The contact owns a 2016 Chrysler Town & Country. The contact stated while driving 30 MPH or more, the transmission jerked before shifting gear. Additionally, while driving 35 - 40 MPH, there was a grinding metal sound coming from underneath the vehicle. While driving 30 MPH, the vehicle vibrated abnormally, without warning. The contact stated that the failure was intermittent. There were no warning lights illuminated. The vehicle was taken to the dealer who diagnosed the vehicle with transmission failure. The contact was informed that the transmission needed to be replaced. The dealer confirmed that the VIN was not included in the federal safety agency Campaign Number: 16V461000 (Power Train). The vehicle was not repaired. The manufacturer was informed of the failure. The manufacturer referred the contact to the federal safety agency Hotline to report the failure. The failure mileage was 198,000.
Chrysler Town and Country grinding brakes problems
218 of the 13,494 owner complaints about the Chrysler Town and Country describe grinding or squealing brakes, most of them for the 2008 model year.
- owner complaints
- 218
- worst model year
- 2008
- typical repair cost reported
- $413
- typical mileage
- 28,000
By model year
Often reported together
Premature wear 13Whining noise 9Check engine light 9Brake failure 8ABS 8Transmission failure 7Fire or smoke 7Door locks 6
What owners say
The contact owns a 2011 Chrysler Town and Country. The contact stated that while her husband was driving at an undisclosed speed, the window glass fell into the door abruptly. A mechanic inspected the vehicle and determined that the failure occurred due to an internal door fracture. The vehicle was not repaired. The contact stated while driving and turning the steering wheel, the steering wheel made an abnormally loud squealing sound. Additionally, the contact stated that the vehicle had difficulty starting, and there was an abnormal amount of smoke coming out of the exhaust pipe. The check engine warning light and the electronic throttle control warning light were illuminated. An unknown dealer was notified of the failure. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 174,098.
The contact owns a 2013 Chrysler Town & Country. The contact stated that while starting the vehicle, the "Accessory On" light illuminated, and the starter made an abnormal grinding sound. The contact stated that several attempts were needed to start the vehicle. The contact stated that the failure occurred several times per week and several times during the same day. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 144,000.
The van began making a squeal noise and the RPMs fluctuating then the check engine light came, I got it scanned the code was for low transmission pressure, This vehicle has less then 100,000 miles on it. The vehicle was inspected by two different repair shops.
My check engine light is on and I get a squeaky noise when driving
Cylinder 3 missfire Loss of hydraulic pump prime. Line pressure low. LC pressure switch rationality. Yes it's available for inspection. Unknown if reproduced by dealer or other Unknown if inspected by manufacturer or other. The check engine light came on a little after 90k miles, at which time it was out of warranty, the mechanic said it had a weak cylinder and the motor needed to be replaced or rebuilt, but it was still drivable. The van would start shaking and loses power under moderate acceleration (like getting on interstate) and begin dinging but eventually gain power back. Around 119k miles, the van made a loud Squealing sound and started loosing speed very quickly in the middle of traffic. I put the car in park and back in drive to see if I could get it out of the road. It then started to roll backwards I barely pushed the gas and it revved up to 6000 RPM and then jerked and quickly accelerated forward. If a car would have been close enough I would have hit them while rolling backwards and when it accelerated forward. Upon inspection, the faults listed above came up. The van is no longer drivable but still starts.
The contact owns a 2016 Chrysler Town and Country. The contact stated that while driving at various speeds, the vehicle would hesitate while in first gear before jumping into the next gear without warning. In addition, the contact also stated that an abnormal grinding sound would emit from the vehicle without warning. The contact took the vehicle to an independent mechanic who informed him that the transaxle oil pump was defective and needed to be replaced. The contact was then notified of the federal safety agency Campaign Number: 16V461000 (Power Train) which the mechanic linked to the failure. The manufacturer was notified of the failure and informed him that the vehicle was not included in the recall. The vehicle had yet to be repaired. The failure mileage was approximately 118,000.
