2013 Volvo VHD problems

What is wrong

Volvo Trucks North America (Volvo) is recalling certain 2004-2019 Volvo VHD trucks equipped with snow plow lamp preparation kits. The snow plow headlights can be turned on without other exterior lights, and high beam indicator will not work when the snow plow high beams are on. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

Risk

The driver may operate the vehicle with the snow plow headlights on but the marker and tail lamps off, reducing the vehicle's visibility and increasing the risk of a crash.

Remedy

Volvo will notify owners, and dealers will update the software related to the plow lights, free of charge. The recall began December 19, 2018. Owners may contact Volvo customer service at 1‑800‑528‑6586. Volvo's number for this recall is RVXX1804.

Recall number 18V766000 · Recall details

What is wrong

Volvo Trucks North America (Volvo) is recalling certain model year 2009-2016 VHD trucks manufactured from April 7, 2008, through December 9, 2015, equipped with USK non-greasable drag links. The ball joint seals may be compromised, which can allow water and other contaminants to enter the ball joints.

Risk

If water and contaminants enter the ball joint, corrosion can occur and lead to accelerated wear, which over time can result in failure of the ball joint, possibly resulting in complete loss of steering, increasing the risk of a crash.

Remedy

Volvo will notify owners, and dealers will replace the drag links, free of charge. The recall began on December 2, 2016. Owners may contact Volvo customer service at 1‑800‑528‑6586. Volvo's number for this recall is RVXX1606.

Recall number 16V735000 · Recall details

What is wrong

Volvo Trucks North America (Volvo) is recalling certain model year 2007-2014 VAH, VHD, VNL, VNM, and VT models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch from automatically disengaging when the brake is applied.

Risk

Without a signal to disengage the clutch when the brakes are applied, the distance required to stop the truck may lengthen, increasing the risk of a crash.

Remedy

Volvo Trucks will notify owners and dealers will inspect and repair the vehicles if necessary. The recall began on August 26, 2013. Volvo's recall number is RVXX1303. Owners may contact Volvo at 1‑336‑393‑2000.

Recall number 13V268000 · Recall details

What is wrong

Volvo Trucks North America (Volvo) is recalling certain model year 2011-2013 VHD and VNL vehicles manufactured December 13, 2010, through July 17, 2012. These vehicles are equipped with an MGM Type 24 J-series piston parking brake chamber. The brake chambers may leak pressure allowing the parking brake to drag when it is supposed to be released. Brake dragging could lead to overheated brake components.

Risk

Overheated brake components could result in a fire.

Remedy

Volvo will notify owners and the brake chambers will be replaced as needed, free of charge. The safety recall is expected to begin on, or before, June 17, 2013. Owners may contact Volvo at 1‑336‑393‑2000. Volvo’s campaign recall number is RVXX1302.

Recall number 13V152000 · Recall details

What is wrong

Volvo is recalling certain model year 2012-2014 VHD, VNL, and VNM trucks, manufactured from April 18, 2011, through March 14, 2013, and equipped with a horizontally mounted remote battery disconnect switch. The remote battery disconnect switch was manufactured with incorrect hardware allowing the cables to loosen. Additionally, as mounted, the cables may vibrate and chafe.

Risk

Loose or chafed cables may lead to overheating of the battery cable and switch which may result in a fire.

Remedy

Volvo will send owners an interim letter and dealers will replace and relocate the remote battery disconnect switch. The recall began on May 7, 2013. Owners may contact Volvo's recall support line at 1‑877‑800‑4945 and select option 1.

Recall number 13V102000 · Recall details

What is wrong

Volvo is recalling certain model year 2002-2013 VHD and VN trucks, manufactured from August 4, 2000, through June 22, 2012, and equipped with bench passenger seats. The seat belt d-ring weld may not be sufficient enough to meet the seat belt pull test. Therefore, these vehicles fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 210, "Seat Belt Assembly Anchorages."

Risk

In the event of a crash, an insufficient seat belt weld may prevent the seat belt from properly restraining the occupant. This increases the risk of injury to the seat occupant.

Remedy

Volvo Trucks of America will notify owners, and dealers will replace the suspected d-ring, free of change. The safety recall began on May 10, 2013. Owners may contact Volvo at 1‑336‑393‑2000.

