Jeep wanted to do an OTA update through the connect service. I continued to select 'update later' for several days then it all of a sudden my uconnect service told me it was updating. Immediately after it was updated, while on the road, the screened flashed off then back on just like it does at start up wanting me to start the vehicle. At this point we were at a stoplight and wasn't actively moving at this time. It was already running, and when the button was pressed, it turned, off, then pressed again and turned back on and restarted with on with CEL. I was only a mile from my local dealership, so I proceeded to go there.
2024 Jeep Wrangler fuel system complaints
Page 6 of 8: complaints 131 to 160 of 197, newest first, as owners wrote them.
UConnect update was pushed and car shut off while driving saying to put in park and turn back on. Vehicles engine literally shut off twice while driving all due to a system update.
I was driving from New York to DC when my car “bricked” on [XXX] my car advised me to go into park mode and began slowing down to a stop (I had no control over it) and luckily I was able pull over onto the shoulder to where I felt very unsafe and waited to restart my car. I was able to restart and try again and it bricked again about 10 minutes later. I was terrified and had a panic attack before being able to safely merge across lanes into a rest stop. I figured that if I switched into gas mode because it appeared to be an electrical problem that I might be able to continue my drive I started driving and not five minutes later I was stalled on a bridge. It was the scariest experience I’ve had probably ever in my life I had to completely shut down my car and restart it just to inch my way onto a shoulder after getting across a bridge with other cars going over 60 70 mph. Eventually I was able to disconnect the battery and reconnect it just in order to make it safely to a dealership with my father, following behind me. Because the check engine light went off when the battery was reconnected, when I got there, the dealership told me the diagnostic test showed no concerns and said that I could take the car and continue my drive. then 15 minutes after continuing my drive it stalled again, again on the highway! So I made my way back to the dealership and in the 10 miles that it took to get to the dealership the car stalled over five more times every single time it stalled I risked someone running into the back end of my car. I was told to contact Chrysler for a customer care case and they were not helpful at all. I was given a loaner that I couldn’t take out of state so I couldn’t get back to New York in a timely fashion so I had to wait in DC an extra day just to get my car back. I still don’t feel safe in the vehicle because a little software glitched caused such a major issue. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Driving down the road, Jeep suddenly says shift to park and loses all power stalling in the middle the road. This happened twice on October 14, 2025 and needed a tow truck to be brought to a dealership. When it loses power everything locks up including steering so you can even pull over safely to the side of the road. This is a very serious issue that can easily cause a deadly accident and needs to be addressed.
The 4xe system had a software update that ran and caused sudden lost of power. Vehicle has been at the dealership since September 15th and should be available for inspection. Upon completion of the update, the vehicle turned off and came to a quick stop. The vehicle did restart and while driving it, it died again. Second time it turned off, I was not able to move it from the traffic lane. Driving east in the morning facing the rising sun on a 55 MPH road. Yes, it was duplicated at the dealership after they thought it was repaired. Vehicle has been inspected by a Mopar Representative. No indication of complete loss of vehicle power and this occurred on September 15th.
Saturday morning, approx 10:00 am vehicle screen showed it was updated U-Conn (not sure exactly) when update finished vehicle lost power while driving (*Note 4xe Hybrid electric Jeep in hybrid mode). Every light on instrument cluster lit up. I was able to coast to the side of the road and park. The display said to place vehicle in park and hit start. I was able to restart the vehicle. The vehicle would drive for 3-5 minutes and then completely lose electrical power again. This is VERY SCARY to happen while driving, losing power steering, power brakes and being a sitting duck in traffic! When we looked on line, it appears this is an issue with 4xe electric jeeps and many, many people have had the same issue. We were very lucky to have not had a major collision. Jeep needs to be accountable for this safety issue, how many people were not as lucky to avoid a collision. Completely unacceptable.
Vehicle loss of total Power while driving, and printed to stop right away. Incident recurring after starting the car once more as per the j instructions
Updated the center screen and minutes later, my Wrangler popped and the frontal collision, CEL, Stability Trak lights came on And the truck came to a halt in traffic on a busy street. I shockingly was not hit, and got the truck to the side of the road. And I was able to army crawl the truck to the dealership. The vehicle was grinding gears and the 4xe system was completely inoperable. This was extremely dangerous.
Complete loss of power and power steering. Repeated every 1.5 minutes after restart.
My car stalled 16 times on [XXX] due to unknown issues. The first time happened on [XXX] . Then multiple times driving from the first location to my residence in East Quogue and then to the dealer. The car would be in drive and suddenly stall, saying there was an issue with the hybrid motor. It also had multiple engine errors pop up. The car is only 15 months old. The idea that it would stall on a highway is very dangerous. I had to pull over, put the car in park, and sometimes it would power on. Otherwise it would take two to three attempts to start the car to continue driving. It was an extremely hazardous situation. It looks to be a software update error on behalf of Stellantis. This is really scary and unacceptable. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Vehicle shut down in the middle of driving. Went into limp mode. Then would only run in gas mode at half power.
The jeep lost power after only driving abojt a mile down the road. all the lights came on the dash and I had to pull over until it came to a slow stop, the brakes didn’t seem like they working. Once in park I got a dash light that said Service Charging System. I was not able to move it out of park to even neutral. After about 15 minutes I was able to get it to start and drove it home about 1 mile- it did the same thing. When it restarted the check engine light is on.
While driving the vehicle shut down unexpectedly. This occurred in the first minutes of driving after a software update the night before. I restarted the vehicle and vehicle and it shut down 4 more times in 1 mile of driving.