Passenger side sliding door makes a loud grinding sound when shut. Often times the door won't shut completely. Other times it will not open (i.e. it's stuck shut). In either case it is not safe for the passengers. They could either fall out because the door isn't shut while the vehicle is in operation. They could also need to exit the vehicle quickly due to an accident, but be stuck because the door won't open. This issue has been occurring for at least 4 years. I've been waiting for the manufacture to issue a recall to fix it because my understanding is it is very expensive to fix but am taking it into the dealership next month to get it looked at.
The contact owns a 2016 Chrysler Town & Country. The contact stated that the rear passenger’s side sliding door would not open and the rear driver’s side sliding door was making a grinding sound. The vehicle was taken to the dealer and diagnosed with door axle failure. The vehicle was not repaired. The manufacturer was made aware of the failure and informed the contact there was no recall associated with the VIN. The failure mileage was approximately 115,500.
I have a 2016 chrysler town and country with 89,000 miles. My sliding driver side door won't unlock or open. Was able to get door unlocked, but had to pull the plug to disable the locking motor to stop the loud gear grinding sound every time the electric door lock would engage. Did not want the door lock to be in the locked position if or when the gears would possibly grind down to nothing. Can only manually open and close the door and manually lock and unlock it also. All other electrical functions like power windows, power open/close function, and latch assist no longer work due to disconnecting the power supply at the bottom of the door. The vehicle was stationary in the garage when the problem was discovered. It was two months before I got the door unlocked and able to open from info on the internet.
Related recalls
Service brakes, hydraulic
- What is wrong
- Eldorado national is recalling model year 2008-2009 amerivan mobility vehicles built on chrysler town & country and dodge grand caravan platforms vehicles. The rear brake lines may have been improperly routed and not secured properly during the alteration. If not routed and secured properly, the brake lines could rub against the vehicle causing a brake fluid leak.
- Risk
- A brake fluid leak could result in a loss of braking ability, possibly causing a crash.
- Remedy
- Eldorado national amerivan dealers will inspect the vehicles and if the brake lines were improperly routed they will be correctly reinstalled free of charge. The safety recall began on october 13, 2009. Owners may contact eldorado national at 1‑800‑955‑9086. These minivans have been altered into wheelchair accessible vehicles by eldorado. This recall is not being conducted by chrysler group llc and will not be performed at no cost by dodge or chrysler dealers unless they are also an eldorado national dealer.
Recall number 09V351000 · Recall details
Service brakes, hydraulic: foundation components: master cylinder
- What is wrong
- The master cylinder rear seal, between the hydraulic fluid and the vacuum reservoir, may not seal adequately allowing hydraulic fluid to be drawn into the power assist vacuum reservoir.
- Risk
- As the hydraulic fluid in the master cylinder reservoir decreases, the level sensor will detect the loss of fluid and illuminate the instrument panel brake warning lamp. Continued operation of the vehicle with the warning lamp illuminated can result in extended stopping distances.
- Remedy
- Dealers will replace the brake master cylinder on all affected vehicles. Addendum (4-14-97): vehicles inspected per chrysler recall no. 707 and found to be outside the listed suspect master cylinder date code range, must now have the master cylinder primary piston replaced (chrysler recall no. 714).
Recall number 96V215000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- The ABS hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.
- Risk
- If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
- Remedy
- Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
Recall number 96V099000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The anti-lock brake system high pressure pump may be porous which will result in brake fluid leakage.
- Risk
- Fluid leakage eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
- Remedy
- Replace the ABS high pressure pump and high pressure hose if the last six digits of the bar code label on the pump are between 052300 and 059262.
Recall number 92V030000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
- Risk
- Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
- Remedy
- Replace the ABS high pressure hose with a hose of different design and construction.
Recall number 91V191000 · Recall details
Questions about the Chrysler Town and Country grinding brakes
Which Chrysler Town and Country years have grinding or squealing brakes problems?
The model years with the most reports are 2008 (64 complaints), 2005 (29 complaints) and 2002 (15 complaints).
How much does it cost to fix grinding or squealing brakes on the Chrysler Town and Country?
Owners who mentioned a price put the repair at about $413 (median of 30 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Chrysler Town and Country?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history