1993 Dodge Intrepid problems

What is wrong

On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.

Risk

Either circumstance may result in the vehicle rolling away without warning.

Remedy

Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on june 14, 2004. Owners should contact daimlerchrysler at 1‑800‑853‑1403.

Recall number 04V021000 · Recall details

What is wrong

Vehicle description: passenger vehicles. The lower control arm attaching brackets can crack due to fatigue and separate from the engine cradle.

Risk

If this occurs, the transmission half-shaft could pull out of the transaxle and result in loss of power.

Remedy

Dealers will reinforce the engine cradle at the point where the lower control arm attaches to it.

Recall number 99V215000 · Recall details

What is wrong

Vehicle description: passenger vehicles built with 3.5l engines. The fuel injection delivery system can leak fuel from some of the sealing o-rings or from hair line cracks in the thermoset fuel injection rail.

Risk

Fuel leakage in the presence of an ignition source can result in a fire.

Remedy

Dealers will replace the fuel rail o-rings and reinforce the outlet (passenger) side fuel rail. Vehicles showing fuel leakage on the outlet fuel rail must have the outlet rail replaced which includes changing the upper and lower injector o-rings. However, if a vehicle is leaking fuel from the o-rings or from a cracked fuel line, the vehicle should be taken into a dealer to have this repaired as soon as possible.

Recall number 98V184000 · Recall details

What is wrong

Vehicle description: passenger vehicles built with 3.3l engines. The 'o-rings' used to seal the interface of the fuel injector rail supply, return and cross over tubes are not as robust as those used in later model years. Deterioration of the 'o-rings' can cause fuel leakage.

Risk

In the presence of an ignition source, fuel leakage in the engine compartment could result in a fire.

Remedy

Dealers will replace the engine fuel rail.

Recall number 98V130000 · Recall details

What is wrong

The front suspension lower control arm tension strut washers can crack and fall off due to hydrogen embrittlement.

Risk

Loss of a washer will cause a clunking sound, heardduring braking. If left unattended, the loss of the washer will eventuallyresult in tension strut attachment failure that can result in loss of steeringcontrol and an accident.

Remedy

Replace the front and rear strut bar washers and nuts.

Recall number 92V128000 · Recall details

On september 5, 2004, mr. Robert galenty of iselin, nj, petitioned the agency to conduct defect investigations of certain model year (my) 1993-1997 vehicles produced by daimlerchrysler corporation.his petition identified three issues of concern: 1) fuel leaking from the fuel injector rails; 2) brake fluid contamination resulting in brake failure; and 3) susceptibility of the vehicle frame to damage while the vehicle is being towed.mr. Galanty alleged that his 1996 dodge intrepid had each of these three problems.concerning fuel rail leakage, daimlerchrysler commenced a recall (98v‑184) of approximately 722,600 vehicles to address engine fuel rail leaks that could lead to a fire, including those vehicles cited in the petition and the petitioner's 1996 dodge intrepid.on october 7, 1998, the federal safety agency opened a recall query investigation (rq98-018) to evaluate the adequacy of the recall remedy.that investigation was closed on july 8, 2002 without requiring further action by daimlerchrysler.very recently, on june 9, 2004, the federal safety agency denied a petition (rp04-001) to reopen rq98-018 after finding that there was no new information that would indicate any basis for reopening it.this is still the current position of the federal safety agency on this issue.concerning brake fluid contamination and frame alignment, a review of the federal safety agency's database shows no other complaints on either one of these issues on the vehicles cited in the petition.

DP04007

The manufacturer reports above are based on daimlerchrysler?s (dc) analysis of model year (my) 1998 (population = 356,384) and 1999 (population = 486,948) ja, jx and lh family subject vehicle data (earlier mys excluded).the population number includes all mys.the precise number of duplicates between odi and dc reports cannot be determined due to missing or incomplete information.the fatality incident involved an elderly person who attempted to stop a roll away vehicle and received fatal injuries.odi also gathered information on my 1997-99 prowler vehicles in this investigation. The prowler vehicles were manufactured with a different design shifter mechanism (the shift lever is shorter).there are no complaints of prowler interlock failure in odi?s database, and dc has received no reports either.the prowler is excluded from the recall scope.the investigation involved a condition where the interlock system could fail (or be made inoperative by the operator) during vehicle use, possibly inadvertently.the interlock system is required under fmvss 114.with the transmission in the park position and the ignition key off, the combined action of pressing the shift button and pulling the shift lever rearward may result in the operator overcoming the interlock system and cause the mechanical linkage of the system to disconnect.when this occurs, there is no overt indication to an operator that the system is defeated, and an increased risk of vehicle roll-away exists.under recall 04v021, dc will replace damaged shift mechanisms, and will install on all vehicles a device which inhibits the operator?s ability to overcome the interlock and defeat the system.beginning with my 2000, dc incorporated a brake and transmission shifter interlock (btsi) system into the subject vehicles.introduction of btsi involved design changes to the shift mechanism, one of which resulted in reduced mechanical advantage (rma) of the shift button.the rma shifter requires increased forces to overcome the interlock system, making the shifter less susceptible to damage.

EA03011

Mr. Larry a. Sackey submitted a petition to the federal safety agency by letter dated april 18, 2003, requesting that agencyfurther investigate the defective collapsible steering shaft system on 1987-1995 vehicles manufactured by the daimlerchrysler corporation.in part because of 49 cfr ? 30120(g), the federal safety agency has decided to limit the scope of the petition vehicles to 1993-1995 models, excluding the 1993 jeep grand cherokee and 1994-1995 dodge ram series trucks that were recalled (93v210 & 96v230) for steering column failure.if the analysis of these vehicles had identified a potential problem, the scope could have been expanded in an investigation.a review of odi's data base shows no recent complaints and a lack of a complaint trend concerning the subject issue on the subject vehicles as a whole or by individual models.therefore, the petition is denied.for details, see federal register notice volume 68, no. 130, july 8, 2003.

DP03002

RQ98018

Alleged that the rear suspension trailing and/or its attachment bolt may fail, posing a risk of loss of vehicle control and loss of rear service brake operation

PE98022

Nitrile rubber seals used in the fuel rail assemblies of the subject vehicles at the supply, return, and crossover tube fittings, and at the pressure regulator fail, resulting in fuel leakage in the engine compartment.also, the outlet (right) fuel rail may leak from cracks at certain mold gates in the thermoset rail material.chrysler will recall the subject vehicles and stated that it intends to replace the o-rings with fluorocarbon o-ring having greater heat resistance capability and attach reinforcements to the rail in the areas where the cracking concern has been known to occur most frequently.rails that are already cracked will be replaced by new, reinforced rails.

EA98007

Alleged gasoline leaks from the fuel rail cross-over tube fittings

PE98014

A safety-related defect trend has not been identified at this time and further use of agency resources does not appear to be warranted.the closing of this investigation does not constitute a finding by the federal safety agency that no safety-related defect exists.the agency reserves the right to take further action if waarranted by the circumstances.an engineering analysis clossing report is included in the public file.

EA95028

A safety-related defect trend has not been identified at this time and further expenditure of agency resources does not appear to be warranted.the closing of this investigation does not constitute a finding by the federal safety agency that a safety-related defect does not exist.the agency will take further action if warranted by the circumstances.see the engineering analysis closing report (ea95-023)

EA95023

There is no summary currently available

PE94056