Check a VIN

Chrysler 200 stalling problems

872 of the 4,191 owner complaints about the Chrysler 200 describe engine stalls while driving, most of them for the 2015 model year.

owner complaints
872
worst model year
2015
typical repair cost reported
$900
typical mileage
50,000
Is there a fix? There are 2 recalls for this area of the car. See below

By model year

Often reported together

Check engine light 127Jerking 67Loss of power 54Won't start 49Airbag light 34Hesitation 32Power steering loss 23Engine failure 19

Trouble codes mentioned

P2172 4U1504 1U1424 1U0121 1U0100 1U0018 1U0001 1P2311 1P2308 1P2305 1

What owners say

Filed Sep 12, 2026 · Electrical, Engine · OH

Formal Customer Complaint request for manufacturer assistance. Vehicle, 2011 Chrysler200 Touring, VIN [XXX], engine3.6L V6. I am the current owner and I'm requesting Chrysler open a case to review intermittent stalling, starting and electrical problems and an HVAC defrost actuator that repeatedly cycles and fails calibration, raising a concern about windshield defrost visibility. I've replaced parts and done diagnostics, but problems persist. I request that Chrysler investigate, review the VIN history, check applicable recalls, and consider goodwill assistance for diagnosis and repair if a manufacturer defect is found. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Sep 4, 2026 · Airbags, Electrical · NJ

Electricity light came on as well as overheating light and engine light all at once also stalling

Filed Aug 30, 2026 · AZ

Vehicle does shift to p then desired gear. It stalls at traffic stop lights. Very dangerous. I do not know what the issue is.i got home to test the issue while in drive with brake pushed down as if I were in idle, at a stop light, and it did the same thing in the video.

Filed Mar 30, 2026 · Body, Electrical · TX

I am reporting multiple safety-related issues involving my 2016 Chrysler 200 S. On 02/06/2024, after an oil change at a dealership, the underbody skid plate bolts were not reinstalled. While driving, the skid plate fell and I lost control of the vehicle, creating a serious safety hazard. No warning indicators were present prior to this failure. The issue was identified immediately after leaving the dealership and is not properly documented in service records. In July 2022, following a battery replacement by the same dealership, the vehicle repeatedly lost power and stalled, leaving me stranded multiple times. I paid for diagnostic testing, but there is no documentation confirming proper diagnosis or repair. I was later advised incorrect hardware had been installed. On 02/27/2026, I was told the check engine light was on and diagnostic codes were cleared without repair. There is no documentation of the codes or repairs performed. I was also informed on 11/19/2022 that parts were ordered for a safety recall. From that date until 02/27/2026, I was repeatedly told parts were unavailable. I scheduled repair and dropped off the vehicle on 03/13/2026. I received notice that repair had begun, but later discovered the vehicle had not been serviced at all. No explanation was provided. Additionally, service records are inaccurate. A vehicle history report shows service on 03/17/2026 at a dealership I have never visited. The vehicle was not serviced anywhere on that date. These issues involve loss of control, repeated stalling, improper repairs, failure to complete a recall, and inaccurate reporting. Documentation is incomplete or missing. Supporting documents are available.

Filed Feb 11, 2026 · Electrical · 70,000 miles · TX

The contact owns a 2015 Chrysler 200. The contact stated that while driving on several occasions at various speeds, the vehicle stalled. The power steering and battery warning lights were illuminated. The vehicle was restarted each time, but the vehicle took a progressively longer time to restart. Eventually, the vehicle failed to restart and was towed to an independent mechanic, where it was diagnosed and determined that the battery needed to be replaced. The vehicle was repaired, but the failure returned five minutes after driving off the lot. The vehicle was taken back, and it was determined that the wiring and electrical system had a communication fault, and that the vehicle needed to be taken to a dealer to be reprogrammed. The vehicle was towed to a dealer, where it was diagnosed, and it was determined that the battery cable and harness needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 70,000.

Filed Jan 29, 2026 · Electrical, Transmission · IN

You have a recall for chryslr 200 2015 for intermittent starting and stalling caused by faulty PDC connector. the federal safety agency. My car is doing exactly that but its not under the recall why not? It had done this gor the last 4 months

