2007 Jeep Wrangler: ABS light or ABS activating

Filed Sep 22, 2025 · Brakes · CA

ABS MODULE fault Abs Traction control inoperable, no parts available, no fixes available.

Filed Sep 17, 2019 · Brakes · 130,000 miles · FL

Abs unit failed. Yellow dashboard warning light illuminated. Red brake warning light was not illuminated. The brake pedal when pushed traveled to the floor. Front wheel brakes became completely inoperative as verified by jacking up the front wheels and testing. Rear brakes still operated, but minimally. Suspect the ABS unit fails by sticking in a faulty bypass state that disables most of the braking capacity, instead of a fail-safe fault mode.

Filed Sep 22, 2015 · Brakes, Electrical · 90,000 miles · NC

My jeep lost all power and brakes while driving. The ABS and brake lines are charred throughout the entire vehicle from overheating and the main wiring harness was damaged as well. The vehicle is currently and national dodge jacksonville nc awaiting repairs. Mike in the service department says the ABS overheated but no fire but another mechanic I had look at it said there was a small fire.

Filed Jan 17, 2015 · Electrical · 58,601 miles · VA

I started my 2007 jeep wrangler 4x2 (manual shift) and was sitting in the drive way (the vehicle was not in gear) when the jeep turned itself off and restarted. At the time it restarted itself, the horn began blowing non-stop, the front and rear windshield wipers turned on, washer fluid sprayed from the rear wipers, the dash lights turned on, the radio turned on, and the interior lights turned on. I attempted to turn off the vehicle and remove the key from the ignition. The horn kept blowing, both sets of wipers were on, the interior lights remained on, the engine kept running, the dash lights remained lit, and the radio wouldn't shut off. I tried to restart the vehicle and turn it off, but nothing helped. The horn was blowing like a demon. The neighbors raced over to help me. We manually stalled the jeep to stop the engine, but the horn, radio, lights, and wipers remained on. We disconnected the battery terminal - horn kept blowing. (this wiped out the computer codes). Then we disconnected the horn to keep it from blowing non-stop. This is the 4th time this has happened to my jeep. On thanksgiving day 2014 - the vehicle turned itself off and turned itself back on while driving at 45mph. The ABS and compass module has been replaced. Software updates have been completed. The clockspring was replaced. They claim the tipm was replaced in 2007. I called the chrysler customer care and the dealership on all occasions after each incident and they basically told me that if they can't see any codes, then the issue didn't happen. They want to see of video. I need help with my demon jeep - I am totally afraid to drive it and the dealership and chrysler corporation won't help me. That thing will eventually cause a serious accident. These issues began in august 2014 and remains unresolved as of 1/17/2015.

Filed Dec 14, 2013 · Brakes, Driver assistance · IL

Shortly before taking vehicle in for brakes, the ABS/esp/bas and traction lights came on. Repair shop stated this would reset after brakes replacement. It did not. Now the lights are on all the time. I have no ABS,no traction control and vehicle is all over the road in inclement conditions. Also the wipers won't turn off after car is turned off and key is removed. They operate on low or high no intermittent. The fluid works and the rear wipers and fluid works, but the wipers wont turn off unless I remove the fuse. And now the cruise control will not work. I was told the tipm is bad, but looking at reviews online. It seems like this is a safety concern for all these issues and should be cause for recall.

Filed Sep 4, 2008 · Brakes · 4,000 miles · PA

Tl*the contact owns a 2007 jeep wrangler. While driving up a steep hill at approximately 5 MPH, the contact continuously applied pressure to the brake pedal. The pedal would vibrate and the vehicle would not slow down. After several attempts, the contact depressed the brake pedal down to the floor in order to stop the vehicle. No warning lights were illuminated on the instrument panel. The vehicle was taken to an authorized dealer and they stated that the failure was related to a malfunction of the wiring in the ABS. The vehicle was repaired. On a separate occasion, the vehicle was taken to an authorized dealer for an identical failure and they were unable to detect the malfunction. The vehicle has not been repaired. The VIN was unknown. The failure mileage was 4,000 and current mileage was 12,300.

Filed Sep 20, 2007 · Brakes · 1,000 miles · CA

Tl*the contact owns a 2007 jeep wrangler. While driving 35 MPH, the ABS locked up. The dealer did not know how to repair the vehicle under the federal safety agency campaign id number 06v493000 (service brakes, hydraulic:antilock:control unit/module ). She stated that she will locate another dealer and notify the manufacturer. The current mileage was 3,000 and failure mileage was 1,000.

Filed Aug 29, 2007 · Brakes, Electrical · 2,384 miles · NC

Tl*the contact owns a 2007 jeep wrangler. While driving 40 MPH, the vehicle stalled. The vehicle coasted and restarted on its own. The vehicle failed again while pulling into the driveway. The contact took the vehicle to the dealer, but they could not duplicate the failure. On july 10, 2007, the vehicle was repaired under the federal safety agency recall number 07v291000 (electrical system). The vehicle has not stalled since the repair, but continues to hesitate as if it will stall. The vehicle was taken to the dealer twice because the air conditioning system failed. On august 27, 2007, the contact noticed that the ABS and anti-skid lights were illuminated. The vehicle is currently at the dealer for the A/C system. The current mileage was 18,000 and failure mileage was 2,384.