Chrysler Town and Country abs comes on

Filed Apr 30, 2026 · Brakes, Engine · 125,002 miles · NY

The contact owns a 2016 Chrysler Town and Country. The contact stated that while the vehicle was in reverse(R), the vehicle stalled, and the power steering became inoperable. Additionally, the failure recurred while making right or left turns at various speeds. The contact depressed the brake pedal, shifted to park(P) and restarted the vehicle after each failure. The failure recurred intermittently. The check engine, power steering, and the ABS warning lights and other unknown warning lights were illuminated. While researching on the website, the contact associated the failure with the federal safety agency Campaign Number: 16V461000 (Power Train). The dealer was contacted and confirmed that the VIN was not included in the recall. The dealer referred the contact to the federal safety agency Hotline to report the failure. The vehicle was not diagnosed or repaired. The manufacturer was informed of the failure. The failure mileage was approximately 125,002.

Filed Sep 4, 2025 · Brakes · 86,000 miles · TX

The contact owns a 2011 Chrysler Town and Country. The contact stated that while attempting to start the vehicle, the ABS module and Service Brake warning lights illuminated. The contact stated that the gear shift indicator also failed to operate as needed. A dealer was contacted. The vehicle was taken to a dealer, where it was diagnosed and determined that the ABS and traction control had failed, and the ABS module needed to be replaced. The ABS module was replaced. The manufacturer was not notified of the failure. The approximate failure mileage was 86,000.

Filed Mar 19, 2025 · Driver assistance, Electrical · OH

1st Vehicle was driving heavy so I got it checked and the transmission had to be replaced, this was in July?? 2024. The vehicle was still driving heavy 2nd was the traction light(s) VSR?? light turned on 3rd The check engine light came on and gave a P0420 Code. The right catalytic converter was replaced in March 2025 4th The same day I went to repare the Catalytic Converter (before replacement), the Blind Spot System warning came on along with 1. My windshield wipers turning on and off by themselves, 2. rpm went down to 0, 3. the low fuel sign came on even though I just fueled up AND the needle dropped to E, 4. the MPH also went down to 0, 5. the tire detection came on + the light, 6. the ABS light came on, 7. the traction lights came, 8. Heating/A/C system dropped to a lower pressure and then regained pressure, 9. there is a skip when accelerating, 10. won't properly read mileages used11. I lose control of my turn signals, lights, wipers AND hazard light as well as the powered windows Everything turned off and I gained control again Then it started again I turned the vehicle off but the lights kept turning on and off and I kept gaining control then losing it ALL of this occurs while I am driving, at a stop, or just turning on the vehicle Yes this possesses an issue for my and the safety of others No and Yes about the confirmed issues with a certified dealership No because I am scheduled for an appointment with a Chrysler dealer tomorrow (Mar.20th,2025) Yes because I have gone to other dealers and they cannot figure out what the main issue is No the issue has not been inspected by the manufacturer, police, insurance rep., etc. Yes and No to other warnings I knew someone was off because when I turn the key to the run position right before I turn the vehicle on, the check engine light stays on If I leave it in that position until all the other lights turn off, the check engine light remains on When I turn the vehicle completely on, the check engine light disappears

Filed Mar 4, 2025 · Driver assistance, Electrical · TX

The wire under the passenger side that controls the cruise control and abs system snapped suddenly. There was no impact or accident it just detached itself on the highway

Filed May 13, 2024 · Brakes · IA

I have an ABS module for my 2008 Chrysler Town and Country van that has gone bad. All of the warning lights came on for the brake system (ABS, Brake, ESP/BAS, traction). I took it to my local garage and they said that it was a bad ABS module and only the dealer could replace it because it needed to be re-programed. I took it to the dealer who also did a diagnostic and said that it was bad and needed to be replaced. BUT the part has been discontinued and they cannot find the part any where else. No other dealer has them. This sounds like a safety concern to me. The car does not have ABS and cannot be fixed. Can you do anything to force Chrysler to start making this part. It is not safe to drive on slippery roads and will lead to accidents and possibly deaths. Please help. Thank you, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Feb 5, 2024 · Brakes, Driver assistance · TN

