Check a VIN

2006 Kenworth T2000 problems

The most common problem on the 2006 Kenworth T2000 is brakes, typically around 233,260 miles. It has 3.5 times the complaints of a typical T2000 model year.

Typical year3.5x the typical complaints
Owner complaints
7
Recalls
7
Service bulletins
12
Worst area
Brakes

The worst 2006 Kenworth T2000 problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

  • Brakes
    7

Problems by type

Tap a problem to see which part fails, at what mileage and in which other years.

  • Brakes
    7

Recalls 7

Service brakes, airReported June 30, 2009 · 3,423 vehicles affected
What is wrong
Kenworth is recalling 3,423 my 2004-2009 t2000, t800,t600, w900 and t660 vehicles. Increased brake excitation in a certain vehicle configuration which includes bendix drum brakes, wide base low profile single tires, and an ag400 or ag460 rear suspension, due to its unique brake clocking and cam tube length, can cause fatigue and cracking to brake assembly components.
Risk
Cracking can cause a complete fracture of the cam tube, which could increase stopping distance and decrease parking brake hold capability.
Remedy
Dealers will inspect the rear axle brakes assembly, replace cracked rear axle brakes assembly components where required, and install cam tube support brackets on all rear axle wheel ends free of charge. The recall is expected to begin or before july 25, 2009. Owner may contact kenworth at 1‑425‑828‑5440.

Recall number 09V239000 · Recall details

SuspensionReported September 24, 2008 · 130 vehicles affected
What is wrong
Paccar is recalling 130 my 2004-2009 t2000, t800, t600, w900 and t660 kenworth trucks built with an ag400 rear suspension, long stroke brake chambers, and wide base tires (super singles). These vehicles may develop an increase in lateral and vertical axle movement. This movement may cause part or parts of the brake assembly (brake cam tube support, brake chamber bracket, brake chamber, brake spider) to develop fatigue cracks, possibly resulting in the failure of the part or parts within the brake assembly.
Risk
A failure may reduce vehicle brake performance, increasing the risk of a crash.
Remedy
Dealers will install the cam tube support brackets on all of the rear axle wheel ends. Inspect the rear axle brake assembly and replace it if cracked. The recall is expected to begin during november 2008. Owners may contact kenworth at 1‑425‑828‑5440.

Recall number 08V485000 · Recall details

Engine and engine cooling: engine: dieselReported September 23, 2008 · 4,883 vehicles affected
What is wrong
Paccar is recalling 4,883 my 2006-2009 kenworth t600, t660, t800, w900, t2000 and my 2008-2009 peterbilt 365, 367, 379, 384, 386, 387, 388 and 389 trucks. Inadequate stiffness of the diesel particulate filter (dpf) bracket could result in separation of the dpf from the chassis.
Risk
A vehicle crash could occur if another vehicle strikes the dpf on the roadway.
Remedy
Paccar is working with caterpillar to repair these vehicles (please see 08e041). Owners may contact caterpillar at 1‑800‑447‑4986 or kenworth at 1‑425‑828‑5440 or peterbilt at 1‑940‑591‑4196.

Recall number 08V487000 · Recall details

Engine and engine coolingReported June 28, 2007 · 28,968 vehicles affected
What is wrong
On certain trucks equipped with caterpillar c11, c13 or c15 engines, the oil fill cap can become dislodged due to cap damage or improper installation and become lodged in the u-joint of the steering driveline and steering gear.
Risk
If the cap becomes dodged in this area, it may result in difficulty steering the vehicle or cause complete steering lock-up increasing the risk of a crash.
Remedy
Paccar is working with caterpillar to repair these vehicles. Revised oil cap retention based on the engine model/configuration will be incorporated to prevent steering lock-up. The recall began during december 2007. Owners may contact caterpillar at 1‑800‑447‑4986 or kenworth at 425‑828‑5440.

Recall number 07V279000 · Recall details

Trailer hitchesReported June 26, 2007 · 9,571 vehicles affected
What is wrong
On certain trucks, the removable tow hitch ,when used to tow or lift a vehicle, can fail due to defective material in the tow hitch.
Risk
If the tow hitch assembly fails while a vehicle is being towed or lifted, it may cause an accident that could result in personal injury or death.
Remedy
Dealers will replace the tow pin assembly free of charge. The recall began on september 4, 2007. Owners may contact kenworth at 425‑828‑5440 or peterbilt at 940‑591‑4201.

Recall number 07V269000 · Recall details

Service brakes, airReported March 9, 2007 · 65 vehicles affected
What is wrong
Certain trucks fail to comply with the brake timing regulatory requirements of federal motor vehicle safety standard no. 121, "air brake systems." the brake valve was moved to the opposite rail, increasing the length of the air line, which in turn increased the wheelbase requiring a dual relay valve system. The vehicles were manufactured with a single valve system.
Risk
If stopping distance was limited, a vehicle crash could result.
Remedy
Dealers will convert the single relay valve to a dual relay valve system free of charge. The recall began on may 21, 2007. Owners may contact kenworth at 425‑828‑5440.

