My vehicle has experienced a complete failure of the ABS Control Module. A dealer diagnosis confirmed internal module failure. The symptoms are: - All ABS system warning lights illuminated (ABS, traction control, brake, sway bar) - Odometer and speedometer stop working while driving - All brake lights remain on continuously - Vehicle exhibits erratic shifting / rough braking This is a documented safety defect affecting many Chrysler/Dodge/Jeep owners where the dealer confirms the ABS module is defective but cannot repair due to the part being on national backorder with no ETA. I am being told the part is backordered indefinitely. I am left driving an unsafe vehicle with no functioning ABS, stability control, or accurate speed/odometer reading, or parking a vehicle I am still paying for and insuring. I am formally requesting: 1. Immediate provision of a replacement ABS module, or a loaner/rental vehicle at FCA's expense until repair
2010 Jeep Wrangler acceleration problems
16 complaints (2% of all complaints for this car). Typical mileage when it fails: 30,000.
- owner complaints
- 16
- of this car's complaints
- 2%
- typical mileage
- 30,000
- crashes
- 0
- recalls
- 0
Which part fails
Owners did not name a specific part.
At what mileage
Complaints by mileage at the time of the problem.
Jeep Wrangler acceleration problems in other years
Related recalls
No recalls on record for this model year.
What 2010 Jeep Wrangler owners say
Most recent owner complaints, unedited.
Most of the dash lights are on scan code U1412. Says traction control not working, ABS not working, speedometer not working, and airbags not working. The Power Control Module (PCM) needs replaced. A known issue with the Jeep Wrangler JKs. No one stocks the parts and used ones are way over priced. How can Jeep not have to replace it or at least stock a replacement part that has the issues resolved?
ABS failing. Loss of Traction Control & Possible Brake Failure. Vehicle Manufacturer failing to provide parts.
I will be driving down the road and a red lighting bolt will flash on my gauges then the jeep will either lose power or shut off. I was almost hit by a semi truck due to this. Once I cycle the key goes away till the next time it happens. Also the brake assist will randomly kick on typically applying braking power to the left rear passenger tire. This is not fixed by cycling the key. Jeep has recalled newer Wranglers for these exact issues but when I contacted Jeep they said it would cost me out of pocket
Tl* the contact owns a 2010 jeep wrangler. While driving 15 MPH with the accelerator pedal depressed, the vehicle vibrated abnormally. The contact stated she switched the vehicle into various gears and slowed the vehicle down however, the failure persisted. The vehicle was not taken to be diagnosed. A dealer was not contacted. The manufacturer was not notified of the failure. The failure mileage was 111,000.
Issue overview: 2010 jeep wrangler has a documented safety issue and the dealership did not agree that there was an issue nor fix the issue, while it was under warranty. I have four pages of specific notes and service dates, etc. As well as the internal official service bulletin that outlines that jeep knew that the safety concern I was raising was a known issue. I can email or fax this documentation as soon as possible, as this text box will not allow me to include all of the information specifics and supporting documentation.
While driving, the horn stopped working along with the speed control and wipers and directional signals . The airbag light is illuminated. My jeep wrangler has just over 30,000 miles on the odometer.
Cruise control stopped working a few months ago. Today I started getting the airbag warning light flashing on and off. Looks like I'll be dropping $500+ for a new clock spring. How is this not already listed as a recall?
Initially, after moderate acceleration from a stop to 35 MPH, engine elicits a new loud rattling sound. This sound directly corresponds to engine RPM dramatically increasing with RPM over 2000. When decelerating from a higher RPM, the sound increases until moderate acceleration is again applied. The sound emanates from the upper right engine area at all times during engine operation. This sound first occurred within one week of a dealer oil change and continues unchanged after 1400 miles. There is no noticeable change in vehicle performance. Gas mileage efficiency has decreased by one to two miles per gallon.
2010 jeep wrangler air bag light came on also horn and cruise control is not functioning because of a bad clock spring. I have been reading online where this is a common problem with this vehicle.
Questions about the 2010 Jeep Wrangler acceleration
Does the 2010 Jeep Wrangler have acceleration problems?
Owners have filed 16 complaints about the acceleration of the 2010 Jeep Wrangler, 2% of all its complaints.
At what mileage do 2010 Jeep Wrangler acceleration problems start?
The typical (median) mileage in owner complaints is 30,000 miles.
Was there a recall on the 2010 Jeep Wrangler acceleration?
There is no recall for this problem on this model year.
What year does the Jeep Wrangler have the most acceleration problems?
The Jeep Wrangler model years with the most acceleration complaints are 2024 (74 complaints), 2021 (48 complaints) and 2016 (36 complaints).
Other 2010 Jeep Wrangler problems
Fuel system 228Airbags 158Electrical 86Transmission 68Steering 66Engine 53Suspension 42Brakes 41Lights 25Wheels 17Body 15Visibility 13Driver assistance 11Tires 8Locks 3Seat belts 3Seats 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2010 Jeep Wrangler?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history