2004 Nissan Quest problems

What is wrong

On certain mini vans equipped with a folding third row rear seat, when the third row seat is raised from its stowed position, it engages striker brackets, one on each side of the seat cushion. The fold-away striker loop is welded to a mounting bracket. The striker may become detached from its mounting bracket due to a broken weld at the point of attachment to the bracket.

Risk

If the third row seat striker weld fails, the striker could separate from the mounting bracket. Striker separation could affect the risk of injury in certain types of crashes.

Remedy

Dealers will replace the third row seat striker brackets free of charge. The recall began on december 19, 2005. Owners may contact nissan at 1‑800‑647‑7261.

Recall number 05V480000 · Recall details

What is wrong

On certain mini vans, there is a seat adjustment mechanism that contains exposed moving components located at the rear inside edge of the second row seat.

Risk

When the operator attempts seat adjustment, a finger may be pinched in the moving seat adjustment mechanism which could cause an injury.

Remedy

On earlier model vehicles built through june 28, 2004, dealers will replace the inboard second row seat adjustment handle, rivet a plastic reinforcement to backside of the existing seat back cover carpeting, install tie-downs and a flange to the inboard side shield. On vehicles produced from june 29, 2004 through september 26, 2005, dealers will rivet a plastic reinforcement to the backside of the existing seat back cover carpeting, install tie-downs and a flange on the inboard side shield. The recall began on december 19, 2005. Owners may contact nissan at 1‑800‑647‑7261.

Recall number 05V474000 · Recall details

What is wrong

On certain minivans equipped with a power sliding door(s), at an ambient temperature below approximately 40 degrees fahrenheit, the actuator for the power sliding door(s) may experience binding due to an out-of-specification condition. In order to open, close or reverse a power sliding door, the shift selector lever must be in "park." if the actuator is experiencing binding and the driver shifts the vehicle out of "park" while a power sliding door is still closing, the door latches may not engage.

Risk

This can result in the door coming open unexpectedly upon rapid acceleration, and an occupant could fall out of the door and be injured.

Remedy

Dealers will replace the actuator for the power sliding door(s). Owner notification began on june 23, 2004. Owners should contact nissan at 1‑800‑647‑7261.

Recall number 04V186000 · Recall details

What is wrong

Certain passenger vehicles fail to comply with the advanced air bag requirements of federal motor vehicle safety standard no. 208, "occupant crash protection." the air bag for the front passenger seat is to be turned off (so that it does not inflate) when certain occupants, such as small children, are in the front seat.

Risk

This reduces the risk of such occupants being unjured by an inflating air bag in a collision.

Remedy

Dealers will inspect the front passenger seat cushion/sensor assembly. If the seat cushion/sensor is found to be operating improperly, the seat will be removed and recalibrated. Owner notification began on june 23, 2004. Owners should contact nissan at 1‑800‑647‑7261.

Recall number 04V103000 · Recall details

The subject vehicles are equipped with optional seat-mounted side air bags.all vehicles are equipped with standard frontal air bags and side air curtains.installation of the incorrect SRS diagnosis sensor unit does not impair deployment of the frontal air bag and side air curtain in the event of a crash.no reports of non-deployment of the subject seat-mounted side air bags have been received by the manufacturer or by the federal safety agency.the warranty reports cited above represent vehicle inspections conducted under the service campaign and sensor replacement was required in 32 of these cases.the manufacturer reports a total of 151 sensor units sold as replacement parts for all purposes.investigation disclosed a low incidence of sensor replacement required under the service campaign to date.no incidents of real world non-deployment of the subject air bags were identified.this preliminary evaluation is closed.

PE08004

The seat adjustment mechanism contains exposed moving components, located at the rear edge of the second row seat.when the operator attempts to adjust the seat, a finger may be pinched in the moving seat adjustment mechanism.nissan will conduct a safety recall on an expanded scope of nissan quest vehicles.on vehicles produced from march 26, 2003 through september 26, 2005, nissan will rivet a plastic reinforcement to the backside of the existing seat back cover carpeting, install three tie-downs and install a flange to the inboard side shield.on vehicles produced from march 26, 2003 through june 28, 2004, in addition to the above corrective actions, nissan will replace the inboard second row seat adjustment handle with the current production seat lever. Nissan north america, inc. Will recall 109,437 my 2004-2005 nissan quest vehicles produced from march 26, 2003 through september 26, 2005.odi is aware of a total of 11 complaints, field reports and warranty claims reporting 11 finger injuries.the recall is identified by the federal safety agency number 05v474.

EA05012

Odi has received five reports alleging that the consumer was injured using the vehicle's second-row seat release lever to fold the second row seat.nissan states, ...the customer operation of the lever in some cases and subsequent orientation of their fingers is different than expected.nissan also reported additional complaints for a total of 11 injuries.nissan modified the lever for production twice.the latest (second modification) design provides a larger sized handle that contains a cup into which the seat occupant can place their fingers to operate the adjustment lever.nissan reports no injuries associated with the cup design lever.beginning june 2004, nissan initiated a customer satisfaction initiative that included replacing the original design handle with the first modification handle (this is not the cup design handle mentioned above).the investigation has been upgraded to an engineering analysis (ea05-012) to allow further analysis of the issue.

PE05019

In january 2004, nissan received reports of power sliding doors coming open while driving.nissan determined that at temperatures below 40 degree f, an out-of-spec door actuator could bind and prevent the door latches from fully engaging.this can lead to the door coming open unexpectedly.nissan notified the federal safety agency by letter dated april 1, 2004, that it is conducting a safety recall campaign (the federal safety agency no. 04v186) on my 2004 nissan quest vehicles with power-sliding doors produced from march 26, 2003 to december 17, 2003.nissan modified the acutator door motor on vehicles built after december 17, 2003 for reasons not related to the inadvertent door opening issue.nissan reports that vehicles built after december 17, 2003 are not subject to the failure mode that causes inadvertent opening.odi's review of the odi owner reports with known build dates (7 of 9 reports, plus one report received prior to dec 17 but with unknown build date) indicates that complaint vehicles were manufactured before the door actuator improvement date (dec 17).also, nissan reports no complaint vehicles with build dates after december 17.nissan's action addresses the concerns of odi.therefore, this investigation is closed.

PE04027