2023 Toyota Tundra. On July 20, 2026 and again on September 18, 2026, while driving, the truck suddenly lost power and went into limp mode. The dash showed 'Check Engine / Reduced Engine Power / Visit Your Dealer' at about 43,440 miles. The truck had to be towed to the dealer on a flatbed. Losing power without warning in traffic is a serious safety risk. Other ongoing problems: the brakes squeaked for over a year before they were fixed, the driver seat bolster plastic is broken (this would be the third repair), the radio volume knob has failed, and there is excessive wind noise. This VIN still shows open recall 25V767 (engine machining debris causing loss of motive power), which has not been performed despite two dealer visits for this exact failure.
Toyota Tundra won't shift problems
109 of the 6,967 owner complaints about the Toyota Tundra describe stuck in gear or won't shift, most of them for the 2012 model year.
- owner complaints
- 109
- worst model year
- 2012
- typical repair cost reported
- $3,000
- typical mileage
- 90,000
By model year
Often reported together
Check engine light 39Loss of power 20Warning lights 4Stalling 3Hesitation 3Adaptive cruise 3Transmission failure 2Jerking 2
Trouble codes mentioned
P2442 7P2440 3P0418 3P2432 2P2714 1P2443 1P2433 1P2240 1P0751 1
What owners say
turbo's have to be replaced because of a wastegate failure. This is a well known issue. My vehicle is at 66700 miles and Toyota has denied a good will claim. Though they admit there is nothing I could have done differently because its a defective part. My safety is put at risk because the truck goes into limp mode and a "reduced power" message is displayed. The dealership has confirmed the issue but because its 7k outside of warranty they are unwilling to do anything even though its a defect. Vehicle has only been inspected by dealership. they also have a diagnostic test for the total engine recall and its very subjective. I don't believe they are keeping safety in mind. I think they are trying to deny as many of those claims as possible.
The TCM is faulty. There is a tsb so Toyota is well aware of the issue. They will not take care of it under the power train warranty. The TCM doesn't shift the vehicle correctly. This lag and funny shifting almost caused an accident.
Manufacturer Recall Number25TB06 the federal safety agency Recall Number25V322 In regards to the above mentioned recalls. The vehicle's reverse camera began flashing while driving forward. The R light on the gearshift was also flashing. While driving forward about 15 mph out of a parking lot, the vehicle suddenly went into reverse on it's own, locked up and would not move. I had to have the vehicle towed to the dealership. This happened around the week of June 8. The dealership says that they reset the electrical recall, we picked up the truck and it ran fine for about a week. The reverse camera and R light on the gearshift began flashing again on June 17. It did not shift itself into reverse, but the dealership requested that we bring the vehicle back. The dealership stated that Toyota has "grounded" the vehicle and does not have a fix for the recall to date and continuing to drive it is a safety hazzard. It has been sitting at the dealership since June 18 with no end in sight. The dealership and Toyota Corporate continues to tell me every few days that they do not have a fix for the issues/recalls.
Loss of power limp mode at highway speeds, error notification on screen to visit dealer. Almost caused sever wreck. Hybrid motor did nothing to mitigate risk.
Throttle body was replaced, no dealer advice to replace driving down the road all of a sudden my vehicle went from highway speeds to limp mode on the middle of the highway and a whole bunch of warnings came on secondary brake system failure, hybrid control failure , stoped on the side of road truck stalled then restarted normal then all warnings came back and back to limp mode, problem comfirmed by dealer in el paso almost 300 miles away from home, not sure who the dealer showed to , and no prior warnings at all before this happend at 51k miles on my 2024 toyota tundra.
The 2023 Toyota Tundra Hybrid’s powertrain design may be insufficient to maintain basic safety maneuvers (specifically "limp mode" or emergency clearing) during an engine failure while operating under high-load conditions in mountainous terrain. This creates a life-threatening hazard for the occupants and other motorists. Statement of Fact: As an owner of a 2023 Toyota Tundra Hybrid, I primarily utilize this vehicle to tow a 9,000 lbs travel trailer through the high-altitude, steep-grade regions of Utah. These routes frequently consist of narrow, two-lane mountain passes with no shoulders and steep drop-offs. Failure Under Stress: Engineering logic suggests that engine stress is highest during heavy towing on steep grades. If a primary engine failure occurs in these conditions, the hybrid system’s battery and electric motor capacity are, in my experience, inadequate to move a combined Gross Combined Vehicle Weight (GCVW) of approximately 15,000+ lbs to a safe location. While the hybrid system may allow a light, unladen vehicle to limp to a shoulder under "ideal conditions," it lacks the torque and sustained power to move a heavy trailer on a grade once the internal combustion engine is compromised. In the event of a failure, the vehicle would likely become "dead in the water" in the middle of a live, narrow lane on a blind mountain curve. Without the ability to reach a turnout or even a marginal shoulder due to the weight of the load, the vehicle becomes a stationary target for other high-speed mountain traffic, posing a severe risk of rear-end collisions and multi-car accidents. I am requesting that the federal safety agency investigate the performance of the Tundra Hybrid’s "fail-safe" modes specifically under maximum towing capacity on grades.
