2013 Peterbilt 320 problems

What is wrong

PACCAR Incorporated (PACCAR) is recalling certain 1990-2020 Peterbilt 320 and 520 vehicles built with specific amber rear turn signals. The turn signals may also light up with the stop/tail lights when the brakes are applied. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

Risk

Rear Turn signals that illuminate at the same time as the brake lights may create confusion and impair the effectiveness of the brake lights, increasing the risk of a crash.

Remedy

PACCAR will notify owners, and for trucks with rear amber lights, dealers will add a jumper harness between the chassis electrical harness and amber tail lights, free of charge. The recall began August 1, 2019. Owners may contact PACCAR customer service at 1‑940‑591‑4220. PACCAR's number for this recall is 19PBC.

Recall number 19V452000 · Recall details

What is wrong

PACCAR Incorporated (PACCAR) is recalling certain model year 2010-2016 Kenworth T440, T800, and W900 trucks manufactured August 31, 2009, to April 20, 2015, and 2008-2015 Peterbilt 320, 337, 348, 365, 382, and 384 trucks manufactured July 27, 2007, to April 28, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.

Risk

If engine oil comes into contact with a hot surface, there is an increased risk of a fire.

Remedy

Cummins will notify owners on behalf of PACCAR, and Cummins service centers will administer the repairs which include securing the ends of the 90-degree elbow and reprogramming the electronic control module (ECM) with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Kenworth customer service at 1‑425‑828‑5000, Peterbilt customer service at 1‑940‑591‑4000 or Cummins Inc. at 1‑800‑343‑7357. PACCAR's number for this recall is 15KWH and 515-G.

Recall number 15V309000 · Recall details

What is wrong

PACCAR Incorporated (PACCAR) is recalling certain model year 2009-2015 Peterbilt 320, 365, 367, 388, and 389 trucks manufactured July 21, 2008, to February 28, 2014. The front axle tie rod end clamp bolts may be improperly torqued.

Risk

Undertorqued tie rod end clamp bolts are susceptible to corrosion, which may cause loose bolts to separate resulting in a loss of vehicle control and an increased risk of a crash.

Remedy

PACCAR will notify owners, and dealers will replace the front axle tie rod assembly on any vehicle where the factory installed assembly has not been previously replaced, free of charge. Owners were mailed interim notices on May 11, 2015. The recall began on April 4, 2016. Owners may contact Peterbilt customer service at 1‑940‑591‑4220. PACCAR's number for this recall is 215-C.

Recall number 15V108000 · Recall details

What is wrong

PACCAR Inc. (PACCAR) is recalling certain model year 2013-2015 Kenworth K300 and Peterbilt 210, 220, and 320 chassis manufactured March 14, 2012 to July 14, 2014. The affected vehicles may have loose fitting electrical connectors on the power distribution module which may cause the engine to shut off.

Risk

An unexpected engine shut down increases the risk of a crash.

Remedy

PACCAR will notify owners, and dealers will install nylon tie straps to hold the connectors in place until the permanent remedy, a connection position device, becomes available. Both remedies will be provided free of charge. The recall began January 29, 2015. For more information, Peterbilt owners may call 1‑940‑591‑4220 and Kenworth owners may call 1‑425‑828‑5000. PACCAR's number for this recall is 14KWH (Kenworth), and 714-G (Peterbilt).

Recall number 14V439000 · Recall details

What is wrong

Paccar is recalling certain model year 2012-2013 kenworth t170, t270, t370, t440, t470, t660, t700, t800, w900, and peterbilt 320, 330, 337, 348, 365, 367, 382, 384, 386, 388, 389, and 587 vehicles, manufactured from january 31, 2011, through january 19, 2012, and equipped with bendix atr-6 antilock traction relay valves. In extremely cold conditions, these bendix relay valves may potentially develop internal leakage. Internal leakage can lead to air pressure being delivered to affected primary or secondary brake causing continuous brake application.

Risk

Unexpected continuous brake application can cause the brakes to overheat and lead to a fire. Unexpected continuous brake application can cause the driver to lose control of the vehicle, increasing the risk of a crash. Also, the brakes may be applied without illuminating the brake lights, failing to give proper warning to other drivers.

Remedy

Paccar will notify owners, and provide a temporary repair until bendix develops a permanent remedy. This service will be performed free of charge. The safety recall began on february 10, 2012. Owner may contact kenworth at 1‑425‑828‑5440 and peterbilt at 1‑940‑591‑4196.

Recall number 12V026000 · Recall details