Recall number 12V510000 · Recall details

On October 22, 2018, an Audit Query (AQ18-005) was opened to assess the completeness and timeliness of Volvo Group's early warning reporting, safety recalls, and communications submissions to the agency.the federal safety agency's investigation determined that Volvo Group failed to recall vehicles in a timely fashion and to comply with other recall and reporting requirements, including notifying owners of recalls and reporting death and injury incidents.the federal safety agency and Volvo Group entered into a Consent Order on January 27, 2023 to resolve AQ18-005.As part of the Consent Order, Volvo Group agreed to a total civil penalty of one-hundred and thirty million dollars ($130,000,000), of which, sixty-five million dollars ($65,000,000) was paid on February 21, 2023.Also, of that total civil penalty, Volvo Group agreed to spend twenty million dollars ($20,000,000) on the specific performance obligation to create a safety data analytics infrastructure to detect and study emerging safety-related defect trends on its vehicles. The Consent Order also holds forty-five million dollars ($45,000,000) of the civil penalty in abeyance pending Volvo Group's satisfactory completion of the requirements of this Consent Order, and its compliance with the Safety Act, and regulations thereunder.The Consent Order is for a three-year term and may be extended by up to two years if the federal safety agency reasonably finds that an extension is warranted.In the Consent Order, Volvo Group agreed to several performance obligations, including enhanced oversight of its compliance with the Safety Act and the terms of the Consent Order through a third-party auditor and regular meetings with the federal safety agency.The third-party auditor will recommend and oversee implementation of process improvements to enhance Volvo Group's safety compliance processes and oversee the company's review of past recalls and submissions to the federal safety agency for accuracy and completeness.Also, via the Consent Order, Volvo Group agreed to create updated written policies, procedures, and training to ensure that its employees understand the requirements of the Safety Act, the regulations thereunder, and this Consent Order.Volvo Group further agreed to launch a user interface on its websites to allow users to search vehicle identification numbers (VINs) for open recalls and implement a system to support the federal safety agency's VIN lookup tool.Based on the Consent Order, this audit query investigation, AQ18-005, is closed.Closure of this AQ has no bearing on the terms of the Consent Order, including Volvo Group's ongoing performance obligations or legal obligations, and does not represent a determination by the federal safety agency as to Volvo Group's performance under the Consent Order to date.

AQ18005

The Office of Defects Investigation (ODI) received Early Warning Reporting (EWR) data from the manufacturer that indicated some number of subject vehicles equipped with the subject automated manual transmission had allegedly experienced a condition where the clutch failed to automatically disengage the transmission from the engine as intended. This may result in extended stopping distances and/or unintended forward motion of a vehicle previously at rest.To date, ODI is aware of 134 subject vehicles with one or more complaints or field reports related to this condition.Also, ODI is aware of 164 subject vehicles with one or more warranty claims related to this condition.By letter dated June 25, 2013, Volvo Trucks North America (Volvo) notified ODI that it has initiated a safety recall (the federal safety agency Recall No. 13V268 and Volvo Recall No. RVXX1303) to address a safety defect in approximately 23,003 model year (MY) 2007 through 2014 Volvo VAH, VHD, VNL, VNM and VT model trucks. The affected vehicles were manufactured from December 20, 2006 through May 22, 2013 and were originally equipped with the subject automated manual transmissions.According to Volvo, reports of the subject transmission clutch mechanism failing to automatically disengage as intended are associated with the removal of a brake pedal micro switch that provided a redundant signal to the transmission control module indicating the brakes had been applied.Previously, Volvo had removed this brake pedal micro switch from new vehicle production and from certain vehicles already in-service via two field service campaigns (SP 432-024 and SP 432-026) because it decided the switch was unnecessary and/or a maintenance issue.In the absence of this redundant brake pedal micro switch, the clutch mechanism may fail to disengage the transmission from the engine at low vehicle speed should the stop lamp switch fail to send and/or the transmission control module fail to receive the primary signal.At the time of this closing, Volvo is evaluating available remedies and will provide the federal safety agency with details when the recall remedy procedure has been finalized.Volvo will notify affected owners by mail by August 25, 2013.Please see the federal safety agency Recall No. 13V268 for details.Accordingly, this investigation is closed.

PE13002