2001 Chevrolet C Series problems

What is wrong

Vehicle description: pickup and utility trucks. Some of these vehicles have an internal component in the outboard seat belt retractors for the 2nd and 3rd row of seats that could be cracked. With repeated actuation of the locking mechanism, the crack could spread to the point such that the seat belt would no longer lock.

Risk

In a crash, increased occupant injury could result from the no-lock condition.

Remedy

Dealers will inspect the outboard seat belts for specific lot numbers and replace the belts if necessary. Gm is enclosing an inspection procedure for the owners to use or they can have their dealers do the inspections. Owner notification began july 2, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1‑800‑222‑1020 or gmc at 1‑800‑462‑8782.

Recall number 01V159000 · Recall details

Gm is conducting a recall on all subject vehicles build between may 1999 and october 14, 1999.significant changes were incorporated into production in early october 1999, and vehicles built after that date have lower warranty failure rates.the complaint and warranty data appear to support the effectiveness of these changes. Gm made additional changes in november 1999, february 2000, may 2001, and february 2004.odi will continue to monitor this problem and will take further action, if warranted, in the future.for further technical details see the attached engineering analysis report.

EA04012

In a letter dated april 20, 2005, gm notified the federal safety agency that it had decided that defects that relate to motor vehicle safety exist in certain model year (my) 1999-2002 c/k 1500 series (pbr parking brake system) and my 2001-2005 c/k 2500 and 3500 series (trw parking brake system) pickups with manual transmissions.according to gm, some of these vehicles may have conditions that cause the friction linings to wear to an extent where the parking brake can become ineffective in immobilizing a parked vehicle.gm's action covers an estimated total of 142,585 vehicles.dealers will install a low-force spring clip retainer for vehicles equipped with the pbr parking brake system and install a redesigned parking brake cable assembly on vehicles equipped with the trw parking brake system. A total of 58 non-duplicative complaints were received by odi and gm concerning the approximately 59,000 my 1999-2002 c/k 1500 series pickup trucks with the pbr parking brake system.these included 22 alleged rollaway incidents, resulting in a rate of 38.5 rollaway incidents per 100,000 vehicles.odi is aware of 24 complaints regarding the my 2001-2005 c/k 2500 and 3500 series manual transmission trucks recalled by gm, including 5 alleging rollaway incidents.though the conditions described in gm's letter are also present in the c/k trucks with automatic transmissions, the rollaway rate in those vehicles was similar to those observed in peer vehicles studied by odi in this investigation.this engineering analysis is closed. For additional information, see the attached closing report.

EA04011

Odi opened pe03-057 to assess parking brake ineffectiveness in the subject vehicles.these vehicles are equipped with four wheel disc brakes that incorporate a single-shoe drum-in-hat parking brake independent of the service brakes.complaint and warranty data indicate that the parking brake linings tend to wear out early in the life of the vehicle (at an average of 24 months in service), reducing the parking brake system's torque below that needed to immobilize the vehicle.gm has attributed this accelerated wear to foreign material intrusion and a failure of the brake shoe to properly self-center within its brake drum.effective with the start of my 2003 production, a newer reduced force hold-down clip was introduced to facilitate brake shoe disengagement from the drum surface.this part is also available at the service level for the my 1999-2002 vehicles.gm has indicated that the paking brake is intended to operate in conjunction with the transmission to immobilze parked vehicles, and that in many cases, accelerated parking brake lining wear is caused by rough use, vehicle modifications, and driving with the parking engaged. Odi has upgraded the preliminary evaluation to an engineering analysis to gather further information concerning parking brake usage factors and the circumstances surrounding the seventeen reported vehicle crashes.

PE03057