Filed Dec 13, 2025 · Acceleration, Electrical · TX

While driving at approximately 60 MPH on a highway, the vehicle suddenly lost motive power, stalled, and entered "limp mode," shifting into neutral or a low gear unexpectedly. This failure caused a rapid deceleration in high-speed traffic, effectively disabling the vehicle and creating an immediate safety hazard and risk of collision. The engine stalled completely, requiring the vehicle to be coasted to the emergency shoulder. After a key cycle, the vehicle restarted but the check engine light remained illuminated. Independent diagnostic scanning retrieved Diagnostic Trouble Codes (DTC) U0018 (Medium Speed CAN Communication Bus Short) and P0894 (Transmission Component Slipping). These specific codes and symptoms (intermittent electrical short causing stall/shift-to-neutral) are identical to the safety defects addressed in the federal safety agency Recall 15V‑470 (FCA Recall R24 - Power Distribution Center Electrical Connector) and the federal safety agency 16V‑529 (FCA Recall S55 - Transaxle Wiring Harness). Although records indicate Recall R24 was marked as "completed" on this vehicle in July 2015, the specific safety defect has recurred, presenting the exact same failure mode. The Authorized Dealer was contacted regarding the recurrence of this safety defect but refused to perform a no-charge inspection, citing an expired repair warranty. The Manufacturer (FCA US LLC) was also contacted to report the recurring safety failure but refused to open a case or authorize a diagnostic inspection, despite the life-threatening nature of the defect. The component and vehicle are available for inspection. The failure has not been resolved.

Filed Oct 20, 2025 · Engine · 127,000 miles · AZ

The contact called on behalf of the owner of a 2015 Chrysler 200. The contact stated that the owner received notification of Manufacturer Recall Numbers: U90 and W84. The contact stated that while driving 25 MPH, the vehicle failed to accelerate as intended while depressing the accelerator pedal. The vehicle stalled, and the contact pulled over to the side of the road. The dealer was contacted. The vehicle was left on the side of the road. However, the dealer refused to schedule an appointment to repair the vehicle. The manufacturer was not made aware of the issue. The failure mileage was approximately 127,000.

Filed Sep 12, 2025 · Engine · MD

The engine stalls abruptly while driving. At the time of this writing, it has luckily stopped when the car was at lower speeds like taking a turn, in a school pickup line, idling at the traffic light. The dashboard does not flash any warning lights and the engine just shuts off abruptly. We then switch the transmission back into parking, switch the A/C off and then start the car by turning the key as usual - it starts very fine and in the first go. This has been happening since last 2 months, upon servicing the car last month the service center noted that lower A/C freon levels were causing massive strain on the A/C compressor forwarding an excessive load to the engine causing stalling to occur. However, even after restoring the freon levels the engine stalling issue still persist. A second round of extensive day-long diagnostics run by the same service station this month did not reveal any problem or root causes and we were left with no resolution. This creates a critical safety hazard for our family and general public.

Filed Aug 5, 2025 · Electrical, Engine · FL

I started having the oil pressure warning light come on same day after an oil change. It was a 3-hour drive, and the light will come on while my foot is on the break. Oil level was in the safe marker. Then I started feeling rumbling like I was driving a stick shift car. One major incident I was waiting for my turn at a light and when it turned green, the car was stalling but went. All of sudden it stopped and cut off and wouldn't crank back up. When it did the light was red and cars were going around me. It was running hot but started back up for me to drive home. But it I stopped it shuts off. The inside lights do a weird thing like comes on randomly while driving and it's scary at night. Also, if using the left turn signal the lights comes on. But when the car is off the radio and other controls go bright then dim. When put on a code reader many codes come up P0506, P0137, P0171, P0131, P0302

Related recalls

EngineReported November 6, 2013 · 521 vehicles affected
What is wrong
Chrysler Group LLC (Chrysler) is recalling certain model year 2013 Dodge Avenger and Chrysler 200, and model year 2014 Jeep Compass and Patriot vehicles equipped with 2.4L engines. Due to abrasive debris in the balance shaft bearings, these engines may have a loss of engine oil pressure, possibly resulting in an engine stall or engine failure.
Risk
If the engine stalls while driving it may increase the risk of a crash.
Remedy
Chrysler will notify owners, and dealers will replace the engine balance shaft module, free of charge. The recall began on December 24, 2013. Owners may contact Chrysler at 1‑800‑247‑9753. Chrysler's recall campaign number is N52.

Recall number 13V552000 · Recall details

Engine and engine coolingReported September 29, 2011 · 667 vehicles affected
What is wrong
Chrysler is recalling certain model year 2012 chrysler vehicles, including 200 and town and country models, dodge vehicles, including charger, durango, grand caravan and journey models and jeep grand cherokee vehicles manufactured from august 31, 2011, through september 13, 2011, that are equipped with 3.6l engines. These engines may experience connecting rod bearing failure due to debris inside the engine block.
Risk
Connecting rod failure may lead to engine seizure which may increase the risk of a crash.
Remedy
Chrysler will notify owners and replace the engine free of charge. The safety recall is expected to begin on or about november 18, 2011. Owners may contact chrysler at 1‑800‑853‑1403.

Recall number 11V487000 · Recall details

Questions about the Chrysler 200 stalling

Which Chrysler 200 years have engine stalls while driving problems?

The model years with the most reports are 2015 (487 complaints), 2013 (104 complaints) and 2012 (98 complaints).

How much does it cost to fix engine stalls while driving on the Chrysler 200?

Owners who mentioned a price put the repair at about $900 (median of 15 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.

VIN decoder

See the problems and recalls for an exact car

Buying a used Chrysler 200?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history