The HECU has been malfunctioning in my car for over a year now. It is an open recall for my make, model and year of car. I took it to Bob Rohrman Indy Hyundai and they diagnosed the failed part. This part affects my ABS. There are currently two warning lights on one for the ECS which is the traction control stabilizer and the ABS light is on. Meaning the use of the breaking system is limited and not working properly. I have asked the corporate Hyundai to uphold the recall warranty but I was advised they would not cover this because my vehicle has a rebuilt title. I drive my vehicle on a daily basis and I’m terrified of my brakes going out. The corrosion from the fluid is what causes the HECU to malfunction and it is so scary to think about. This problem was diagnosed and first reported to my his dealership on 6/23/2022.
2011 Hyundai Genesis: ABS light or ABS activating
14 of the 122 complaints about the 2011 Hyundai Genesis describe ABS light or ABS activating.
- owner complaints
- 14
- of this car's complaints
- 11%
- typical mileage
- 95,000
- recalls
- 1
ABS light or ABS activating by model year
What owners say
My car at 58000 miles whenever I brake on slippery surface where ABS is activated my brake pedal goes nearly down to floor. And continuous for days going down nearly to floor on normal braking before brake pedal comes back up to normal level again. This has happened now every time ABS is activated. Dealer wants nearly $3000. To replace the ABS.
Recall on car back in 2014 for brake failure. Improper fluid used causing ABS assist module to fail resulting in soft break pedal. Purchased vehicle in 2014 used and never told of this issue after purchasing vehicle nor never sent any info. Electrical problems , drive seat wont respond , wind shield wipers randomly turning on . Tail lights not working also on recall. This notification also never sent to use resulting in the vehicle being rear ended last year . Passenger seat head rest deployed and not drivers. Car was fixed and a couple of weeks ago the passenger head reset deployed again hitting my daughter and at the same exploded and came of its frame landing in the back seat. Hyundia dealer wont do anything other than whats on recall now.
My 2011 genesis sedan (4.6l v8) has an increasingly soft, spongy brake pedal past year or so. This occurs while driving in/out of my neighborhood, on busy nj highways, and when parked with engine running. Had rotors, pads, master cylinder and brake fluid replaced recently (~2 months ago; $1200; receipts available). Did not solve the problem. I feel unsafe driving the car and putting me/other drivers at risk. From researching the problem, including recently learning about the recall of 2009-2012 models for brake problems, I am guessing that either the brake booster and/or ABS brake module are failing. I bought the car new and am its only owner. Car has only 73,000 careful miles on it. I'm reluctant to spend any more money. What can I do?
Abs module failed. Brake pedal goes down to floor to stop the vehicle.
My 2011 hyundai genesis is experiencing braking failure. I have almost had accidents due to my car's inability to come to a stop in a reasonable time, especially when following vehicles that come to a sudden stop. The pedal depresses almost to the floor and is very spongy. The problem is intermittent but consistent. I researched the issue and found that there was a recall related to this issue, but for some reason, hyundai excluded my VIN despite it falling within the manufacture period of hyundai cars experiencing the issue. I took the car to the hyundai dealership and they diagnosed a failed ABS system, specifically stating that the internal seals of the hecu (ESC unit) were worn causing poor sealing. This may be related to the corrosive brake fluid that they replaced for their campaign tl6. Under hyundai's recall campaign 114, the hecu system should have been inspected and repaired or replaced in addition to changing the fluid. Hyundai merely replaced the fluid. This has caused a dangerous situation with my braking system that could have been avoided.
I purchased my used pre-certified hyundai genesis 20 11 car in february 2014 and shortly thereafter I found that my brakes which originally were firm would go down to the floor or nearly to the floor within 6 months I did some research on the car and found that in 2013 hyundai corporation issued a recall on the ABS system do 2 corrosive brake fluid that was could potentially corrode the ABS system and 2013 the brake fluid was replaced on my car prior to my purchase. However hyundai did not inspect whether ABS systems had already been damaged by this corrosive brake fluid and merely replaced it my car has an ABS system that has been tested and it fails. The brake pedal on my car nearly touches the floor and it is difficult to stop the car safely. I was driving in the rain recently and just missed hitting a car that stopped suddenly.
