Check engine light activated then intermittent loss of power while in motion or while stopped. Forced to restart engine. Happened after over the air update of Telemetrics box module update.
2024 Jeep Wrangler fuel system complaints
Page 7 of 8: complaints 161 to 190 of 197, newest first, as owners wrote them.
After doing the unconnect update on Oct 10, while the vehicle was driving it bricked (stopped moving, everything went off). Causing a near accident with our entire family in the car - young children involved! We pulled over and turned it off then back on again and we're in limp mode for a while when it bricked AGAIN this time in the middle of an intersection. This is a BRAND NEW Jeep and has barely been driven. Absolutely horrific!
I installed an update last night and today the vehicle just shuts off on it own. Looks like jeep stellantis pushed an updated that they clearly did no testing on. P1e1d-00 is the code when I scan. I can no longer drive my jeep.
After accepting a prompted Uconnect over-the-air (OTA) software update, my 2024 Jeep Wrangler 4xe began experiencing complete loss of motive power while driving. The vehicle suddenly lost acceleration capability and had to be restarted multiple times. I took the vehicle to McPeek’s Chrysler Dodge Jeep Ram in Anaheim, CA, where technicians confirmed that multiple Wrangler 4xe vehicles had arrived the same day with the same failure following the same Uconnect update. The dealership performed a rollback to the previous software version, but the issue was not resolved. During the post-rollback road test, the technician confirmed that engine and propulsion issues persisted, and my service advisor advised that the vehicle was unsafe to drive. As a result, the Jeep was not released back to me and remains at the dealership pending further direction from Stellantis engineering. Diagnostic codes reported by other affected owners and visible in forums include U0293-00 (Lost communication with hybrid control module), U0010-00 (CAN bus communication failure), and P1E1D-00 (Hybrid control processor fault), which appear consistent with a communication breakdown between the Uconnect and hybrid powertrain systems. Jeep Customer Care has opened case #[XXX] for this incident and is coordinating with the dealer. This appears to be a safety-related defect, as the vehicle can unexpectedly lose power while in motion. Dealer: McPeek’s Chrysler Dodge Jeep Ram 1221 S Auto Center Dr, Anaheim, CA 92806 (714) 635-2340
My car will abruptly lose all power will driving down the road and the dash directs you to put it in park and restart the vehicle. This requires coming to a complete stop in the middle of the roadway. This happened 10x in a 30 mile drive and at times at highway speeds. Forcing me to either stop in the middle of the freeway or hope i can get to the side of the road to pull off. This is extremely dangerous and from my early research this is happening to all 4xe wranglers after a failed update last night. Jeep is advising people to drive the car in gas mode (which it does not have) but all 3 hybrid modes have the same result. Someone is going to be seriously injured or killed because of this issue. Nobody should be driving these vehicles like this and i dont know what my 18 year old daughter would have done if she was driving on the highway. This emergency needs immediate attention not the response from Jeep that they will “look into it monday”
After an Update, the Jeep died completely in the middle of the road with a bunch of errors on the dash and would not restart. After about 10 minutes, it restarted but died again shortly after. A third try a while later and it ran in manual transmission mode to where we could get it home. Check engine light is on and vehicle is still acting odd.
Performed software update yesterday evening while driving. Stopped to get gas and software update completed. Stopped to get food and when I got back into my car, check engine light came on and car abruptly emergency braked and powered off while in drive. Had to change drive mode to e save to make it home. Attempted to drive again and car lost power and came to a halt every other minute. Had to turn car off, turn back on wherever it halted. In the middle of traffic. Almost caused an accident several times. I have video.
On 10/10/2025 there was an OTA update to the telematics/Uconnect system in my car. After it finished the car shut off while I was driving it multiple times. I lost all power and had to coast to the side of the road. This is extremely unsafe. Everyone that did the update is having this issue.
After automatic update, the vehicle lost propulsion and stopped at the middle of the road. All lights came on. Lost power steering as well. Restarting the car clears the lights except check engine light. It happened 2 more times on my way home.
After a software update the Jeep has issues with power, it powers off completely and I have to pull over and put it in park, then restart it only to be able to drive .5 mile before it shuts down again.
Sudden loss of power every 2-5 minutes after the latest over the air software update.
There was an OTA update pushed to my Jeep last night. Since I had just bought the Jeep 6 days ago I thought it was needing to catch up on updates so I let it update. Now when I attempt to drive it the Jeep will randomly SHUT OFF while driving at any speed and prompt me to shift to Park and a check engine light comes on. When I coast to a stop and shift to park and push the button to start it again it comes back on with a CEL. It will continue to do this until I just park it and don’t drive it.
