2006 Dodge Sprinter 3500 problems

What is wrong

Daimler Vans USA, LLC (DVUSA) is recalling certain model year 2003-2006 Dodge and Freightliner Sprinter 2500 and 3500 vans manufactured June 30, 2003, to August 31, 2006. The instrument cluster on the affected vehicles fails to illuminate the BRAKE warning lamp in the instrument cluster during the vehicle start up bulb-function check. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 105, "Hydraulic and Electric Brake Systems."

Risk

Without the BRAKE lamp illuminating during the vehicle start up bulb-function check, the driver has no confirmation that the lamp is working and therefore may not know whether or not the lamp will illuminate if the brake fluid level is low. If the operator is unaware that the vehicle has low brake fluid, there would be an increased risk of a crash.

Remedy

DVUSA will notify owners, and DVUSA and Dodge dealers will correct the instrument cluster software, as necessary, free of charge. An interim notification was sent to owners on January 6, 2017. A second notice will be mailed to owners once the remedy becomes available. The recall began on July 27, 2017. Owners may contact DVUSA customer service at 1‑770‑705‑2070.

Recall number 16V833000 · Recall details

What is wrong

Cummings Mobility Conversion & Supply (Cummings) is recalling certain model year 2006-2014 Ford E-150, E-250, E-350, Chevrolet Express, 2006-2008 Dodge Sprinter, and 2009-2014 Mercedes-Benz Sprinter, and 2013 Ford Transit Connect vehicles manufactured January 1, 2006, to October 8, 2014, equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts manufactured by Ricon Corporation after January 1, 2006. The platform side plate of the affected wheelchair lifts may crack.

Risk

If the platform side plates crack, the lift platform can separate from the lift and come to rest against the vehicle's lift door. When the doors are opened, the platform may fall out, increasing the risk of injury to the lift operator.

Remedy

Cummings will notify owners to take buses to a Ricon dealer or service center who will install supplemental platform support bumpers. Any platform that has already started cracking will be replaced, free of charge. The recall began January 13, 2015. Owners may contact Cumming's customer service at 1‑800‑639‑5438 or Ricon customer service at 1‑800‑322‑2884. Cumming's number for this recall is 14E-041.

Recall number 14V706000 · Recall details

What is wrong

Sprinter is recalling 10 my 2001-2006 dodge and freightliner 2500 and 3500 vehicles. The welding seam between the bracket and steering column of affected spare parts does not meet design specifications. The result of an out of specification welding seam is that the steering column may detach from its interior vehicle mounting bracket.

Risk

The operator may lose steering ability of the vehicle increasing the risk of a crash.

Remedy

Dealers will inspect and replace the steering columns free of charge. The recall is expected to begin on or before february 16, 2009. Owners may contact sprinter at 843‑695‑5057.

Recall number 08V339000 · Recall details

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

EA21002