When driving at full speed vehicle shuts off and says to put into park. You cannot accelerate. Warning lights come on saying Antilock system failure, Hybrid system issues along with many other lights. You can be going 70 and it just turns off. We were driving from Sandusky Ohio home to Indiana and this happened. Our safety was put at risk fue to being on highways and out of nowhere our vehicle would lose acceleration and you would have to pull over and restart the car.
10 minutes after a software update. My vehicle lost propulsion and would engage a gear unless the vehicle was shut off/on and would repeat the loss after less than a half mile. Vehicle was towed to dealer.
Vehicle lost power transfer while in Drive and dash instructed to press brake to shift into Park. Check Engine light came on. Dash said something about fuel transfer issue. Happened 5 times in .25 mile. Had to turn car off and restart to drive and it happened again. This all happened after a UConnect update
Pulled vehicle out of the garage. Stopped with foot on the brake. Let off the brake to drive and the check engine light came on along with a red light on the gauge cluster with a red wrench. Warning came on the screen saying put vehicle in park and press the start stop button. Vehicle turned back on and the screen said no hybrid power available. Drove down my driveway and complete loss of power. Screen again said put vehicle back in park and press start stop button. Again the vehicle started and I returned to my driveway and parked the vehicle. Check engine light remained on when vehicle was on.
Jeep pushed an OTA Software Upgrade on 10/10/2025. The following morning 10/11/2025, while operating the vehicle. The vehicle lost all propulsion and power steering. Check Engine Light Came on and a message “Shift to P to Start” message appeared on the console. Additionally, the traction control system, collision avoidance alarms appeared on the console. Fortunately I was able to navigate the vehicle to the shoulder of the road without getting hit. However, I fear had my newly permitted teenage driver been operating the vehicle the outcome would have been much worse.
Updated my jeep (per the prompt) on 10/11. Subsequently Lost power steering and power while driving. Had to turn off the car and restart it. Not safe to drive and unpredictable.
I was driving down and my vehicle lost power. I was able to steer and brake but the gas wouldn’t work. I was able to pull off and restart the vehicle and it did it again with a short amount of time.
Was driving on highway at speed of 60mph then the vehicle loss motive and drifted with no power. Check engine light came on and was able to move to the shoulder. I was able to restart the vehicle but would move for a min then loose power again. Didn't matter whether on electric, hybrid,or gas.
My car did an automatic UConnect update. I went to dinner, got back in my car an hour later and about 2minutes later while driving, my engine shut off and and the Press Break and Push Start came on. I had no power at all while making a turn through an intersection. I pulled over as much as I could, powered off the vehicle completely. Waited a minute and it started back up, but now the engine light was on. Was able to make it home (7miles) but was vey concerned about it shutting off again, at night while driving home. Dealer can’t get my vehicle in for a week!
Following a software update on 10/10/25, our vehicle can no longer be driven safely. Repeatedly loses power, power steering, etc. This issue is impacting thousands of Jeep owners nationwide. Please investigate and help resolve before people lose lives.
While driving, Jeep stalled out/became unresponsive, D started flashing on gear shift panel and dashboard, check engine light came on and dashboard message said: "shift to P to start" "Press brake & Push button to start" While jeep was already ON and was driving. Very dangerous!! This happened 4x in 1 mile radius. Had to put in P, shut off and restart but kept happening. Luckily was able to maneuver/glide jeep to parking lot but this sudden loss of power is extremely dangerous. I could’ve been rear-ended or worse each time it happened. Per Jeep forums this occurred after a Uconnect update. Several Jeep Owners are having the same issue with no word from Jeep. This update was done on a Friday evening (10/10/25) of holiday weekend. No one is available in service department until Tuesday (10/14/25). According to JeepCares Forum… it was a telematics box module update.
Car lost power as I was driving with an errors and just stopped working. As I was trying to get home this happened twice. I had to pull over and follow the prompts on screen. Seems like there was a bad update that has cause all 2024 Wrangler 4xe’s to do this. This is a huge problem really dangerous and inconvenient. This jeep is my only vehicle. I need a vehicle to drive. I called the dealership and they have no idea how to help me or fix this issue.
Immediately after installing a system update, car shut off/stalled while driving. Attempts to restart and continue driving only resulted in minimal forward progress. Very scary and very dangerous situation to have car just stop functioning while driving.
After traveling a short distance, the vehicle will shut down, lose all power and require you to restart. At which time the process repeats, short distance of travel with sudden loss off all vehicle functions. There is some indication that this is due to a software issue pushed in an ota update.
After an over the air update, when driving the vehicle all of the sudden thought the car was parked and lost all power. After coming to an immediate uncontrolled stop, I was able to shift into park and then drive again however due to the issue and many others reporting I am not comfortable driving above 25 MPH.
Immediately after downloading the Uconnect 10/10/25 update, as requested by my Jeep, the car immediately lost all power, shutting completely off in 6pm traffic. This problem on 10/11/25 has been posted all over social media. Took the jeep to the dealership for service and they said they have no information from Stellantis about this occurring. No warnings prior to downloading update. We could have been killed.
Performed uconnext update last night and this morning car completely lost power on the highway. Power steering also did not work and unable to provide gas to car to accelerate. Dead stopped on highway. Dealership then tells me it is “safe to drive but will continue stalling out”
VIN decoder
See the problems and recalls for an exact car
Buying a used 2024 Jeep Wrangler?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history