Recall number 07V090000 · Recall details

Engine and engine coolingReported December 22, 2005 · 30,995 vehicles affected
What is wrong
On certain tractors equipped with caterpillar diesel engines, the variable valve actuation oil line may wear against the sharp edge of the cylinder head if not positioned correctly.
Risk
The oil line may be cut on the cylinder head causing an oil leak and a possible fire.
Remedy
Caterpillar, in conjunction with paccar, will be conducting the owner notification and remedy for this campaign free of charge. Owners may call caterpillar at 309‑675‑6496, kenworth at 425‑828‑5440, or peterbilt at 940‑591‑4201.

Recall number 05V570000 · Recall details

See all 7 recalls for the 2006 Kenworth T2000

Defect investigations

Rear brake air chamber mtg bracketsOpened February 27, 2009, closed July 6, 2009

On june 23, 2009 paccar notified odi that 3,423 kenworth t2000, t800, t600, w900, and t660 trucks, model years 2004 - 2009, equipped with bendix brakes, wide base low profile tires and airglide (ag) 400/460 rear suspensions are being recalled.certain of these vehicles have experienced fatigue cracks in the brake cam tube mounting or air chamber mounting flanges bracket adjacent to the attachment welds. If left unrepaired, the cracks can cause a complete fracture of the cam tube, which could disable the affected brake and risk increasing vehicle stopping distances under high pressure brake applications and decrease parking brake capability.this configuration has experienced failures at a higher rate than similar vehicles with other types of suspensions and brake installation clocking. Paccar will also send an owner notification letter to owners of vehicles equipped with suspensions other than the ag 400/460, which will prescribe a periodic inspection of the components and if a crack is discovered, offer the owners the opportunity for a free repair.this policy will be in effect until july 15, 2014. Copies of the recall and the owner notification are attached.

PE09013

Trailer light plug failureOpened February 8, 2008, closed May 5, 2008

The office of defects investigation (odi) opened this preliminary evaluation of kenworth products based on their field communication tib # 34-31.kenworth introduced the qcs ii sta-dry trailer cable in may 2006.the technical information bulletin stemmed from field feedback that indicated a flexibility problem with the qcs ii cable connection, which could result in a loss of lighting to the trailer.odi believes a loss of lighting would adversely affect the trailer's visibility. Further, the resulting loss of brake lights is inherently critical to highway safety, day or night.kenworth has upgraded the tib repair to a safety recall.kenworth dealers will install a reinforcement bracket between the back of the qcs ii molded boot and the frame bracket, thus providing abetter cable connection. The defect notification was submitted on 4/25/08 (copy attached).trailers built between may 24 and november 21, 2006 (model year 2007 trailers) will be remedied.the population to be remedied is 3,573 in the united states.this investigation is closed.

PE08011

Technical service bulletins for the 2006 Kenworth T2000 12

Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.

See all 12 bulletins for the 2006 Kenworth T2000

What 2006 Kenworth T2000 owners say

Most recent owner complaints, unedited.

Filed Sep 3, 2008 · Brakes · 308,737 miles · MN

Left rear brake chamber broken at mounting studs and s-cam broken. Dealer welded up mount on s-cam and installed new brake chamber.

Filed Sep 3, 2008 · Brakes · 303,287 miles · MN

Brake chamber missing a bolt and bent push rod. Took to dealer - pounded bracket straight and replaced brake chamber.

Filed Sep 3, 2008 · Brakes · 231,028 miles · MN

Parking brakes were not working. Took to dealer. They replaced both s cam brackets and both brake chambers.

Filed Sep 3, 2008 · Brakes · 233,260 miles · MN

Dot scale in ca discovered both brake chambers on rear axle were broken. Truck was put out of service until repairs were made at the scale. Both chambers were replaced. Had this not been discovered a serious accident could've happened.

Filed Sep 3, 2008 · Brakes · 210,738 miles · MN

Right rear brake chamber cracked. Took to dealer and they replaced.

Filed Sep 3, 2008 · Brakes · 198,719 miles · MN

Right rear brake chamber was leaking. Took to dealer. Found internal rod end broken off. They replaced brake chamber.

Filed Aug 22, 2008 · Brakes · 376,100 miles · MN

On two of are 2006 t2000 kenoworth semis, the s-cam tube broke under stress of normal braking. Causing the trucks to lose there braking power to that tire. These trucks had around 400,000 miles on them. This kind of repair is rare this early in the trucks life, and is possibly dangerous if it happens at the wrong time.

Compare the 2006 Kenworth T2000

Other model years

19971998199920002001200220032004200620072008

Questions about the 2006 Kenworth T2000

Is the 2006 Kenworth T2000 reliable?

Owners have filed 7 complaints about the 2006 Kenworth T2000, 3.5 times a typical T2000 model year.

What is the most common problem with the 2006 Kenworth T2000?

Brakes, with 7 complaints, typically around 233,260 miles.

How many recalls does the 2006 Kenworth T2000 have?

7 recalls, covering service brakes, air, suspension and engine and engine cooling.

Was there a recall on the 2006 Kenworth T2000 brakes?

Yes, 2 recalls: 09V239000, 07V090000. Check your VIN to see if your car still needs the free repair.

Share your experience with the 2006 Kenworth T2000

Tell other buyers what went wrong and what it cost. We review every report before it appears, and we never publish names, emails or VINs.

No names, contact details or links. Reports about a dealer or a person are not published.

VIN decoder

See the problems and recalls for an exact car

Buying a used 2006 Kenworth T2000?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history
Is this car on a recall?Check VIN