Honda CR-V grinding brakes problems

Filed Sep 25, 2026 · Steering · 20,000 miles · TX

The contact owns a 2022 Honda CR-V. The contact stated that while driving and steering the vehicle, the steering wheel was sticking. Additionally, the vehicle made an abnormal grinding sound while turning the steering wheel. The contact stated that the failure increased while driving 60-80 MPH on the highway and caused a safety risk. The vehicle was taken to the dealer, where it was diagnosed and determined that the steering rack and pinion had failed and needed to be replaced. The vehicle was repaired, and an alignment was performed. The contact associated the failure with an unknown recall. The failure mileage was approximately 20,000.

Filed Sep 3, 2026 · Body, Electrical · CA

The vehicle was purchased Aug 7th and since delivery date the car has been having issues. The primary issue is the infotainment system, the monitor sometimes disconnects from apple CarPlay abruptly. During the use of this feature the navigation system will also disconnect making it unsafe when using navigation. The vehicle has a persistent problem with squeaking and tapping noise coming from the engine Bay Area. When going over and bumps or uneven surfaces the car rattles. The vehicle also has worse mpg than advertised. Currently getting 22.4mpg with ECON active.

Filed Aug 24, 2026 · Transmission · VA

Loud squeal noise when transmission is selected in reverse. Remains squealling as long as transmission is in reverse.

Filed Aug 15, 2026 · Steering · VA

I am writing to report a severe, premature safety defect in the steering system of my 2018 Honda CR-V.While attempting to turn the vehicle,I noticed an audible grinding sound accompanied by a distinct feeling of "stickiness" and resistance in the steering wheel. Despite being a low-mileage vehicle with approximately 54,412 miles,the vehicle's steering has experienced a significant mechanical failure.Two independent, certified mechanics have thoroughly inspected the vehicle and confirmed that the steering column assembly has failed internally and requires a complete replacement.Both mechanics stated that the mileage was too low for this kind of issue.There were no warning lamps or messages prior to the failure, nor have any began occurring.The vehicle was last inspected in April of 2026 by the Honda dealership and passed.The failed steering column causes unpredictable mechanical binding, grinding, and a sticky sensation while turning.This creates a severe safety hazard as the steering wheel catches and requires increased physical effort to steer safely, significantly increasing the imminent risk of a collision or loss of vehicle control.The failure occurred under normal driving conditions without any prior collision or external damage.I have official diagnostic reports from two separate repair facilities confirming this diagnosis.There is currently a very limited existing steering recall for this generation (the federal safety agency Campaign 18V663000),but my VIN is excluded despite exhibiting identical hazardous symptoms.I am requesting that the federal safety agency investigate this widespread steering column/gearbox failure trend in 2018 Honda CR-Vs to force an expanded safety recall before a catastrophic accident occurs.I contacted Honda's official recall department to report this defect.The representative documented the issue but stated there was nothing further they could do.When I asked if the case could be reviewed for a potential recall, I was told there is no formal process.

Filed Aug 5, 2026 · Brakes · 99,565 miles · MN

The contact owns a 2018 Honda CR-V. The contact stated that while driving 30 MPH, the brakes independently activated. In addition, the contact stated that the brake pedal was firm while depressed and the tires squealed. The vehicle was taken to the dealer; however, the failure was not duplicated. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The contact stated that the failure was a known failure with the vehicle. The manufacturer was not made aware of the failure. The failure mileage was approximately 99,565.

Filed Jul 10, 2026 · Steering · TX

I am submitting this complaint regarding a steering system defect on my 2019 Honda CR-V, which currently has fewer than 55,000 miles. Over the past few weeks, I have been experiencing a grinding/creaking noise when turning the steering wheel, particularly during low-speed right turns and when the steering wheel is turned while reversing. The noise also occurs occasionally steering forward and has become progressively louder and more frequent. In addition to the noise, the steering wheel intermittently catches or sticks while driving straight and then making a slight steering correction and also when turning in a fixed position. When this occurs, the steering wheel requires noticeably more force than normal to move, especially to the right. This creates inconsistent steering feel and raises concerns about vehicle control and safety. I had the vehicle inspected by my mechanic, who diagnosed the issue as a defective steering rack worm gear. Based on this diagnosis, the recommended repair is replacement of the complete steering rack assembly. Given the relatively low mileage of this vehicle and the potential safety implications of intermittent steering binding, I believe this represents a defect in the steering system that should be investigated.

