Tl* the contact owns a 1995 chevrolet s10. While driving 25 MPH, the brakes failed to respond and the vehicle crashed into a tree. The anti lock brake system warning light illuminated prior to the failure and the air bags failed to deploy. A police report was filed. There were no injuries. The vehicle was towed to an independent mechanic. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was 69,000. Updated 07/28/16
1995 Chevrolet S10 brakes problems
320 complaints (35% of all complaints for this car). Typical mileage when it fails: 112,000. 71 crashes reported.
- owner complaints
- 320
- of this car's complaints
- 35%
- typical mileage
- 112,000
- crashes
- 71
- recalls
- 1
Which part fails
- Antilock/traction control/electronic limited slip232
- Foundation components25
- Foundation components: disc: pads21
- Antilock13
- Foundation components: master cylinder8
- Foundation components: disc: rotor7
- Foundation components: drum6
- Power assist5
At what mileage
Complaints by mileage at the time of the problem.
Chevrolet S10 brakes problems in other years
Specific symptoms reported on the 1995 Chevrolet S10 brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
ABS 135Brake failure 95Premature wear 6Grinding brakes 5Spongy pedal 5
Related recalls
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive can malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
- Risk
- If this occurred at a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
- Remedy
- Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Recall number 99V193000 · Recall details
Related investigations
Loss of power assist
There is no summary currently available
EA00008
Abs braking system
This investigation resulted in a safety recall, 99v‑193, and a service campaign, 99i-006.
EA94038
What 1995 Chevrolet S10 owners say
Most recent owner complaints, unedited.
Tl* the contact owns a 1995 chevrolet s10. While driving at approximately 15 to 20 MPH, the contact depressed the brake pedal but to no avail. The brakes would not engage and the contact depressed the brake pedal several times before the vehicle came to a stop. The contact stated the failure would occur intermittently on several occasions. The vehicle had not yet been taken to the dealer to be diagnosed. The manufacturer was not contacted. The failure mileage was 170,000 and the current mileage was 190,000.
While braking the brakes of the consumer's 1995 chevrolet s10 locked up and caused the vehicle to slide into a steel post. The consumer had no control over the vehicle. *nm the consumer sustained a concussion as a result of the accident. The vehicle was taken to the dealer who informed the consumer that the brakes were functioning as they should.
When depressing the brake pedal vehicle did not stop at the desired stopping point. Vehicle was taken to a repair shop, where no problems were found with the brakes. Consumer found recall 99i006000 for this make, model, and year concerning ABS brake failure. *ak brakes failed in 5 different occasions in a month.
While braking ABS failed, causing extended stopping distance. Dealership was notified, but did not resolve the problem.
I own a 1995 chevrolet s10 2wd pickup truck. I have experienced several occasions where my antilock brakes have failed to stop me in a reasonable distance. I have not yet recieved a notice from the manufacturer so I was wondering what I should do. Thank you.
I had been noticing my brakes felt soft I called the dealer, and they said there were no problems, then last week my wife was driving it and the brakes failed and she was in a bad wreck and the air bags did not deploy.
We are the owners of a 1995 chevy s10 ls VIN number [xxx]. We have had several minor problems and a few major problems with the truck in the three years of ownership. The most recent problem is serious and caused a potentially fatal situation, all which have made us unhappy with the truck. I approached a stoplight, where other vehicles were stopped and I proceeded to slow down. That's when I noticed that my brakes were not responding and that my vehicle was not slowing down. I continued to apply the brake in disbelief but still my truck careened on. This all occurred in less than 5 seconds. Before I knew it I was given a choice of either slamming my truck into the car in front of me at 40mph, or taking my chances on the sidewalk, that to my blessing was empty. Desperately, I veered my truck to the right over the sidewalk, over block barriers onto a parking lot praying that the impact would slow my truck down. My truck finally rolled to a stop. Upon inspection of the truck, it turns out that the brakes failed because a plastic part that connects a vacuum line to the brake booster broke. I am shocked and outraged that something like this could happen. If this part fails at any time, there are no power brakes to slow the vehicle. According to the owner''s manual, the part in question never needs servicing and has no replacement interval. What even scarier is that we have had our brakes serviced twice in the past two years. Question to gm and other why did this part break? What could we have done to prevent this incident? Have there been similar incidents of this nature with other gm trucks? Is this a recall item? Over the course of owning our gm truck we have had other mechanical failures, the first was when the inside rear view mirror fell to the floor and now this''brake failure. We have become more and more dissatisfied with this gm truck. It has proven to be unreliable and unsafe. Information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).
Failure #1-rear brakes would lock when stopping. This would activate the rear antilock brake system and result in extra long stopping. Failure #2-the air vacuum hose that controls the position of the vents (ie heater or vent or defrost) melted and control of the defrost was lost. Windshield frosted over and reduced vision through windshield resulting in dangerous condition. Dt
Consumer states that when trying to apply the brakes the brake pedal will go to the floor causing the vehicle to have extended stopping distance. Dealer notified mr
Questions about the 1995 Chevrolet S10 brakes
Does the 1995 Chevrolet S10 have brakes problems?
Owners have filed 320 complaints about the brakes of the 1995 Chevrolet S10, 35% of all its complaints, more than any other problem.
At what mileage do 1995 Chevrolet S10 brakes problems start?
The typical (median) mileage in owner complaints is 112,000 miles.
Was there a recall on the 1995 Chevrolet S10 brakes?
Yes, 1 recall: 99V193000. Check your VIN to see if your car still needs the free repair.
What year does the Chevrolet S10 have bad brakes?
The Chevrolet S10 model years with the most brakes complaints are 1994 (532 complaints), 1995 (320 complaints) and 1996 (219 complaints).
Other 1995 Chevrolet S10 problems
Visibility 207Airbags 111Engine 82Transmission 50Fuel system 37Seats 34Acceleration 29Suspension 25Electrical 24Seat belts 22Steering 21Body 15Tires 15Lights 13Locks 6Wheels 3
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Chevrolet S10?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history