1994 Ford Bronco problems

Filed Feb 9, 2015 · Brakes · 130,000 miles · KS

Parking brake does not hold. I can not park on incline. If parking brake is applied fully at 15 MPH it takes 45 yards to stop. Extremely unsafe!!!

Filed Jan 24, 2015 · Acceleration, Brakes · 78,500 miles · MI · fire

The vehicle was parked in my school parking lot and caught fire hours after parking it. Vehicle is a total loss.

Filed Apr 25, 2013 · Acceleration, Brakes · 175,000 miles · MD

The 1994 ford bronco equipped with speed control had ford recall no. 05s28 accomplished in 2008. In 2012 the wiring overheated and caused damage and a leak to the master cylinder reservoir and had to be disconnected. When ford was contacted they instructed that the recall had been accomplished and they could not warranty the part.

Filed Nov 15, 2010 · Seats · 161,000 miles · MO

1994 ford bronco driver seat (bucket) back frame has broken. Have spoken to numerous sources that all claim this is a common occurrence. Was advised not to replace with bronco seat, that all have either already failed or will fail eventually. That sounds terribly unsafe, especially in the event of a crash.

Filed Feb 9, 2009 · Brakes · 105,000 miles · SC

Tl*the contact owns a 1994 ford bronco. The contact stated that the parking brake does not hold. On several occasions, he applied the parking brake and the vehicle rolled in the direction of the hill on where it was parked. The dealer stated that the federal safety agency campaign id number 94v169001 (parking brake:conventional) was not an active recall. The manufacturer stated that the recall was not in their database and refused to perform the repair. The current mileage was 180,781 and failure mileage was approximately 105,000. Updated 03/09/09. *lj updated 03/11/09.

Filed Dec 29, 2008 · Electrical, Transmission · 107,000 miles · FL

Tl*the contact owns a 1994 ford bronco. The contact is able to start the engine with or without the key in the ignition. He simply grabs and turns the metal piece where the key is placed. He is concerned that anyone can start and steal the vehicle. He has a friend with the same vehicle who also experiences this failure. The contact has not taken the vehicle to a shop or mechanic. It has never been diagnosed or repaired. The failure mileage was 107,000 and current mileage was 180,000. Updated 01/21/09.

Filed Sep 11, 2006 · Acceleration · 108,989 miles · WI · fire

The vehicle was parked outside our home at 3:50 am the horn started to blow, I looked outside and flames were coming from under the hood. We drove the car earlier that day around noon for a couple of hours.

Filed Jul 6, 2006 · Lights · 97,000 miles · KY

I own a full size 1994 ford bronco 351 5.8l eddie bauer. After driving at night for 5-10 minutes the lights flash off and on intermittently. I noticed a very strong burning electrical smell emitting from the dashboard around the headlight/dimmer switch. I removed the dash to examine the switch, contact blades, and wiring harness plug. The plastic connector at the end of wiring harness that plugs into the headlight/dimmer switch was burned, melted and extremely hot to touch. After research on internet I feel very strongly that this problem will occur more frequently as vehicles get older and the switch fails due to defect. I'm no automotive genius, but concerned that others may continue to drive vehicle and faulty switches will start fires. I saw information from walters forensic engineering - toronto ontario that lab situations showed these same switches cause fires from electrical resistance problems. I have the melted parts for examination. Consequences can be serious injury or death. Ford motor corporation should replace/recall these faulty items. Recent ford fires may also be related to this switch due to close proximity of cruise control fires source. The headlight switch may melt and burn behind the dash area from high heat. Part# stamped on the dimmer switch is motorcraft e77b-11654-aa. There is a secondary number in non-removable ink or paint that appears also. May be a ford plant or part identification# used during assembly. It is 3l 0912. There are 9 blades on the switch that connect to wiring harness. These prongs have identification letters next to them down inside the switch. (for example: to name a few there are d1, d2, and ign) the area of concern has b2 next to it. It's at the bottom of the third rows of blades in the center. Motorcraft apparently has a different or new identification# for this switch. I have not purchased a replacement yet, but it looks like the new part # for my vehicle as described may be sw2103. Please respond!

Filed Jan 17, 2006 · Acceleration · MA · fire

1994 ford bronco caught on fire under the hood while parked. The vehicle was a total loss. *ts ***no answer required*** three and a half years after the fire the consumer received recall 05v388000 from the manufacturer. The recall was for the cruise control deactivation switch. The recall stated that the switch could overheat and result in a underhood fire. The letter also stated that a replacement part wouldn't be available until 11/2005. The consumer request reimbursement for the value of his vehicle at the time of the fire.

Filed Oct 3, 2005 · Acceleration · OR · fire

Dt: the contact called ford on 10-03-05 about the recall letter she received on friday 9-28-05. T a fire broke out on 2-28-04 on 1994 ford bronco. The contact told ford about the fire, and ford claimed that the contact's insurance took care of the issue and they could not do anything else . Also, ford told the contact that because she did not have a ford dealer look at the car and determine that the cause of the fire was the scds they could not do anything for her. On 2-28-04 while driving at 70 MPH she saw smoke in rear view mirror. She pulled over and saw a fire coming from under the hood. The fire department was called, but cancelled after a trucker put the fire out. No one ever determined the cause of the fire. She did have the truck repaired and was driving it now. She reported of having no problems with the cruise control or any problems with the truck starting prior to the fire. As of this date she has not had the scds disconnected, but planned to have it disconnected.