Owner claims that when he applies the brakes they slip before stopping the truck fully.
1995 Chevrolet S10 brakes complaints
Page 8 of 12: complaints 191 to 220 of 320, newest first, as owners wrote them.
Steering wheel out of alignment, causing vehicle to pull.
Vehicle is very slow in stopping. Abs brakes kick in at very low mileage. Braking, is especilly, horrible in bad weather.
Abs brakes system failed
Quickly depressed the brake pedal to make a sudden stop, nothing happened, pedal went to the floor. Quickly depressed the brakes again, and sometimes the brakes caught and sometimes they did not. This has occurred six times. *ak
Abs brakes system failed. Consumer unhooked fuse to ABS system and now brakes work ok.
Driving about 20-25mph & would start to apply brakes, left front would lock up, but other wheels would not catch/lock up. Vehicle would go into a slide when weather is wet; does not happen when dry weather. The dealer said brakes working fine after putting vehicle on computer.
While traveling, a pedestrian on a bike ran in front of the vehicle, consumer tried to stop the vehical by pressing the brake pedal, pedal traveled to the floor board and the vehical continued to move, hitting the pedestrian.
Whiile driving the car and when trying to slow down or stop the car brakes don't respond at all. Consumer has to wait for the truck to come to a complete stop.
Anti-lock brakes: when driving and attempting to apply the brakes the brake pedal freezes int the upward position. Vehicle continues to move with no brakes, no movement in the pedal while the vehicle travels 2to 3 hundred feet with no brakes. This is an intermittent problem. Dealer could not duplicate because there was no warning lights on. Second time ABS light were on, and they still could not detect the problem.
While attempting to apply the brakes in an emergency situation, brakes failed, vehicle skidded and rearended the vehicle in front. No deployment of driver's air bag, resulting in an injury.
When appyling the ABS brakes in normal conditions the vehicle will proceed to slow down, but not come to a complete stop which nearly caused an collision dealer checked the computer system, but cannot identify any problem. Please give any further details.
In damp/rainy weather the brakes tend to un expectedly to lock up when the slighttest amount of pressure is applied to the brake pedal.
Brakes fail on gravel, snow and ice.
Antilock system failed.
Brake failed on slippery wet pavement causing driver to crash.
Anti lock brakes failed.
When applying the ABS brakes, the pedal went to the floor and the brakes failed to stop the vehicle, causing an accident in which the driver's air bag did not deploy in a frontal impact at 30 to 35mph.
Driving vehicle 40 MPH; went to apply brakes (ABS), vehicle did not stop. Kept applying pressure on brakes, was not slowing down. Took to dealer & could not find problem after puttihg on computer & took for test drive.
Driving vehicle about 35mph went to apply brakes and brakes failed to catch properly. Would have to stand on pedal & nothing happens, ABS will not kick in. Took to dealer & they could not locate problem in order to repair it.
Applied the ABS and the brakes did not take, causing front end crash at 30 MPH and the air bags did not deploy.
Power assisted brakes failed, causing extended stopping distance.
Brakes: premature wear of the outside disc brake pads. Wear indicator installed on inside pads; but outside wore out before installing wear indicators. Dealer and manufacturer indicated that this was normal.
During hard braking (non-panic) at approx. 60mph, experienced pulling to extreme right due to left front caliper sticking. Dealer lubircated caliper slide points to correct problem. Also, on wet pavement experienced caliper sticking at approximately 35mph, duringnormal stopping, ABS kicked in, took longer to stop, ABS light appeared, brake action seemed inadequate to effectively stop in straight line in a timely manner.
Excessive wear of right passenger's side brake calipers/shoes and pads, consumer also noticed excessive dust on the rims of the wheels. Ea94-038.
Owner has ABS brakes; brake pads wear down excessively and there maybe a problem , owner is concerned about this problem.
The front disc brake rotors are rusted and the vehicle has no braking power.
Consumer needs to replace the brake shoes and pads on the front of the vehicle. The right brake pad is worn more then the left side. Consumer contacted the dealer, the dealer stated it was normal operation.
When applying the ABS brakes in a sudden stop, the brakes failed to stop the vehicle, causing a collision.
When applying brakes, experienced hard or soft pedal, pedal sometimes goes to floor, squeaking noise, pulls to right or left, extended stopping distance; dealer reproduced problem, replaced ABS box, master cylinder, speed sensor and brake pads.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Chevrolet S10?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history