2006 Jeep Liberty suspension problems

Filed Sep 12, 2026 · Suspension · OK

The front passenger side lower ball joint corroded, failed, or detached while I was driving, causing the front of the car to basically fall onto the tire/steering to fail. I had to immediately pull over right before entering the highway as it was undriveable. Thankfully I wasn’t going fast bc this could’ve caused a crash or flipped my car. There was a recall for this exact issue for 800,000 Jeeps of the same make, model, and year, but this exact VIN wasn’t included in the recall. No warning lights or symptoms appeared prior to this occurring. I am asking for an expansion of this recall notice to include my VIN as clearly this issue is one in the same.

Filed Jul 21, 2026 · Suspension · 163,911 miles · CO

ball joint recall was issues and done on paper in August 2006 on the Jeep liberty. Both ball joint have failed on this vehicle at different times this year while driving the vehicle and Jeep has declined to take any responsibility in any way. This is a major safety concern as any kind of speed while this occurs would be catastrophic. I suspect that Jeep submitted that the recall was fixed when in fact it was not and documents were falsified.

Filed Apr 13, 2026 · Suspension · 87,803 miles · MA

The contact owns a 2006 Jeep Liberty. The contact stated that while driving at an undisclosed speed, the steering wheel was loose, with a clunking sound coming from the steering wheel. The vehicle was taken for inspection and failed the inspection. The vehicle was diagnosed by a certified mechanic, and the contact was informed that the driver's side ball joint was detaching and needed to be replaced. The vehicle was taken to another certified mechanic to be repaired. Two years later, the steering was loose again. The vehicle was taken for inspection, and it failed the inspection again. The vehicle was not repaired. The contact researched and found information about the federal safety agency Campaign Number: 06V288000 (Suspension); and associated the failure with the recall. The dealer was contacted and confirmed that the VIN was not included in the recall. The manufacturer was not made aware of the issue. The failure mileage was 87,803.

Filed Feb 7, 2026 · Suspension · KY

The front lower ball joints have repeatedly failed under recall. The dealer says I now have to pay to have it repaired properly, under recall

Filed Jan 27, 2026 · Steering, Suspension · IA

Vehicle: 2006 Jeep Liberty VIN: [XXX] Summary: The front lower ball joint on my 2006 Jeep Liberty failed while the vehicle was in normal use. This failure matches the defect described in the federal safety agency Recall 06V288000 (Chrysler F23), which involves corrosion and separation of the front lower ball joints. My VIN does not currently show this recall as open, but the failure occurred exactly as described in the recall documentation. Details: In November 2025, the front end of the vehicle collapsed due to a lower ball joint separation. The joint failed without warning, causing loss of steering control. The vehicle had to be towed home by AAA. The failure is consistent with the recall condition involving water intrusion, corrosion, and separation of the lower ball joint from the steering knuckle. The vehicle still has other open recalls (fuel tank and rear lower control arms), but the front lower ball joint recall does not appear as open in the federal safety agency VIN lookup. I believe the recall may have been incorrectly marked as completed in the past, or the original repair was not performed or not performed correctly. The defect has clearly recurred. Safety Concern: This is a serious safety hazard. The ball joint separation caused sudden loss of steering and could have resulted in a crash. The defect is identical to the condition described in Recall 06V288000. Requested Action: I am requesting that the federal safety agency review this case and require Chrysler/Stellantis to perform the recall repair for the front lower ball joints, as the defect has reoccurred and the recall never expires. I also request verification of whether the recall was ever properly completed on this VIN. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Nov 12, 2025 · Body, Fuel system · 180,000 miles · IA

The contact owns a 2006 Jeep Liberty. The contact stated that while driving approximately 20-25 MPH, the front control arm fractured. The front wheel seized, and the vehicle drove into a driveway. There were no warning lights illuminated. The vehicle was towed to the residence. The local dealer was contacted and suggested an appointment, and that the rear control arm was not covered under warranty. The contact was informed about the federal safety agency Campaign Number: 13V252000 (Fuel System, Gasoline, Structure) and the federal safety agency Campaign Number: 18V278000 (Suspension). The vehicle was not diagnosed or repaired. The manufacturer was contacted and referred the contact to the local dealer for assistance. The approximate failure mileage was 180,000.

Filed Aug 19, 2025 · Suspension · 214,564 miles · OR

The contact owns a 2006 Jeep Liberty. The contact stated that while reversing, the contact noticed an abnormal sound before the vehicle stopped. The contact stated that upon inspecting the vehicle, the front of the vehicle had lowered unintendedly. The contact noticed that the front lower ball joint had detached and separated from the spindle. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The dealer was made aware of the failure. The contact referenced an unknown recall; however, the VIN was not included in the recall. The manufacturer was not made aware of the failure. The failure mileage was approximately 214,564.

Filed Feb 21, 2025 · Suspension · 213,000 miles · OR

The contact owns a 2006 Jeep Liberty. The contact stated while driving on the highway at 55 MPH, there was an abnormal popping sound coming from the front passenger’s side, and the vehicle started to skid. There was no warning light illuminated. The contact pulled over onto the side of the road to park and inspect the vehicle and became aware that the front passenger’s side lower ball joint was fractured. The vehicle was towed to a local independent mechanic where the vehicle was diagnosed, and the contact was informed that the lower ball joint was fractured and needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The approximate failure mileage was 213,000.

Filed Jan 24, 2025 · Suspension · MI

I was driving down the freeway at 70 mph, and suddenly my car (2006 Jeep Liberty) felt as if the rear end was dragging and I began to lose control of my vehicle. The icy Michigan conditions were no help, but thankfully the drivers surrounding me were attentive and moved out of the way until i was able to regain control and pull onto the shoulder. I had my vehicle towed to a shop, where i was informed the rear control arm had fractured and in turn damaged the rear axle. I found out there was a recall for this EXACT problem on my car, a blessing because my family is struggling very badly financially. BUT, Chrysler says my vehicle's VIN is not listed on the recall and it is not their problem. Not only is this extremely dangerous for all drivers of these effected vehicles, but my kids missed school today because I don't have a functioning vehicle. Manufacturers need to be held accountable and publicly announce ALL VEHICLES THAT COULD BE EFFECTED, not whichever number of vehicles pleases public relations.

Filed Feb 26, 2024 · Body, Fuel system · 63,000 miles · PA

The contact owns a 2006 Jeep Liberty. The contact received notification of the federal safety agency Campaign Numbers: 13V252000 (Fuel System, Gasoline, Structure) and 18V278000 (Suspension) however, the parts to do the recall repairs were not yet available. The contact stated while driving at various speeds, there was an abnormal sound coming from underneath the vehicle. The vehicle was taken to the dealer, where it was diagnosed and determined that the abnormal sound was due to a lower control arm failure. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recalls repairs. The manufacturer was made aware of the failure. The failure mileage was approximately 63,000. Parts distribution disconnect.