Moments after installing a software update as instructed in my dashboard, my vehicle came to an immediate halt while driving on a busy freeway. The dashboard displayed instructions to shift the vehicle in park and restart the vehicle. I managed to move the vehicle onto the shoulder and completed these steps to regain control of the vehicle. I completed the rest of my commute on local roads, and this incident occurred two more times before I arrived home. This is not an isolated incident. Many users have reported similar incidents and accidents associated with the recent software update. I contacted Jeep to document this concern. However, they took no responsibility and offered no guidance to rectify the issue. This vehicle is only one year old and is now unsafe to drive.
Over the air update on 10/10/25, disabled my Wrangler. Engine light is on, vehicle shuts down, turns off while driving, continuous error messages, unable to operate vehicle safely, it will not stay running while driving. Within 20 miles, it shut down six times while driving on the highway. As of this date and time, Jeep, Mopar, Stellantis have not offered any guidance, assistance or potential fixes.
After a over the air update, the vehicle will unpredictability lose power. The dash will display a warning stating that the vehicle must be shifted into park to be restarted. Jeep has acknowledged this issue in forums with no resolution identified. I have only experienced it while trying to accelerate in front of traffic, on of which almost resulted in an accident due to failure to accelerate.
Software update sent to vehicle 10/10/2025. Allowed update as I was parked for afternoon. In the evening I attempted to drive for dinner. Vehicle suddenly lost propulsion, all warning lights came on, vehicle went to neutral, lost power steering, coasted to sudden stop and message stated shift to park and press start. Which I did. Same thing happened again in just a few feet in the middle of an intersection nearly causing an accident. Jeep is not answering their phones. Dealership is saying to have it towed. I want Stellantis to take this vehicle back. Too many issues.
As I was driving the car on the highway, the engine light came on, then the "D" for drive gear started flashing and I could no longer accelerate or give the car gas. The only option was to "coast" across several lanes to the break down lane, put the car completely in park, shut off the ignition, and then restart the vehicle to drive again. This happened to me at least 7-8 times today (5 times while on the highway and a few while on other roads leading to and from the highway). I was unfortunately already on a drive to drop my children off somewhere so I had no choice but to complete the ride to the destination, then drive back home to park the vehicle. Needless to say, it's a very scary situation when you can no longer accelerate with cars coming up quickly behind you and you are unable to do anything but try to coast to a safe place to put the car in park and shut it off. It also happened to me while crossing an intersection and oncoming traffic from the other direction that then had a green light was swerving around me. I tried calling Jeep customer service to ask if it's a widespread issue and after 20 minutes on hold, the customer service rep came on to simply say their system is down and they're currently unable to assist anyone. I was almost in several accidents because of the issue and hope they send out a warning to all of those affected, assuming it was more than just my vehicle, because this seems to be occurring every since there was a mandatory software update yesterday. This happened at different speeds, in both electric and gas mode, and once while stopped at a red light, so there appears to be no consistent condition under which it occurs. It just unexpectedly happens and you need to pull somewhere safe with minimal control because of the lack of being able to accelerate (esp. if it occurs while you're on an upward slope because the ability to coast is almost nil).
Today while driving on my street in Electric mode at ~25-30 mph, suddenly an alarm dinged and the “D” on the transmission started flashing and the “check engine” light came on. I lost power to the drivetrain (pressing the accelerator pedal did nothing) and an alert on the screen said to press the brake pedal and start button to start the car. I pulled over, turned it off, then turned it back on again. It started driving but then the same thing happened after ~1 minute. Luckily I was in my neighborhood and not on a highway, so I was able to pull over. It was a bit scary because as the Jeep was almost to a stop (but still moving) suddenly the power steering gave out. Luckily I was near the curb. I repeated the same process, drove for one minute, repeat, one minute, repeat. The check engine light was on the whole time. This behavior has been documented by other Jeep owners on the internet and appears to be a software issue. Having the vehicle randomly shut down while driving is INCREDIBLY dangerous.