The contact owns a 2024 Toyota Tundra. The contact stated that while driving approximately 45 MPH, the vehicle went into LIMP Mode and failed to accelerate. The contact stated that the messages “Engine Power Reduced” and “Support Brake Malfunction” were displayed. The vehicle was able to restart. The contact stated that while driving approximately 45 MPH, the message “Malfunction with Throttle/Engine/Powertrain” was displayed. The vehicle was towed to the dealer, where it was diagnosed and determined that the vehicle had experienced a low-voltage failure and needed to be repaired. The vehicle was repaired; however, the failure recurred. The vehicle was taken back to the dealer, where it was diagnosed that the computer software had failed, and a software update was needed. The contact received notification of the federal safety agency Campaign Numbers: 26V038000 (Back Over Prevention), 25V322000 (Exterior Lighting), and 25V767000 (Engine and Engine Cooling); however, the parts for the recall repairs were not yet available. The manufacturer was made aware of the failure. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The approximate failure mileage was 7,278.
Transmission does not shift into gear after accelerating from a brief or rolling stop.
Intermittent Transmission issue. Truck will not shift into 5th or 6th gear. Temporary fix is turning the car off and on again. Problem will eventually return. Is this a Software or Hardware issue? Is there a campaign or recall on this issue?
Related recalls
Power train: automatic transmission
- What is wrong
- Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2022-2024 Tundra, Tundra Hybrid, Lexus LX600, and 2023-2024 Sequoia Hybrid vehicles. Unexpected vehicle movement may occur when the vehicle is in neutral and the brakes are not applied.
- Risk
- Unexpected vehicle movement can increase the risk of a crash.
- Remedy
- Dealers will update the transmission control ECU software, free of charge. Owner notification letters were mailed April 8, 2024. Owners may contact Toyota customer service at 1‑800‑331‑4331. Toyota's numbers for this recall are 24TA02 and 24LA02.
Recall number 24V125000 · Recall details
Power train: axle assembly: axle shaft
- What is wrong
- Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2022 Tundra and Tundra Hybrid vehicles. The flange nuts on the axle shaft sub-assemblies can loosen over time and potentially cause one or both axle shaft sub-assemblies to separate from the axle housing.
- Risk
- Axle shaft separation can cause a loss of vehicle stability and brake performance, increasing the risk of a crash.
- Remedy
- Dealers will inspect the rear axle assembly, tighten the axle flange nuts, and replace any damaged axle-related components if necessary, free of charge. Owner notification letters are expected to be mailed July 15, 2022. Owners may contact Toyota customer service at 1‑800‑331‑4331. Toyota's number for this recall is 22TA05.
Recall number 22V445000 · Recall details
Power train: driveline: driveshaft
- What is wrong
- Toyota is recalling certain model year 2011 tundra vehicles equipped with a 3-joint type propeller shaft. Due to improper casting of the slip yokes, there is a possibility that the slip yoke may break, causing the propeller shaft to separate at the joint and come into contact with the road surface.
- Risk
- The driver could experience loss of motive power and vehicle control, increasing the risk of a crash.
- Remedy
- Toyota will notify owners and inspect the propeller shaft and, if necessary, replace it free of charge. The safety recall is expected to begin during may 2011. Owners may contact toyota at 1‑800‑331‑4331.
Recall number 11V254000 · Recall details
Power train: axle assembly: axle shaft
- What is wrong
- Toyota is recalling certain model year 2010 tundra vehicles with four wheel drive, there is a possibility that an improper weld exists at the union of the propeller shaft and yoke. Due to this improper weld, this joint may separate and the separated shaft may come into contact with the road surface.
- Risk
- This may result in a loss of vehicle control increasing the risk of a crash.
- Remedy
- Dealers will replace the front propeller shaft free or charge. The safety recall began on march 19, 2010. Owners may contact toyota at 1‑800‑331‑4331.
Recall number 10V091000 · Recall details
Power train: driveline: driveshaft
- What is wrong
- On certain 4-wheel drive pickup trucks, due to the improper heat treatment of the slip yokes that had been reworked during the manufacturing process, the hardness of the slip yoke may be insufficient.
- Risk
- In this condition, there is a possibility that the yoke may break causing the propeller shaft to separate at the joint and come into contact with the road surface or the fuel tank which could result in a loss of vehicle control or a fuel leak.
- Remedy
- Dealers will inspect the slip yoke and replace the propeller shaft if necessary free of charge. The recall began on january 7, 2008. Owners may contact toyota at 1‑800‑331‑4331.
Recall number 07V579000 · Recall details
Questions about the Toyota Tundra won't shift
Which Toyota Tundra years have stuck in gear or won't shift problems?
The model years with the most reports are 2012 (30 complaints), 2007 (19 complaints) and 2008 (17 complaints).
How much does it cost to fix stuck in gear or won't shift on the Toyota Tundra?
Owners who mentioned a price put the repair at about $3,000 (median of 25 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Toyota Tundra?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history