1997 Dodge Stratus problems

What is wrong

On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.

Risk

Either circumstance may result in the vehicle rolling away without warning.

Remedy

Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on june 14, 2004. Owners should contact daimlerchrysler at 1‑800‑853‑1403.

Recall number 04V021000 · Recall details

What is wrong

Vehicle description: passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, can break the connecting pin in the shifter.

Risk

If this happens, the "ignition-park" interlock system will be nonfunctional.

Remedy

Dealers will inspect for proper operation of the system. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a "self-adjusting" design.

Recall number 98V183000 · Recall details

What is wrong

Vehicle description: passenger vehicles. The lower control arm ball joint can separate due to loss of lubrication.

Risk

Separation of the ball joint could cause a loss of steering control increasing the risk of a vehicle crash.

Remedy

Dealers will inspect the ball joint end housing cover seal for leakage with a high pressure air tester and the rubber boot will be visually inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.

Recall number 97V201000 · Recall details

What is wrong

Vehicle description: passenger vehicles. The secondary hood latch spring can disengage from its retention hole if the hood is slammed shut.

Risk

If this condition occurs simultaneously without engaging the primary latch, the hood would not be restrained increasing the risk of a vehicle crash.

Remedy

Dealers will replace the secondary hood latch spring with a longer end hook spring.

Recall number 97V095000 · Recall details

The manufacturer reports above are based on daimlerchrysler?s (dc) analysis of model year (my) 1998 (population = 356,384) and 1999 (population = 486,948) ja, jx and lh family subject vehicle data (earlier mys excluded).the population number includes all mys.the precise number of duplicates between odi and dc reports cannot be determined due to missing or incomplete information.the fatality incident involved an elderly person who attempted to stop a roll away vehicle and received fatal injuries.odi also gathered information on my 1997-99 prowler vehicles in this investigation. The prowler vehicles were manufactured with a different design shifter mechanism (the shift lever is shorter).there are no complaints of prowler interlock failure in odi?s database, and dc has received no reports either.the prowler is excluded from the recall scope.the investigation involved a condition where the interlock system could fail (or be made inoperative by the operator) during vehicle use, possibly inadvertently.the interlock system is required under fmvss 114.with the transmission in the park position and the ignition key off, the combined action of pressing the shift button and pulling the shift lever rearward may result in the operator overcoming the interlock system and cause the mechanical linkage of the system to disconnect.when this occurs, there is no overt indication to an operator that the system is defeated, and an increased risk of vehicle roll-away exists.under recall 04v021, dc will replace damaged shift mechanisms, and will install on all vehicles a device which inhibits the operator?s ability to overcome the interlock and defeat the system.beginning with my 2000, dc incorporated a brake and transmission shifter interlock (btsi) system into the subject vehicles.introduction of btsi involved design changes to the shift mechanism, one of which resulted in reduced mechanical advantage (rma) of the shift button.the rma shifter requires increased forces to overcome the interlock system, making the shifter less susceptible to damage.

EA03011

There are no injuries or fatalities associated with this alleged defect.while conducting this investigation, odi found that the subject cinches meet the load bearing requirements of federal motor vehicle safety standard 208, and that many of the reported failures were due to incorrect child safety seat installations. Additionally, the report rate is low (1.60/100k).the information available fails to establish the existence of a defect trend at this time.further allocation of agency resources to this issue is unwarranted and the preliminary evaluation is being closed.

PE02082

By letter dated november 6, 1997, the manufacturer advised this agency of its decision to initiate a safety recall campaign of the subject vehicles to correct the defect identified in this ea.the recall will also cover 1996 and 1997 chrysler cirrus/dodge stratus vehicles, as well as 1995 through 1997 chrysler sebring convertible and plymouth breeze vehicles equipped with identical lower control arm ball joints.an estimated total of 599,00vehicles are affected by this recall.the manufacturer's investigation disclosed that process variability, together with the ball joint housing cover crimping operation, can result in an ineffective seal that permits a loss of lubrication and accelerted wear of the ball joint assembly.this condition can lead to failure and separtion of the lower control arm ball joint.the recall is identified as the federal safety agency 97v‑201 and a copy of chrysler's letter to the federal safety agency is attached hereto.

EA97016