this car's complaints
- 11%
- typical mileage
- 140,000
- recalls
- 1
Is there a fix? There is 1 recall and 2 service bulletins for this area of the car. See below
ABS light or ABS activating by model year
What owners say
Tl* the contact owns a 1998 gmc yukon. The contact stated that the vehicle was leaking brake fluid abnormally. The contact inspected the vehicle and discovered that the brake lines were severely rusted. The vehicle was taken to the dealer and the entire brake line system from front to rear was replaced. The failure and current mileage was 88,000. The ABS sensors failed three times. Updated 03/03/11
This vehicle has historically been bad for wear on discs and pads. I had just replaced the discs and pads once again, and was in an accident. I really think the problem was with the ABS system and not the disc or pads.
Dt*: the contact stated while driving 5mph and below, the ABS engaged. As a result, the stopping distance was increased. There is a the federal safety agency recall, # 05v379000, concerning the ABS. The vehicle has the same problems as in the recall; however is not included in the recall because of the VIN. The vehicle was taken to the dealer who recommended cleaning the wheel speed sensor however, the contact declined.
Dt*: the contact stated intermittently, while stopping the brakes would grab. This occurred at various speeds. The contact cleaned the sensors and there is no longer a problem. There is a the federal safety agency recall, # 05v379000, regarding the antilock brakes. The vehicle had the same problems as indicated in the recall; however, it is not included in the recall due to the VIN. Updated 2/20/2007 - rust had built up under the front ABS sensor which caused sensor errors.
Dt: the contact stated about three -four weeks ago the ABS kicked in at low speeds, and he has no stopping power. The dealer told the contact the bearing hubs needed to be replaced. About two weeks ago he noticed a grinding noise coming from the transmission area. The dealer told him the transfer case needed to be removed and likely replaced.
Dt: the contact stated there was a recall for this make and model, but his vehicle was not included in the recall. The ABS activated while applying the brakes at low speeds. There was vibration in the brake pedal, and extended stopping distance when the brakes were applied. The ABS light did not illuminate, indicating a problem with the brakes. The problem became progressively worse over the past year. The service dealer stated that they duplicated the problem, and it was the same problem as indicated on the recall.
I just bought a 1998 yukon and during inspection asked about my brake issues. I was told that there was a recall for the ABS. I looked it up and it is doing exactly what the recall states (gm re-call #05068). During low-speed braking, it has an increased stopping distance, which could result in a crash. The recall is only for 1999-2002 vehicles. I'm wondering why the 1998's weren't included in this re-call as it is apparent that they have the same issue. What should I do about this?
Abs brake problems; 3 0r 4 times a day when applying the brakes, under normal braking situations, regualr road condtions, the pedal goes down to the floor broad and the ABS does not kick in, resulting in extended stopping distance. Vehicle has been to the dealer (6) times for brake problems. Dealer admitted there was a problem with the ABS, but could not rectify. On 5/12/98, driver was involved in a crash due to brake problems.
Service bulletins that may apply
Related recalls
Service brakes, hydraulic: foundation components: disc: rotor
- What is wrong
- Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. One or both front brake rotor/hubs were built with an out-of-specification gray iron that can fail during the life of the vehicle.
- Risk
- If a driver continues to drive with a cracked rotor, the cracks could continue around the wheel mounting bolt circle and ultimately result in a wheel separation.
- Remedy
- Dealers will inspect the rotors for a core date of "287" and, if found, replace the rotor.
Recall number 98V033000 · Recall details
Questions about the 1998 GMC Yukon abs
Is ABS light or ABS activating a common problem on the 1998 GMC Yukon?
9 of 80 owner complaints about the 1998 GMC Yukon (11%) mention ABS light or ABS activating. The model year with the most reports is 1999.
Is there a recall or service bulletin for this on the 1998 GMC Yukon?
There is 1 recall and 2 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1998 GMC Yukon
VIN decoder
See the problems and recalls for an exact car
Buying a used 1998 GMC Yukon?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history