Filed Jun 24, 2026 · Engine, Transmission · MI

While our 2013 Honda CR‑V was still drivable, we began experiencing a brief but loud rattle or grinding noise at cold start, especially after the vehicle had been sitting. Several years ago the dealer replaced the Variable Timing Control (VTC) actuator because of this cold‑start rattle. After a period without noise, the cold‑start rattle returned and became frequent, along with concerns about abnormal oil consumption. We reported these symptoms repeatedly during routine service visits. In March 2026, the CR‑V was brought to the Honda dealer for a routine oil change. The vehicle arrived running normally. After the service, the dealer advised that the vehicle would no longer start and was undriveable. Their diagnosis was a failed VTC actuator, a stretched/jumped timing chain, and internal engine damage requiring timing‑system repair, cylinder head/valve work, and possibly pistons and rings due to oil‑consumption‑related wear. The failure occurred without any warning lights or messages immediately prior to the event. The only prior symptom was the recurring cold‑start rattle that had been present for years and was previously addressed once by replacing the VTC actuator. The dealer has confirmed the failure and provided written estimates; the vehicle remains disabled. This pattern—cold‑start rattle, VTC actuator failure, timing‑chain stretch/jump, and internal engine damage—appears consistent with a known defect in the VTC actuator/timing system on this generation of Honda CR‑V. If the timing‑chain failure had occurred at highway speed rather than while the vehicle was at the dealer, it could have caused sudden loss of power and increased the risk of a crash.

Filed Jun 10, 2026 · Steering · OH

I have experienced all of the following: "Sticky" Steering: A momentary feeling that the steering wheel catches or sticks when trying to turn it, often requiring extra force to break it loose, Notchy or Jerky Feel: When breaking through the sticky point, the car may jerk slightly, Abnormal Noises: You may hear clicking, grinding, or rubbing noises coming from the front of the vehicle when turning and Increased Effort: It becomes noticeably harder or stiffer to turn the steering wheel. There are no issues when driving straight but when I turn the wheel, into a curve or exiting or entering a ramp for example the wheel can stick and I have to apply additional force to complete the turn. I have also experienced a notch or jerky when completing wider turns, the steering seems to stick in muliple places while the turn is being made. There is also a clicking or popping sound that occurs at each sticking point. There have been no warning lights and I have tried turning on and off all the various lane assist features thinking that the issue was with the technology. Family members have verified these issues but I just found out about this issue after searching on the internet and checking to see that my vehicle was not included even though many of the searches said 2022 was included. If I can get my dealership to look at this issue or another professional I will make an additional complaint.

Filed May 4, 2026 · MN

Vtc actuator for timing tensioner is faulty. Has a horrible grind on start up. No warning lights, no dash lights. This can cause damage to the engine. Was class action involving same part.

Filed May 3, 2026 · Driver assistance, Transmission · AL

Car has been running fine and maintenance is up to date . Got up one day to leave for work and when I went to accelerate I started hearing a grinding clatter type noise ( only when accelerating at about 3k-5k rpm ) and once the car got up to needed speed it goes away . No engine light codes ( but having intermittent connection issues with obd port but never been damaged or anything) but it does it sometimes consistently and sometimes it will have a few moments under same acceleration condition or higher rpms but its never consistent. When these occur the car feels like power loss in the acceleration and a slight dragging in the drivability but again not always present. Been to exaust shop and they found nothing from.their initial inspection. Its hard to trigger the affects since it happens randomly/intermittently. Very unsave and there are no reasons or explanations to these events