While driving my 2024 Jeep Wrangler 4xe (VIN: [XXX] ), the vehicle suddenly lost all motive power without warning. The accelerator pedal became completely unresponsive, the “D” indicator on the gear selector began blinking, and the vehicle coasted to a stop in traffic. It would not restart for several minutes. This has occurred multiple times since purchase. The most concerning incident happened earlier this year while driving on a freeway with my wife and two young children, the vehicle abruptly shut down in active lanes of traffic, forcing us to coast to the shoulder while cars passed at highway speed. On [XXX] the same failure occurred four times within a ten-minute drive home. Each time, the Wrangler became undriveable and required several minutes before it would restart. The vehicle is currently at Simi Valley Chrysler Jeep Dodge Ram for inspection (Service Order #[XXX]). The service advisor stated that multiple Wrangler 4xe vehicles were brought in for the same issue that morning. They also stated that the Wrangler 4xe has faced this issue for years and were not surprised by my story. The defect appears related to the hybrid powertrain control system or high-voltage electrical components. The problem has been reproduced and reported to Stellantis Customer Care as a serious safety concern. No warning lamps or messages appeared before the loss of power, only the blinking “D” indicator afterward. The vehicle and affected components are available for inspection upon request. This defect poses a severe risk of crash or injury due to sudden, total power loss while driving. Dealership confirmed multiple similar 4xe vehicles with the same stalling issue that day. This appears to be part of an ongoing pattern consistent with the federal safety agency investigation RQ24012 for loss of motive power in Jeep Wrangler 4xe models. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The latest Uconnect 5 update was performed by the Jeep dealership on my 2024 Wrangler 4xe on October 11th, 2024. After leaving the dealership, the vehicle shut off while driving and displayed a message instructing me to “shift to Park.” I lost propulsion and power steering, creating an immediate safety hazard. The dealership had just completed the update and told me it was safe to drive. Based on reports circulating among other 2024 Wrangler 4xe owners, this appears to be a widespread issue linked to the most recent Uconnect 5 update (released around October 10, 2025). Please investigate this issue as a potential safety defect related to the software update.
I accepted a uconnect software update last night and this morning lost complete power while diving my jeep multiple times. I had to pull over on busy streets, put the vehicle in park, turn on/off the vehicle a couple times and got it to start again. The check engine light has been on since. I went to the dealership and they said they’ve received multiple complaints today as well. I have it home and not drivable.
Updated vehicle last night via u-connect, vehicle died today while driving, lost all power. Check engine light on, hundreds of posts via social media with the same problem
2024 Hybrid. Vehicle shuts down while driving. Driver had to pull over to shut vehicle down and then restart it. Very dangerous situation.
A software update appears on the screen. I hit update and got out of the Jeep. A number of hours later I started up the Jeep and drove away, about a mile down the road while driving the Jeep entirely shutdown. The motor was off and I had not control. The dash told me to put it in park and update. I was luckily in a spot where I could just stop in the middle of the road, I put it in park restarted but now with the check engine light on. I was able to limp home. It was very scary as if it was a more major road I could have caused an accident.
Software update causes vehicle to completely loose power after two minutes or so of driving. Very serious problem and dangerous. Requires stopping vehicle immediately and rebooting. Happens again and again.
After an over-the-air update of the Uconnect system on 10/10/25 the vehicle repeatedly lost propulsion. In each instance I abruptly had absolutely no acceleration, the gear indicator on the dash started flashing, the power mode indicator (electric/hybrid/esave) disappeared, an alert said shift into park and press the brake + start button, and the check engine light and red wrench lights came on. I was still able to steer and brake with power steering and brakes for maybe 30 seconds before those went out too. After putting it into park and pressing the brake and start button it started back up and I could drive it normally for a little bit, but it happened two more times on a 1.5 mi drive. This is a serious safety issue. I read the check engine code which was P1E1D
The vehicle did an over-the-air update to the vehicles software, u connect. The vehicle has since suffered two losses of propulsion while driving, with check engine light indicator illumination and a P1E1D code. This has been reported by numerous other 2024 4xe drivers.
After the the latest U-connect update, my jeep will not run after about 30 seconds while driving. Stalls while in motion. Will restart, but then shuts off again. Has an engine code on dash.
This issue happens after an update on the car. Within 10 minutes after the car update the engine light came on and the car shut down on the road completely unable to drive . Without a warning, car stop to a complete shutdown while driving. My safety was at risk 5 times almost got into a car accident due to this issue where the car completely stopped while driving. Steering wheel completely locks when the car shuts down.
My vehicle prompted me to update my UCONNECT software around 540pm last night as I went tminto class. Upon leaving class around 845pm, I expierenced a complete loss of power, many dash indicator lights came on, and the vehicle message appeared indicating the vehicle needed to be put into Park. This all occurred while driving at about 40mph. I have never had any issues with the vehicle before this.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2024 Jeep Wrangler?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history