2022 Ford Bronco: stuck in gear or won't shift

Filed Jun 28, 2026 · Engine, Transmission · TN

2022 Ford Bronco 2.7L EcoBoost VIN [XXX] has experienced recurring engine oil pressure failure causing vehicle to enter limp mode limiting speed to 25mph creating an unsafe driving condition. Diagnostic trouble codes P0524 Engine Oil Pressure Too Low and P06DD Engine Oil Pressure Control Stuck Off confirmed. Two failed warranty repair attempts at Lenoir City Ford Lenoir City TN on XXX and XXX. Dealership provided loaner vehicle both times acknowledging vehicle was unsafe to drive. Ford corporate case number XXC is open. Third repair attempt scheduled XXX.” INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Jun 16, 2026 · Engine, Transmission · ID

While operating the vehicle under load, the vehicle suffered a sudden and severe loss of engine performance, followed immediately by loud metallic banging from the engine bay. The vehicle lost all power and was immediately disabled (LIMP MODE), presenting an imminent highway safety hazard.The Physical Damage: Subsequent mechanical teardown revealed deep vertical cylinder wall scoring, heavy raw fuel residue in the engine oil pan, and a blown head gasket. Relationship to Active Safety Defect: This catastrophic block failure perfectly mirrors the progressive failure profile of the federal safety agency Campaign 25V455 / Ford Safety Recall 25S75 (Low-Pressure Fuel Pump Failure). Internal component degradation in the fuel tank delivery module dropped fuel pressure to the engine. Under turbo boost, this starvation induced an extreme, instantaneous lean-out condition. The resulting low-speed pre-ignition (LSPI) exploded and shattered the internal piston rings (the metallic banging), leading to mechanical wall gouging, unburnt fuel wash into the lower crankcase, and a secondary blown head gasket. Request for Action: Ford's current VIN parameters for Recall 25S75 have not yet captured my specific vehicle despite it matching the exact production window, component setup, and catastrophic failure sequence. I am requesting that the federal safety agency log this case as clear evidence of consequential engine destruction originating from the 25V455 pump defect, and evaluate whether Ford's recall scope must be expanded to protect other consumers from highway engine failures.

Filed Feb 2, 2026 · Transmission · TX

I’ve complained to my local Ford dealer about 10-speed transmission issues including to several different service techs. There is a loud clunk and physical movement of the vehicle when shifting from park through to reverse and eventually to drive—it’s the P to R which is most noticeable. I’ve had 3rd party mechanics inspect the clunk, had Ford replace the driveshaft, conducted a trans fluid flush, but the clunk persists. I am concerned that one day, the vehicle will not shift out of park or potentially damage the transmission to an undriveable state outside of warranty. This has persisted for several years. I need Ford to replace the transmission and then conduct research into the issues with the old one once removed.

Filed Feb 19, 2024 · Engine · VT

My bronco started having issues randomly when it went into limp mode one day. I brought it in to get fixed and it continued to happen. Ultimately, they told me that it needed a brand new engine.

Filed Jul 26, 2022 · CA

2 days after purchase while driving the vehicle I recieved a check engine light and a warning that there was a failure of the turbo wastegate. This caused my car to not allow acceleration while driving on the freeway and impeded my ability to manually shift my vehicle into gear. This caused safety issues for myself and others as I was forced to quickly lower my speed on the freeway to avoid causing unrepairable damage to my engine and to be able to shift my vehicle back into gear. My dealer confirmed that the turbo waste gate was faulty and required replacement. I have heard this is a common part failure on this vehicle. Prior to the warning light, my car regularly was difficult to shift and often would not go into gear when shifting. I had to decrease speed often to get my vehicle to shift.