2014 Jeep Wrangler: ABS light or ABS activating

Filed Oct 23, 2026 · Brakes · VA

The ABS module stopped working. This is causing the brakes to skid, and the tires to spin when turning and wet. My daughter has run off the road one time on a slippery road because the tires were spinning too fast. There are three warning lights on dash - ABS, Skid, BRAKE. There is also a OBD II diagnostic code - C2200

Filed Oct 12, 2026 · Brakes · VA

ABS module failure. Common on Jeep Wrangler JK. Could cost $1,500 to repair. Things happen but this is a common occurrence according to forums. Confirmed by reputable licensed mechanic.

Filed Oct 8, 2026 · Brakes · IN

My 2014 Jeep Wrangler Unlimited has an intermittent ABS system failure. The ABS, red BRAKE, and traction-control warning lights illuminate while driving. A diagnostic scan returned active code C2200, indicating an internal anti-lock brake module fault. The original ABS module is Mopar part number P04779788AF. I inspected and cleaned the electrical connector and checked the wheel-speed readings, which appeared normal. The C2200 code returned active after these checks. When this fault occurs, the ABS and traction-control systems may be disabled, potentially reducing braking stability and vehicle control during emergency braking or slippery road conditions. I have also found reports from other Wrangler owners describing similar failures. Replacement modules are expensive and difficult to find. I am requesting that the federal safety agency investigate whether these ABS module failures represent a recurring safety defect.

Filed Sep 10, 2026 · Brakes, Electrical · FL

2014 Jeep JK with 78,000 miles has a code C2200 abs module internal failure. The ABS module needs to be replaced. Part cannot be located as there is a national backorder

Filed Sep 4, 2026 · Brakes, Electrical · VA

2014 Jeep JK with 53,000 miles has a code C2200 abs module internal failure. The ABS module needs to be replaced. Part cannot be located as there is a national backorder. This is a known safety issue with no resolution by Stellantis.

Filed Sep 1, 2026 · Brakes · FL

The ABS control module on my 2014 Jeep Wrangler JK failed approximately four years ago. Since that time, I have been unable to obtain a replacement module through Jeep/Mopar, leaving the vehicle without properly functioning ABS and related electronic stability/traction-control safety systems. I was initially told the replacement part was on backorder and waited for an extended period (August 2022). In January 2026, I contacted my Jeep dealer checking on the status of my quote q96683 from 12/3/25. I was required to prepay $1,342.54 for the replacement module, which I did. It is now September 2026, approximately eight months after I prepaid, and the part still has not been supplied. I have not been given a reliable delivery date and there is no ETA. My concern goes beyond an ordinary parts shortage. This is a failure of a safety-critical braking component, and Jeep owners appear to be experiencing extremely long waits because the manufacturer cannot provide replacement ABS modules. My vehicle has needed this repair for approximately four years. A manufacturer should have a reasonable means of repairing a failed ABS/stability-control system in a vehicle of this age. Owners should not have to operate vehicles indefinitely without these safety functions—or stop using otherwise serviceable vehicles—because the manufacturer cannot supply the necessary component. I am asking the federal safety agency to investigate failures of the ABS control module in 2014 Jeep Wranglers, the availability of replacement modules, and whether the number of failures and inability to obtain replacement parts represent an unreasonable safety risk. I also ask the federal safety agency to determine whether a recall or other manufacturer action is warranted. I have documentation of the dealer order and my approximately $1,342.54 prepayment for the replacement module and can provide it if requested.

Filed Aug 10, 2026 · Brakes · FL

Have had this issue since I believe 2020 or 2021. Either way a long time. This issue concerns the ABS control module failure. The warning lights (Brake, ABS and traction control) are lit showing unavailable / issue. The computer is throwing code C2200. The parts to repair are not available. Online forums show this is a big issue within the Jeep Wrangler community. It has been reported that Internally, Jeep has acknowledged the issue by placing new inventory on an "engineering review" hold after admitting that a massive batch of newly manufactured replacement parts had fatal software flaws.

Filed Aug 1, 2026 · Brakes · FL

The ABS module has failed and is apparently impossible to locate. I have been working with a mechanic for 8 months now, and both the dealership and MOPAR cannot provide a date for either a replacement solution or parts availability. This seems to be a widespread issue for the Wranglers from this period. Stellantis should at least provide an alternative. Thanks,

Filed Jul 28, 2026 · Brakes · 167,935 miles · LA

ABS module failure back order with no date of possible delivery

Filed Jun 28, 2026 · Brakes, Driver assistance · SC

XXX lights on dash for abs, brakes, traction came on upon commuting home from [XXX] to [XXX]. I went to Honda Fredericksburg and diagnosis was C2200 failed and the part was on back order. Returned to SC and followed up with Jeep and local automotive services and part back order but able to drive without replacement and still awaiting product. XXX engine light on in addition to the continual abs, brake, traction lights as well as vehicle going into limp mode. Took it immediately to local automotive services shop and received ABS control Module failure is now sending error to other sensors to put Jeep in limp mode and inoperable. OEM Part still on back order and unable to obtain from Jeep. I contacted Mt. Pleasant Jeep dealership service department as well and unable to get the part. No part available and unknown timeframe which leaves me to garage the Jeep while waiting for a new part to become available. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Jun 26, 2026 · Brakes · 93,000 miles · MI

The contact owns a 2014 Jeep Wrangler. The contact stated that while starting the vehicle, several unknown warning lights were illuminated. The traction control, cruise control, and ABS features were inoperable. The vehicle was taken to an independent mechanic, and DTC: C2200 was retrieved. It was determined that the ABS module needed to be replaced; however, the part was on backorder. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 93,000.

Filed Jun 13, 2026 · Brakes · AL

• ABS Control Module. • Intermittent braking & locked calipers while driving in normal conditions. Vehicle would became unstable at highway speeds at times. Sometimes resolves. Ruined calipers & almost started a fire due to friction heat from failed system. • Yes • No • Yes & No. The warnings & uncontrolled braking happens almost simultaneously & at times Intermittently. Warning lights are now on continuous. Unable to drive vehicle due to the dangers of uncontrollable braking by the module.