The worst 2007 Peterbilt 387 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 6
Equipment: other: labels
- What is wrong
- PACCAR Incorporated (PACCAR) is recalling certain model year 2006-2016 Peterbilt 587, 579, 567, 389, 388, 387, 385, 382, 379, 378, 367, 365 and 357 trucks manufactured July 25, 2005, to February 26, 2016. The affected vehicles may be equipped with Tire and Rim Certification Labels that list a tire pressure below the actual correct amount. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 120, "Tire selection and rims and motor home/recreation vehicle trailer load carrying capacity information for motor vehicles with a GVWR of more than 4,536 kilograms (10,000 pounds)."
- Risk
- If the tires are underinflated due to the incorrect inflation pressure listed on the label, the truck may not be able to carry the maximum gross vehicle weight rating (GVWR) load listed without experiencing tire failure which would increase the risk of a crash.
- Remedy
- Peterbilt will notify owners and mail them a corrected Tire and Rim certification label, free of charge. The recall began on June 19, 2015. Owners may contact Peterbilt customer service at 1‑940‑591‑4000. PACCAR's number for this recall is 215-D.
Recall number 15V132000 · Recall details
Fuel system, other: storage: tank assembly
- What is wrong
- Paccar is recalling certain model year 2008-2012 kenworth t2000, t660, t700, t800, and w900, as well as model year 2009-2012 peterbilt 365, 367, 384, 386, 387, 388, 389, and 587 trucks equipped with paccar mx engines. The oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil module onto exhaust components.
- Risk
- The discharge of engine oil onto exhaust components which are hot, such as when the engine is under significant load, may cause a fire.
- Remedy
- Dealers will re-torque the oil module filter cap and install a secondary retention device on the secondary centrifugal spinner filter cap. This service will be performed free of charge. The safety recall is expected to begin during march 2011. Owners may contact kenworth at 1‑425‑828‑5440 and peterbilt at 1‑940‑591‑4196.
Recall number 11V127000 · Recall details
Power train: axle assembly
- What is wrong
- Paccar is recalling certain model year 2007-2008 kenworth and peterbilt vehicles manufactured from february 2, 2006 through april 30, 2007. The bearing surfaces of the extended lube universal joint that attaches the inter-axle driveline to the drive axle may become prematurely worn due to breakdown of lubrication and/or excessive heat. Prematurely worn bearing surfaces may result in the u-joint becoming loose and/or binding. This condition may result in universal joint failure, allowing the inter-axle driveline to detach from the axle.
- Risk
- Detachment of the driveline from the axle may cause the vehicle to lose power and become disabled in the roadway. Also, the driveline could drop from the vehicle into the roadway increasing the risk of a crash.
- Remedy
- Paccar is working with its supplier to remedy the vehicles free of charge. The safety recall is expected to begin during february 2011. Owners may contact kenworth at 425‑828‑5440 and peterbilt at 940‑591‑4196.
Recall number 10V634000 · Recall details
Engine and engine cooling: engine: diesel
- What is wrong
- Paccar is recalling 1098 kenworth my 2008 t800, w900, my 2008-2009 t2000 and peterbilt my 2007-2009 379 and 387 trucks equipped with c15 caterpillar diesel engines. The aftertreatment regeneration device (ard) may develop a hole and heat and flame may escape during a regeneration of the diesel particulate filter.
- Risk
- This may result in a fire hazard.
- Remedy
- Paccar is working with caterpillar and will inspect and remedy the engines free of charge. Owners may contact caterpillar at 1‑800‑447‑4986, kenworth at 425‑828‑5440 or peterbilt at 940‑591‑4196.
Recall number 09V019000 · Recall details
Power train: axle assembly
- What is wrong
- On certain trucks, the axle housings may have been manufactured with steel that was out of specification which could result in a fatigue failure over time.
- Risk
- If a fatigue failure occurs and is left unattended, the axle may lock up or the end of the axle could come off, which may result in a vehicle crash.
- Remedy
- Dealers will inspect and replace the axles free of charge. The recall began on may 9, 2007. Owners may contact kenworth at 425‑828‑5440 and peterbilt at 1‑940‑591‑4196.
Recall number 07V132000 · Recall details
Suspension
- What is wrong
- On some peterbilt trucks, certain parts used in the air suspensions have a high copper content causing premature failure.
- Risk
- Failure could cause erratic vehicle handling which can cause a vehicle crash without warning.
- Remedy
- Dealers will inspect and, when necessary, replace the defective parts. The recall began on january 17, 2007. Owners may contact peterbilt at 1‑940‑591‑4196.
