2006 Chevrolet Impala: ball joint or control arm failure

Filed Oct 20, 2013 · Steering · 125,000 miles · IL

I was getting off the expressway when I just all of a sudden feel a shaking coming from the steering wheel I noticed the service traction control was on so I pulled over that's when it shut down on me. I then got the wheel hubs and ball joints changed because I thought that was the problem but it was not so my mechanic reset the vehicle went off for a day then came back on.

Filed May 22, 2013 · Engine, Lights · CA

2006 chevrolet impala. Consumer writes in regards to transmission problems. *smd the consumer stated the transmission was slipping. She explained to the dealer, there was a recurring problem with the transmission. Each time, the consumer went to the dealer, she was informed they could not recreate the problem, and therefore no problem existed. Besides the transmission problem, there was a horrible ratcheting machine-gun type noise coming from behind the dash, when she changed the vent position. The loud noise lasted for about a minute and was almost ear-piercing. Also, the engine mount broke, the water pump, steering and tie rods failed, the engine burned excessive amount of oil, and the engine low oil light illuminated. The windows made a screeching sound, the sunroof would drag, the plastic headlight covered were fogged and faded. The tire pressure monitoring light was constantly on. On april 24, 2013. The consumer took the vehicle to an independent transmission shop to have them assess the same transmission slipping problem, she had been experiencing for seven years. They dropped the transmission pan, and they found fine metal, pieces of aluminum and clutch material in the pan.

Filed Jul 27, 2011 · Steering, Suspension · 4,000 miles · GA

Currently I have 29103 miles on it.I had took it in shop 2 times complaining about problem w/steering ,and was told this was normal.I knew different.now the warranty ran out the passenger side tie rod end was completely worn out,and the drivers side is bad also.I've contacted cheverolet and they said to take it to dealer and pay of course for them to tell me a third time probably that this is normal.I am scared of this car,but have no choice except to drive it .I beleive this car slip thru factury inspections . As also rotors was turn at about 4000 miles and again at 26000 miles.

Filed Jul 5, 2011 · Steering · 6,000 miles · MI

Tl* the contact owns a 2006 chevrolet impala. The contact stated that the vehicle was taken to an authorized dealer or independent repair shop on three occasions to have the tires replaced due to excessive tread wear. The contact stated that the tires were wearing excessively due to defective tie rods. The vehicle was not taken to have the tie rods repaired. The failure mileage was 6,000 and the current mileage was 31,000.

Filed Feb 11, 2009 · Brakes, Suspension · 69,615 miles · MO

I have a 2006 chevrolet impala which required the front brakes to have the rotors machined and replaced 3 times in the first 33,000 miles. I was told that this was caused by the use of inferior metal for the rotors which could not withstand the heat generated by braking, especially when exiting from a highway. Additionally, the front outer tie rods required replacement in the first 65,000 miles of driving because they had become worn out which caused the front tires to be loose or "wobbly."

Filed Jan 16, 2009 · Steering, Suspension · 64,000 miles · MI

First the wheel had a shimmy in it. The rotors were replaced and new brakes. That wasn't it . It was the front ball joint. 2. Car wouldn't heat up. Radiator cap replaced at dealer for 45 dollars. Rear defogger quit working. 4. Power steering out now and it feels like the rack and pinion going to fail. Car no longer under warranty now with 64k. I am tired of this lemon.

Filed Jan 13, 2009 · Steering · 45,000 miles · VA

I own a 2006 chevrolet impala ls with 45,500 miles on it. In december 2008, I experienced wobbling in my front left tire. The outer tie rod was broken and had to be replaced. The tires were severely and unevenly worn, requiring a new set of tires due to bad alignment, and now I am hearing and feeling vibrations and clunking in the steering column. A google search revealed dozens of similar and recurrent steering column and alignment problems and complaints with both the 2006 and 2007 chevrolet impala. The replacement of the steering column is only a temporary fix. It comes back. I did not purchase an extended warranty, but gm does not regard this as being covered in the extended warranty outside of 36,000, anyway. Several have complained of steering failures and lock-ups which resulted in both injuries as well as damage to property and other vehicles. This is clearly a problem that can have fatal results if not corrected. Consumers should not have to pay to correct this problem. Replacement of the steering column would incur an out-of-pocket cost exceeding $1,000. Please issue a recall, if not for me, then for the people for whom the problem has not begun to occur and spare them injury and/or death.

Filed Nov 17, 2008 · Engine, Steering · 43,500 miles · OH

I have a 2006 ss impala I've had nothing but on going problems. 1st waterpump went out then 2nd driver tie rod was replaced 3rd powersteering hose replaced 4th battery went dead 5th power steering hose out again and tie rod on passenger needs replaced also. I'm so fed up with this car and its problems!these have been on going problems since 2006.

Filed Nov 23, 2007 · Steering · 37,500 miles · KY

I noticed the front right tire was wearing extensively on the outside. First I checked the tire pressure and it was at the proper amount. Then I went to have the tires rotated and was told to have the alignment check by the tire serviceman. Then I went to have the tires aligned and the technician said the tie rod ends had to be replaced because they were worn out and loose. I personally observed the front wheels and they both were extreme loose. The car has been regularly serviced by the chevrolet local dealer and only had 37,500 miles on it. I had it serviced at approximately 35,500 miles by the chevrolet dealer. I took the car to the chevrolet dealer, who agreed that both the tie rods ends needed replacing and that he thought they could be replaced with chevrolet paying for them. Both the alignment technician and the chevrolet dealer service person told me that the reason the tie rod ends were worn out was that they contained no grease fittings and further that the ones chevrolet finally replaced the worn out ones they do not have grease fittings. This car is a 2006 chevrolet impla. I still am going to have to replace what was the front tire(s) before this discover due to this manufacturing defect. Further,I am expecting to have to replace the current new ones which have no grease fittings within 30,000 or again risk my safety and excessive and unnecessary tire wear. I am told by service people and technicians that I can purchase aftermarket (non-general motors tie rod ends) that would have grease fittings. This lack of grease fittings is obviously a very serious manufacturing defect, that endangers the lives of hundreds of thousands of chevrolet impala owners and their passengers and others on the roads. I am concerned about this what appears to me to be a manufacturing defect.

Filed Sep 27, 2007 · Steering · 15,000 miles · WI

Tl*the contact owns a 2006 chevrolet impala. The contact stated that the outer tie rod end was defective on both the driver and passenger side tires. While driving 55-60 MPH, the entire vehicle fluttered and shook when the steering wheel was turned. The dealer replaced the tie rods and there had been no further occurrences. The current and failure mileages were 15,000. Updated 11/07/07.