Vehicle is a 2011 Chrysler Town Country Touring L and has 68,000 miles on it. It is well maintained with no issues prior to compliant incident. While normal driving of vehicle emergency dash light system activated numerous safety warning lights i.e.: ABS, ESC, Engine light. My wife was travelling on a highway at 68 mph. Loss of drivability noted at the time included; loss of speedometer, abnormal shifting of transmission, loss of ABS and traction Control, Cruise Control and seat belt notification. The following day, I took the vehicle to repair dealership where I was notified that there was numerous codes showing up on scanner. PCM Codes included; c2200 Internal fault of ABS Module, U1110, U1120, P0501. Advised that I would lose numerous other systems not noted due to codes these included; electric rear doors inoperable while vehicle started, seat belt alarm system, rear parking system notification. Dealership advises that Chrysler company has put the sale of ABS modules part # 68089474AA on hold for over the last year, due to an Engineering review, and that no modules are available for sale. It was recommend that I "get rid of the vehicle". In doing internet searches this is a long running problem with numerous vehicles using this same ABS Module system. Due to the numerous safety systems this affects, the vehicles are unsafe without a recall to correct this manufacturer defective ABS Brake Module. I have had to setup an auxiliary GPS module to calculate speed and severely limit driving this vehicle during inclement weather. As of now normal braking remains unaffected but there. Public is at the mercy of the manufacturer as ABS modules are not for sale and have a retail value of over $1300.00 + install and dealer reprogramming. This is a severe safety issue and aligns with other current recalls of similar models with the same condition. You may contact me at anytime to discuss. I am a recently retire Chief of Police and a certified Accident Homicide Investigator.

Filed Oct 2, 2023 · Acceleration, Brakes · TX

The ABS light, Traction light, and Brake light all come on and simultaneously. I've been told that the ABS Module is bad and needs to be replaced. The fact that the module needs to be replaced concerns me since there are prior recalls for ABS Module with other Dodge, Ram, and Chrsyler makes and models.

Filed Sep 8, 2023 · Airbags, Brakes · GA

Air conditioning condensation leaking below dashboard and onto carpet, causing electrical shorts in air bag and anti-lock brake (ABS). Chrysler identified this issue and issued a recall (K25) in January 2011, but only for vehicles manufactured through December 3, 2008. In consultation with Chrysler and according to its own internal documentation, my vehicle (manufactured in February 2009) has the same defective parts and is prone to the same safety issues caused by condensation leaking into critical electronic safety components, but they refuse to remedy the safety issue "due to it not being subject to the recall" -- despite Chrysler personnel conceding that my February-2009 was manufactured with the same, identical, flawed parts as those 2008 and earlier 2009 models that are subject to recall K25.

Filed Jan 3, 2023 · Electrical, Engine · FL

Multiple times the van will intermittently stall while driving down the road or stopped in traffic. First the dash lights flicker, speedometer and rpm gages go to 0, and warning lights such as esp, traction, abs, airbag, battery etc flicker on and off and occasionally hear almost a spark through radio speakers, then everything shuts off, both electrical and mechanically. When that happens I lose power steering and cannot get my hazards or brake lights to work. One time I could barely press the brake pedal, or steer and it was at night which means the vehicle was completely dark with no kinds of lights at an intersection with my 2 children and myself inside. So very scary! It gives me the worst anxiety to drive it and I'm too scared to sell it as I feel I would be knowingly selling a very unsafe vehicle. Occasionally the sliding side doors do not operate properly. First time the other night while the van was parked I hit the automatic shut button for the sliding door and lost all power to the vehicle and then it popped back in and operated fine. I have had multiple mechanics look at it and nobody can figure it out. Bought the van used in March or April of 2020 and had issues starting just 2 weeks after purchase. The van is now at around 108000 miles. I am out of money, a vehicle and options. Please help from a very scared and desperate mother who otherwise loves her minivan!

Filed Sep 28, 2022 · Brakes, Electrical · OH

ABS/TCS/EBP/ESP warning lights all illuminate during system check at 8mph. Diagnostic code C2200 - Internal Module Fault. Ongoing issue. Appears to be ambient temperature related. Internet+forum searchs find this exact condition very common on 2008 model Chrysler minivan. Requires ABS controller replacement with has been discontinued by Mopar. 2008 was the only model year to utilize this particular part number. 68030939AA. Superseded by 68030939AB.