Recall number 06V490000 · Recall details
See all 6 recalls for the 2007 Peterbilt 387
Defect investigations
Driveshaft separates from tractor
SummaryOn July 13, 2010, the Office of Defects Investigations (ODI) opened an investigation on model year (MY) 2007-2009 Peterbilt tractors equipped with the (SPL170XL extended lube inter-axle driveline).ODI opened this investigation based on one Vehicle Owners Questionnaire (VOQ) and certain Peterbilt field reports.During the course of the investigation, ODI reviewed PACCAR's IR (October 22, 2010) response with associated data related to Warranty and complaint information, mined field data, interviewed customers and visited local dealers within the Washington Metropolitan area.PACCARconducted testing regarding torsional loading and identified various causative factors contributed to this safety defect finding.The Defect is a consequence of the bearing surfaces of the SPL170XL extended lube universal joint that attaches the inter-axle driveline to the drive axle becoming prematurely worn due to a breakdown of lubrication and/or excessive heat.Prematurely worn bearing surfaces may result in the u-joint becoming loose and/or binding.This condition may result in universal joint failure, allowing the inter-axle driveline to detach from the axle, which may cause the drive shaft to separate from the vehicle, increasing the risk of personal injury or property damage hazard.ODI learned that the affected population of the alleged defect extended to peer models within PACCAR.In summary, the following vehicles are being recalled: MY 2007 and 2008 Kenworth trucks, models T600, T660, T2000, T800 and W900 and MY 2007/2008 Peterbilt trucks, models357, 378, 379, 385, 386, 387, 388, and 389 allequipped with extended lube inter-axle drivelines manufactured by Dana Corporation.The recall affects vehicles manufactured between February 2, 2006 and April 30, 2007.At this time PACCAR has not yet identified a fix for the inner-axle safety defect and is currently conducting testing with the intent to provide a solution to the failure.ODI will monitor the development of PACCARS testing and ensure a timely repair for the consumer.This investigation is closed.
PE10029
Horton Fan Hub Failures
PACCAR is conducting an Owner Notification Program (ONP) for select vehicles within the subject and peer populations.The ONP are attached to the closing report and can be found in the federal safety agency Technical Service Bulletin (TSB) database. (TSB: 10033585, 10033584)See Closing report for investigation details.
EA09008
Rear brake air chamber mtg brackets
On june 23, 2009 paccar notified odi that 3,423 kenworth t2000, t800, t600, w900, and t660 trucks, model years 2004 - 2009, equipped with bendix brakes, wide base low profile tires and airglide (ag) 400/460 rear suspensions are being recalled.certain of these vehicles have experienced fatigue cracks in the brake cam tube mounting or air chamber mounting flanges bracket adjacent to the attachment welds. If left unrepaired, the cracks can cause a complete fracture of the cam tube, which could disable the affected brake and risk increasing vehicle stopping distances under high pressure brake applications and decrease parking brake capability.this configuration has experienced failures at a higher rate than similar vehicles with other types of suspensions and brake installation clocking. Paccar will also send an owner notification letter to owners of vehicles equipped with suspensions other than the ag 400/460, which will prescribe a periodic inspection of the components and if a crack is discovered, offer the owners the opportunity for a free repair.this policy will be in effect until july 15, 2014. Copies of the recall and the owner notification are attached.
PE09013
Horton fan hub failures
There are 84,573 subject and peer (kenworth) vehicles.subject vehicles are model year 2007 through 2008 paccar trucks built with a horton fan hub assembly.the ea will include peer vehicles (kenworth's with horton fan hubs) in the subject population.there are a total of 1,645 warranty claims on the combined population.odi surveyed warranty claim owners and found that a significant number of the failures resulted in a disabled vehicle.odi also believes that certain models are more prone to failure and further analysis is warranted to understand the differences in failure rates. Odi is concerned that a large disabled vehicle is at an increased risk of being struck in the rear by another vehicle.odi is also concerned that this failure mode provides little warning and therefore, a driver has less opportunity to remove the vehicle from the travel lanes or shoulder, once a fan separation has occurred.odi will conduct further risk assessment during the ea to gain an understanding of the warning, options available to the driver and the increased risk of the truck being struck in the event of a breakdown.the federal safety agency has upgraded pe09-002 to an ea (ea09-008) to further investigate this matter.
PE09002
Technical service bulletins for the 2007 Peterbilt 387 16
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- "Kenworth: Dealers should check the chassis list and SIR weekly for VIN changes
- 1210F - spl 170XL
- Information Only – Windshield washer pumps have a high No Trouble Found rate
- Fix as Fail: For all conventional models, except 387/587, equipped with Side-of-Cab (“SOC”) exhaust and...
- Information Only: This bulletin provides dealers with a battery warranty quick reference guide to ensure...
- Information only: Hendrickson Softek front axle maintenance intervals and requirements.
- Information Only: Proper jump-starting voltage will eliminate high voltage related issues and equipment...
- Information Only – Vehicles may have the connector seals on the wheel speed sensor incorrectly installed,...
- Information Only: Vehicles may have the connector seal on the wheel speed sensor incorrectly installed,...
- Information Only: This bulletin provides guidance for repairing an air-conditioning system after internal...
Compare the 2007 Peterbilt 387
Other model years
Questions about the 2007 Peterbilt 387
Is the 2007 Peterbilt 387 reliable?
Owners have filed 0 complaints about the 2007 Peterbilt 387.
What is the most common problem with the 2007 Peterbilt 387?
There are not enough complaints to tell.
How many recalls does the 2007 Peterbilt 387 have?
6 recalls, covering equipment, fuel system, other and power train.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 Peterbilt 387?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history