2008 Volvo VHD problems

What is wrong

Volvo Trucks North America (Volvo) is recalling certain 2004-2019 Volvo VHD trucks equipped with snow plow lamp preparation kits. The snow plow headlights can be turned on without other exterior lights, and high beam indicator will not work when the snow plow high beams are on. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

Risk

The driver may operate the vehicle with the snow plow headlights on but the marker and tail lamps off, reducing the vehicle's visibility and increasing the risk of a crash.

Remedy

Volvo will notify owners, and dealers will update the software related to the plow lights, free of charge. The recall began December 19, 2018. Owners may contact Volvo customer service at 1‑800‑528‑6586. Volvo's number for this recall is RVXX1804.

Recall number 18V766000 · Recall details

What is wrong

Volvo Trucks North America (Volvo) is recalling certain model year 2007-2014 VAH, VHD, VNL, VNM, and VT models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch from automatically disengaging when the brake is applied.

Risk

Without a signal to disengage the clutch when the brakes are applied, the distance required to stop the truck may lengthen, increasing the risk of a crash.

Remedy

Volvo Trucks will notify owners and dealers will inspect and repair the vehicles if necessary. The recall began on August 26, 2013. Volvo's recall number is RVXX1303. Owners may contact Volvo at 1‑336‑393‑2000.

Recall number 13V268000 · Recall details

What is wrong

Volvo is recalling certain model year 2002-2013 VHD and VN trucks, manufactured from August 4, 2000, through June 22, 2012, and equipped with bench passenger seats. The seat belt d-ring weld may not be sufficient enough to meet the seat belt pull test. Therefore, these vehicles fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 210, "Seat Belt Assembly Anchorages."

Risk

In the event of a crash, an insufficient seat belt weld may prevent the seat belt from properly restraining the occupant. This increases the risk of injury to the seat occupant.

Remedy

Volvo Trucks of America will notify owners, and dealers will replace the suspected d-ring, free of change. The safety recall began on May 10, 2013. Owners may contact Volvo at 1‑336‑393‑2000.

Recall number 12V510000 · Recall details

What is wrong

Volvo is recalling certain model year 2008-2011 vhd, vnl, vnm, as well as 2008-2010 vt vehicles for failing to comply with the requirements of part 567, "certification." the tire description may be incorrect on the vehicle's certification label.

Risk

The misinformation on these labels could lead to a vehicle overloading that can increase risk of a crash.

Remedy

Dealers will inspect and replace the labels free of charge. The safety recall began on february 25, 2011. Owners may contact volvo at 1‑800‑458‑1552.

Recall number 10V492000 · Recall details

What is wrong

Volvo trucks is recalling 127,764 my 2001-2008 vhd, vnl, vnm, and my 2005-2008 vt trucks. A seal may fail allowing water and contaminants to seep into the windshield wiper motor.

Risk

If this happens a short circuit may occur, which over time could possibly lead to a vehicle fire.

Remedy

Volvo will replace the wiper motor free of charge. Since this recall involves a large number of vehicles, volvo will release the recall in stages as parts are received. Priority will be given to the vehicles located in the regions/states that have a corrosive environment. The recall began on september 30, 2009. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 09V173000 · Recall details

What is wrong

On certain heavy duty trucks, the circuit protection (I.e. Automatic circuit breakers) used to protect the vehicle lighting system may not provide adequate protection.

Risk

If a short circuit occurs and is left untreated, components and wiring may be subject to overheating which could possibly result in a vehicle fire.

Remedy

Dealers will replace the circuit breakers with fuses. The recall began on february 25, 2008. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 07V573000 · Recall details

What is wrong

On certain trucks equipped with a saf holland simplex fifth wheel, the lever arm pivot bolt may have been over tightened. An over tightened pivot bolt can distort the pivot bolt spacer sleeve, which may prevent the fifth wheel latch jaw from closing and latching securely around the trailer king pin.

Risk

There is a possibility that the pivot bolt can become loose without the driver's knowledge. When this occurs, the driver could drive away and the trailer could become disengaged, increasing the risk of a crash.

Remedy

Dealers will replace the pivot bolt and sleeve with a hex head shoulder bolt and washer free of charge. The recall began on january 28, 2008. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 07V496000 · Recall details

What is wrong

On certain trucks, the hood restraint cylinder does not contain enough dampening to adequately restrain the hood.

Risk

The cylinders could possibly separate, which would leave the hood unrestrained when opening and closing the hood.

Remedy

Dealers will replace the hood restraint cylinders free of charge. The recall began on october 15, 2007. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 07V410000 · Recall details

What is wrong

On certain trucks, an unprotected lead in the thermoswitch of the heater may make contact with another post possibly creating a short circuit, which can result in continuous operation of the heating element.

Risk

If the condition exists and the key is left on without fuel in the filter, the heating element may heat to a point where a flame becomes present at the tip of the element which could result in a vehicle fire.

Remedy

Dealers will inspect the thermoswitch and will replace it if necessary. The recall began on september 10, 2007. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 07V345000 · Recall details

What is wrong

On certain trucks, the nut used to retain the steering shaft may or may not be a lock nut that has the locking feature. A lock nut is required to provide additional resistance to ensure that the nut does not come loose.

Risk

If the nut were to come loose, the steering shaft could potentially separate resulting in loss of steering control which could cause a crash.

Remedy

Dealers will replace the steering shaft pinch bolts and locknuts free of charge. The recall began on august 24, 2007. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 07V323000 · Recall details

The Office of Defects Investigation (ODI) received Early Warning Reporting (EWR) data from the manufacturer that indicated some number of subject vehicles equipped with the subject automated manual transmission had allegedly experienced a condition where the clutch failed to automatically disengage the transmission from the engine as intended. This may result in extended stopping distances and/or unintended forward motion of a vehicle previously at rest.To date, ODI is aware of 134 subject vehicles with one or more complaints or field reports related to this condition.Also, ODI is aware of 164 subject vehicles with one or more warranty claims related to this condition.By letter dated June 25, 2013, Volvo Trucks North America (Volvo) notified ODI that it has initiated a safety recall (the federal safety agency Recall No. 13V268 and Volvo Recall No. RVXX1303) to address a safety defect in approximately 23,003 model year (MY) 2007 through 2014 Volvo VAH, VHD, VNL, VNM and VT model trucks. The affected vehicles were manufactured from December 20, 2006 through May 22, 2013 and were originally equipped with the subject automated manual transmissions.According to Volvo, reports of the subject transmission clutch mechanism failing to automatically disengage as intended are associated with the removal of a brake pedal micro switch that provided a redundant signal to the transmission control module indicating the brakes had been applied.Previously, Volvo had removed this brake pedal micro switch from new vehicle production and from certain vehicles already in-service via two field service campaigns (SP 432-024 and SP 432-026) because it decided the switch was unnecessary and/or a maintenance issue.In the absence of this redundant brake pedal micro switch, the clutch mechanism may fail to disengage the transmission from the engine at low vehicle speed should the stop lamp switch fail to send and/or the transmission control module fail to receive the primary signal.At the time of this closing, Volvo is evaluating available remedies and will provide the federal safety agency with details when the recall remedy procedure has been finalized.Volvo will notify affected owners by mail by August 25, 2013.Please see the federal safety agency Recall No. 13V268 for details.Accordingly, this investigation is closed.

PE13002

On october 18, 2007 volvo trucks north america filed defect report 07v‑496 which outlines a safety recall program to notify the affected owners and correct the affected vehicles.

PE07046