The federal safety agency campaign number: 13v‑489 hyundai notice 13-01-006 campaign 114. I have had my brake pedal go almost all the way to the floor 3 times now in the last 2 months. This is extremely dangerous and luckily I have been able to stop in time not to cause an accident. Review of the hyundai forum indicates that my ABS module or hydraulic electronic control unit (hecu) is failing. Brake pedal feel will then go back to normal after I restart the car several times. I have an appointment with dennis hyundai in columbus, oh today and I hope they are willing to replace the ABS module for free as required.
After a brake job, I took the car back to say that the pedal was going to the floor. I was told I had a leak in the master cylinder. Got that repaired. After having the master cylinder repaired, I am now being told I have to replace the hydraulic electronic control unit (ABS, hecu). Did some research, and saw that this was a recall issue for 48,000 genesis between the years of 2008 and 2012. Issue seems to be caused by brake fluid corrosion. My car was not part of the recall. I reported the initial issue at 64,000 miles. Car is now at 80,000. It has been sitting at the dealership because it had an engine replaced covered under warranty.
While the automobile is in motion the brake pedal is mushy to the point that it almost reaches dead bottom before engaging the brakes. This happens both on the highway and on the street no matter the speed. Repair shop states that its the ABS hydraulic module is defective. Hyundai dealer states that it is for the fluid recall. It is not fixing the brakes.
Abs module with adaptive cruise and electric park brakes
Tl* the contact owns a 2011 hyundai genesis. When applying the brakes, the brake pedal traveled to the floorboard without stopping the vehicle. The contact had to pump the brake pedal in order for the vehicle to stop. When the vehicle was stopped with the brake pedal depressed, the pedal would lower unintentionally; however, the vehicle would begin to slowly move forward at the same time. The contact took the vehicle to a certified mechanic who diagnosed that the electronic control system and ABS failed and needed to be replaced. The contact notified the anderson hyundai dealer and was informed that the vehicle was not included in the federal safety agency campaign number: 13v489000 (service brakes, hydraulic). The vehicle was not repaired. The manufacturer was made aware of the failure and reiterated the dealer's diagnosis. The approximate failure mileage was 118,000.
Service bulletins that may apply
- The warranty coverage for the hydraulic electronic control unit (HECU) for certain Genesis (BH) and Equus...
- The warranty coverage for the hydraulic electronic control unit (HECU) for certain 2009-12 Genesis (BH)...
- This bulletin describes the procedure to inspect and identify fluid which may appear around the brake...
- Summary to be provided on a future date.
- Hyundai: on certain vehicles, the brake fluid needs replacing and information procedure has been provided
Related recalls
Service brakes, hydraulic: fluid
- What is wrong
- Hyundai is recalling certain model year 2009-2012 Genesis vehicles manufactured April 30, 2008, through March 28, 2012. The vehicles may contain brake fluid which does not protect against corrosion of the Hydraulic Electronic Control Unit (HECU).
- Risk
- If the module corrodes, reduced brake effectiveness may result, increasing the risk of a crash.
- Remedy
- Hyundai will notify owners and instruct them to bring their vehicle to a dealer for service. Hyundai will inspect the HECU module for proper operation, and will replace the modules as necessary. Hyundai will replace the factory brake fluid in those vehicles that have not previously had the factory brake fluid replaced. These repairs will be done free of charge. The recall began on December 24, 2013. Owners may contact Hyundai at 1‑800‑633‑5151 or by email at [email protected]. Hyundai's recall number is 114.
Recall number 13V489000 · Recall details
Questions about the 2011 Hyundai Genesis abs
Is ABS light or ABS activating a common problem on the 2011 Hyundai Genesis?
14 of 122 owner complaints about the 2011 Hyundai Genesis (11%) mention ABS light or ABS activating. The model year with the most reports is 2009.
Is there a recall or service bulletin for this on the 2011 Hyundai Genesis?
There is 1 recall and 5 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2011 Hyundai Genesis
VIN decoder
See the problems and recalls for an exact car
Buying a used 2011 Hyundai Genesis?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history