2003 Dodge Dakota steering problems

Filed Mar 27, 2014 · Steering, Suspension · 111,800 miles · WI

Upper ball joints determined to be seriously worn. Need to be replaced asap. Was told dodge had recall/extended warranty on these parts but chrysler will not cover replacement at current time and with current mileage. Was told by chrysler to initiate the federal safety agency contact relative to chrysler case #[xxx]. Information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).

Filed Aug 16, 2013 · Brakes, Steering · TN

I have purchased several tires for this vehicle, and the problem is mainly in the front. I have had it aligned as required and it continued to eat the tires in a very few months. I recently (within the last 6 - 8 months) had the brakes, rotors, idler arm, bushings and other items replaced that dealt with the steering and the braking of this vehicle and it is doing the same thing again. When turning left or right, it will pop, and when pressing on the brakes it will grab, release then grab again. The brakes are not making a noise and I know when new brakes are installed that they have to allowed to maintain their fit, however, once they maintain their fit, they shouldn't start grabbing. When I have to press the brakes in a hurry the ABS light comes on and it concerns me the vehicle will not stop in time. This has been a problem for the last 4 or 5 years.

Filed Mar 11, 2013 · Steering · 91,500 miles · WI

Tl* the contact owns a 2003 dodge dakota. The contact stated that while parking the vehicle and in reverse, the contact attempted to steer the vehicle to the right and the steering wheel seized. The vehicle was taken to an independent mechanic for diagnosis and the contact was informed that the steering shaft needed to be replaced. The vehicle had not been repaired. The failure and current mileage was 91,500.

Filed Oct 25, 2011 · Steering · 123,000 miles · MI

Steering shaft universal joint has excessive wear, appears it is due to poor design as road splash hits the lower steering joint and poor seals allow rust and cause it to seize, making steering difficult and then when it is lubed by spraying a lubricaant on it it fails a short time later. Survey the dodge dealers and see how many of these joints they are replacing... This part is also on national bank order per my local dealer. Information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6)

Filed Sep 19, 2008 · Brakes, Engine · 5,000 miles · NC

Tl*the contact owns a 2003 dodge dakota quad cab. Whenever the brake pedal was applied, the brakes would pulsate, overheat, and lock up. The stopping distance would also increase. The dealer stated that wet conditions and high speed braking caused the rotors to warp. In addition, the vehicle idles high and roughly when approaching a stop sign or traffic light. When accelerating from a stop or merging into traffic, the vehicle would idle roughly. There was no throttle response for approximately 10 to 20 seconds, but then the vehicle would surge forward. The vehicle has been taken to a dealer approximately five times for these issues, but the failures still persist. All the sensors were replaced, but the failure is becoming worse. The dealer replaced the front rotors three times and the contact replaced them four times. The current mileage was 132,655 and failure mileage was 5,000. Updated 11/06/08. *lj the rotors and brakes were replaced several times. The consumer was told the vehicle had a faulty master cylinder that was not letting the rear brakes ever work. The air conditioner was built to drain into the front passenger floor. The computer in the vehicle would not accept updates. The intermediate shaft was replaced. The wiper motor was replaced. Updated 11/06/08.

Filed Mar 6, 2007 · Brakes, Steering · FL

To whom it may concern, I own a 2003 dodge dakota quad cab slt. And I have run into a lot of problems with this truck that people I know say they had very similar problems with the same make of vehicle. To start with my truck only has about 62,184 miles on it, for a 2003 model truck, that is considered low mileage. The problems I have run into is as follows: both front wheel hub bearing sets have prematurely failed, in particular, the right front hub tried to lock up on me and almost caused me to loose control of the truck, I have since replaced that hub but still need to replace the left front before it locks up:second is that the steering and suspension system has no provisions for preventative maintenance, I.e. No grease zircs for the ball joints, tie rods,upper and lower control arm bushings, wheel bearings, etc...causing rapid wear and failure:third big issue, I have already replaced all four brake rotors due to warpage. The brake calipers were built with some type of composite plastic pistons that distort due to excessive heat build up in the brakes. Which in turn causes uneven pad contact, that then causes excessive heat, accelerated pad wear, brake fade, rotor warpage, and an awful "squeal" when the brakes are applied. I have noticed that my brand new brake pads are actually cracked now because of a combination of the calipers and the hubs going bad: fourth issue is that the transmission causes the engine to over "rev" in the highway passing gear especially with the over drive and cruise control on. When you're driving down the highway and you give it a little more gas to get around somebody, the engine RPM's shouldn't go up to sometimes around 7000, that in turn could cause premature engine or transmission failure. I have been in contact with daimler-chrysler about these concerns but they just keep giving me the run around and not answering my questions. I still have the old parts also.

Filed Jan 18, 2007 · Steering, Suspension · 48,318 miles · CT

2003 dodge dakota 4x4 4.7 automatic: steering/handling looseness, instability, skittishness on roadways worse at higher speeds, very pronounced over bumps. Inconsistencies in roadways. Vehicle "walks" sideways when going across road discontinuities. Dealer service return for diagnosis: major safety component intermediate steering shaft defective/worn.

Filed Mar 10, 2005 · Steering, Visibility · CA

When making a left turn at 30 MPH consumer heard a popping sound. When the vehicle was serviced, the consumer was informed that a tie rod needed replacement. Consumer was still having the same problem, even after the repair was made. *ak *nm the consumer stated the dealer refused replace the wiper motor even though there was a recall.

Filed Dec 10, 2004 · Steering · TX

I purchased a 2003 dodge dakota on 02/01/2003. Since I have had this vehicle I hear a metalic popping noise when I turn sharply. I was told by the dealer that the noise is probably my spare tire lock but even if I secure the lock the noise continues. Because of the recent news stories about a possible recall I'm concerned that the noise I am hearing may be from the ball-joint defect that is being scrutinized.

Filed Aug 19, 2004 · Steering · NY

While driving 65 MPH, the vehicle swerved in different directions. The consumer was able to maintain control of the vehicle and drove it to the dealer for inspection. The mechanic was unable to duplicate the problem. Please provide further details.