2002 Toyota Tundra wheels problems

Filed Jun 13, 2021 · Steering, Suspension · VA

on June 9th at about 2pm while driving through my neighborhood, my upper an lower ball joints on my 2002 Toyota Tundra separated from my vehicle causing a catastrophic loss of control of truck and tore my hub with tire from vehicle ripping the brake fuel line and shoving entire components up under my Tundra while losing control with no brakes or steering capability. It also destroyed the drivers side front tire. Needless to say if I was say...going 55 to 60 miles per hour on highway...I would not be writing this. Had truck towed to Checkered Flag Toyota and they quoted me a price of over1300$ in repairs... they are fighting me on fixing my truck damages even though said damages were caused by the ball joint recall on the 2002 tundra...recall I D#05v

Filed Jul 13, 2018 · Wheels · 106,000 miles · NY

While driving, I had my spare tire fail off the car due to tundra spare tire lift plate rot. I was unaware of this condition and could have resulted in a serious accident.

Filed Mar 3, 2016 · Body, Brakes · 171,145 miles · UT

My first issue was 3 years ago when my muffler was so rusted away I felt something dragging pulled over and seen my muffler had fall almost off hanging there. The next year I pulled into my work and all my studs on my tire broke and my tire and rim went one way and me and the truck went other way. Now my brakes keep sticking then they finally just stopped working all together after replacing pads. I have went thur 3 sets of tires in 4 years. I have it in the shop and they are saying my brake lines are completely corroded and falling apart.

Filed Jul 22, 2015 · Suspension, Wheels · 174,612 miles · OH

Took the truck in for recall inspection of rear as per recall notice #bxd ssc. Was told by sunnyside toyota that the rear part was fine but the other part of frame is badly corroded. They/and the toyota manufacturer said that this portion of frame is not covered under recall. Estimate of repair cost $15,000. Remarks on vehicle inspection report: 99 front section of frame has a large hole that we feel is getting to the point of being dangerous/not part of bxd campaign

Filed Jul 8, 2015 · Body, Tires · 160,000 miles · OH

I was driving down the street and the spare tire fell off. It actually caused the truck to bounce up slightly. Luckily the tire did not contact any other vehicles. Thing to note: my truck was part of the frame corrosion recall issued by toyota. At the time, they did not replace the frame but only covered the rust with some coating. That did not stop nor slow the rust. The "band aid" they used was insufficient at solving the problem, it only covered it temporarily.

Filed Feb 7, 2007 · Wheels · 31,000 miles · CA

Tundra 2002 v6 vibrated badly at 45 MPH. When checking, found 3 broken studs in the front wheels, 2 from the driver side and 1 from the passenger side. With some on-line research, a tsb for this particular model and year has issued back in 2003. Yet, owners of this tundra model had never been made aware of it. While making a call to toyota corporation, a customer service representative stated that there is an upgrade brake system-calipers, brake pads, and other parts related to the front brake-available for free of charge for tundras that have had brake problems. When taking this problem to a local toyota dealer, no one seemed to take any action. 3 months later, they still didn't fix my car. Brake history-several complaints about the brakes and rotors being worn out and warped fast have been brought up the local dealer. Every time a complaint was made, the answer was that brake is not covered by the 3-year/36k warranty. When the studs broke off, dealer told me that they didn't document any of my complaints due to the facts that I never asked them to repair my brake. Wow, it sounds like they have to rip me off before they document my complaints. If others got their brake system upgraded for free of charge, then why not me?

Filed Nov 3, 2005 · Brakes, Wheels · 103,461 miles · FL

Consumer complaint regarding 2002 toyota tundra. The vehicle makes noise when turning left. The vehicle was taken to the dealer who determined that five of the lug nuts were loose due to stress. 5 of the lugs were left loose. One stud broke and one lug nut was holding the wheel in place. *ts the consumer noticed that the tire were worn and asked the service manager to have them checked. It was determined that they were indeed worm and the tires were replaced. After the tires were replaced the consumer notice a problem with the front end that was not there prior to the tire replacement. The dealer replaced all 6 lug nuts, 1 stud and cap which was installed incorrectly. The brakes were replaced at 20000 miles and 90000 miles. About 6000 miles after the last brake service the consumer notice a pulsation when the brakes were applied. The vehicle was taken back to the dealer where they replaced the rotors.

Filed Sep 19, 2005 · Brakes, Engine · 6,000 miles · NV

I have had multiple problems with my 2002 tundra trd 4wd. I have had it in more than 4 times for the brakes vibrating/pulsating and looks like I will be taking it in again as they are starting to vibrate again!! Reno toyota has always done all the maintenance on it and keep trying to say it is my fault the brakes are bad and the rotors are warping. They replaced the rear axles a couple of months ago but I had to pay the $50 deductible. They also had to install a gasket on the crossover for the engine coolant as the factory never installed it. The AC doesn't get cool enough to cool the interior. Whistling noise but don't know where it is coming from...sounds like coming from side mirrors??? I replace the wheels recently because of vibration because the wheels were warped. Always have excessive brake dust on front wheels. Transmission feels and sounds like it is slipping all the time. Rough idle after warm up. I bought it new in july 2002 and now have 69400 miles on it. Most of which are highway miles with no towing ever...no heavy hauling ever. Am too afraid to drive it off-road because of all the brake problems...nevada=mountains=cliffs=death...I am not ready to risk my life or my grandchildren so will not even let me ride with me anywhere.

Filed Dec 29, 2002 · Wheels · 6,014 miles · CA

I was rotating the tires and tightening the lug nuts when six broke. My torque wrench was set at 80 pounds, below the 82 recommendation. Two lug nuts on the right rear on one on the right front would not tighten and just kept turning. Eventually each of the lug nuts fell off, breaking the stud. The studs did not "snap" like a clean break. The lugs that broke were possibly not hardened or were made from some very soft metal. The left side produced similar results on the left rear. The left front secured all six lug nuts properly with the 80 # torque setting. On the left rear, three of the studs, all adjacent to one another broke just like the three did on the right side. I have been changing tires for 35 years and have only broken one stud previously. Eighty foot pounds of torque is not very much to break off a stud. Chevrolet currently sets lug nuts at 145 foot pounds of torque. I feel something is wrong with the lug studs on this vehicle, or at least the six that merely broke. Thirty of the lug studs held and tightened according to procedures. However, the six that broke did so before ever causing the torque wrench to reach a mere 80 foot pounds, which was actually two pounds under the recommended setting. In looking at the steel stud where it twisted apart, the metal has the appearance of cast pot metal, not cold hard steel. So far, I have received no help from the toyota dealer. They say, "you caused them to break, it is not our fault. We change tires all day with our air impact wrenches and we are not breaking them." a "digitorque" torque wrench is much more accurate than an impact wrench. That is why I own one because I realize the importance of setting nuts and lugs at the right setting. For these reasons, I feel that some lug nut studs that may have not been hardened, etc., were installed on my vehicle since they broke off under very little pressure.

Filed Aug 13, 2002 · Wheels · IL

Rims on vehicle are bent, material seems to be too soft. *ak the problem already has gone to the bearings and rotors.