My granddaughter and I were driving the car around 50mph. When suddenly we smelled burning. The car wouldnt go when I pressed the gas pedal. We smelled the loudest weird smell. So I immediately pulled into the closest car clinic. The breaks were blue and almost on fire. No warning or anything. Turns out, It was the abs control module. It totally failed and caused the breaks to lock up completely. Which almost caught fire. The break pads were blue. We were terrified. After getting Calipers, break pads, and rotars repaired costing $712. I still have to pay another $1000 when I get paid in a week. To get the abs control Module repaired. Because the car isn’t drivable without that repair. I just wish Ford would pay for the repair. Being that they made most of the 2019 Ford Fiesta SE with the wrong fluids. Which causes the breaks to lock up and the abs control module to fail/die. But they denied it. Which is so unfair. Because We could’ve died. And it’s an expensive repair. At no fault of my own. I will upload the other invoices for the back breaks, rotars, pads, calipers and abs control model as soon as I get it paid and repaired. . Thank you
Ford Fiesta abs comes on
22 of the 3,179 owner complaints about the Ford Fiesta describe aBS light or ABS activating, most of them for the 2014 model year.
- owner complaints
- 22
- worst model year
- 2014
- typical mileage
- 74,580
By model year
Often reported together
Jerking 5Shudder 3Won't start 2Stalling 2Loss of power 2Fire or smoke 2Engine failure 2Check engine light 2
What owners say
The contact owned a 2019 Ford Fiesta. The contact stated that while driving 50 MPH, there was an abnormal burning odor on the interior of the vehicle. The vehicle was taken to an independent mechanic where it was diagnosed with ABS control modular failure. The contact was informed that during the production of the vehicle, the manufacturer used brake fluid which caused the brake pads to swell and corrode. The contact was informed that the front and rear brake pads and rotors had seized. The contact was informed that the failure was a fire risk. The dealer was contacted by phone and made aware of the failure. The contact agreed to a voluntary buy back. The failure mileage was approximately 65,400.
Brakes started seizing up while driving. Became extremely dangerous as the car would rock at speed and also would not start moving if I came to a stop. Went immediately to a shop, when I arrived into the shop, inspection found that the caliper was locked onto the wheel preventing the front wheel from moving. Had the caliper replaced but the caliper was still seizing, and then had to get the ABS Hydraulic Assembly, P/N D2BZ 2C405-E replaced. This P/N seem to be causing a lot of troubles from online forums. This issue had no warming lamps, messages or anything indicating this other than a feel that the car is accelerating more slowly. However, when the brakes started seizing, the situation felt extremely dangerous.
ABS Module failure. I had to leave the break lines direct, losing my ABS. I had to replace the brake pump because of that too. The car was only 80k ish.
The contact owns a 2014 Ford Fiesta. The contact stated that while driving at an undisclosed speed, the brake pedal was depressed, and the contact became aware that the braking system had overheated. There was no warning light illuminated. The vehicle was taken to the independent mechanic, where it was diagnosed that the ABS module had failed and needed to be replaced. The vehicle was not repaired. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure, and a case was opened. The contact was referred to the federal safety agency Hotline for assistance. The approximate failure mileage was 64,000.
2014 Ford Fiesta manual sedan exhibiting recurring, dangerous hood latch malfunction (recently noticed) where hood unlatches while driving/parked & experiencing sudden power loss when AC is used (fuse removed to prevent this dangerous condition). Potential safety hazards: obstructed vision, hood detachment, engine tampering, sudden loss of control. Ford Service Advisor admitted hood latch "should" be a recall, yet dealership attempts to charge $350-$500 ($250 diagnostic) for repair instead of initiating recall. This raises concerns Ford prioritizes profit over safety, esp. since Fiesta is discontinued. Other issues include previous brake pad lock-up requiring costly ABS Hydraulic Control Unit repair & door latch recall 20S15 ("door may unlatch while driving"). Multiple recurring issues suggest vehicle may be a lemon overall. Request immediate the federal safety agency investigation into hood latch defect & electrical/AC power loss issue. Urge recall consideration. I will gladly allow my vehicle to be studied in a the federal safety agency lab to aid investigation. Concern heightened by Ford's discontinuation of model.
The contact owns a 2011 Ford Fiesta. The contact stated while driving at approximately 65 MPH, the vehicle stalled. The contact stated that the engine malfunction, ABS, and Hill Assist warning lights were illuminated. The contact had taken the vehicle to an independent mechanic where it was diagnosed; however, the contact was unaware of the diagnostic result. The vehicle was repaired; however, the failure reoccurred. The vehicle was taken back to the same mechanic who again diagnosed the vehicle and informed the contact that the vehicle was repaired. The contact stated that the failure reoccurred, and the vehicle was taken to a local dealer. The dealer diagnosed the vehicle and determined that the throttle body, engine electrical harness, and engine mounts needed to be replaced. The vehicle was repaired. The contact stated that the failure had reoccurred, and the vehicle stalled with white smoke coming from the exhaust pipes. The contact had not taken the vehicle back to the dealer. The vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 144,000.
Upon stopping when applying the brakes they locked up. There were no warning lights on. It was diagnosed by an independent auto repair shop, not drivable I had it towed to the Ford Dealership. The ABS module, and calipers have failed. I learned there was a recall on these parts but do not apply to my specific vin #. The ABS module is on national back order, likely a month out. I have paid for the part. The service dept quoted new rotors calipers/hose and pads I think this vehicle may need to be added to the recall since it is the exact same failure. Luckily I was in town and not on the interstate when the brake system failed.
I started to notice a bit of resistance when pressing on the brakes. Minor initially, but then if you had to apply slightly more pressure the car would jerk/pull hard to the right. The harder and faster you had to press, the more intense the jerk. I took her in to the dealership and they noticed something with the reservoir into the hydraulics unit that feeds fluid into the brakes. The fluids are not circulating back into it and the caliper is not building enough pressure to close. They said it's the ABS Hydraulic Control Unit: D2BZ-2C405-E and the part is on national backorder with no ETA. The car is unsafe to drive without the part. She's a 2014 with only 28k miles and it seems strange to have this failure with such low mileage. I just have texts with the dealership right now. I spoke with Ford directly today and they guesstimated 5-6 months for the part. I ordered a used part and will take her to another mechanic to get it replaced in the interim since the dealership won't work with a used part. At that point I will have invoices. Thanks.
I believe that it is the ABS brake system I am bringing it to the ford dealer Thursday. The caliper on the front driver side was not working so I changed it still didn't work fluid go's to the ABS pump but doses not come out of that one. When you use the brakes the front passenger side locks up and slides like it's not going to stop it is really bad when the roads are wet and there were no warning signs. It's going to the dealer Thursday.
Related recalls
Service brakes, hydraulic: foundation components: disc: caliper
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2019 Fiesta vehicles. The brake calipers may have been manufactured with the incorrect assembly fluid, which can cause the caliper's rubber seals to swell.
- Risk
- The swollen seals can cause the brakes to drag, potentially overheating the brakes and increasing the risk of a crash.
- Remedy
- Ford will notify owners, and dealers will flush the brake fluid and replace the front brake calipers and brake hoses, free of charge. The recall began October 10, 2019. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 19S27.
Recall number 19V629000 · Recall details
Questions about the Ford Fiesta abs
Why does the abs come on in the Ford Fiesta?
Owners who report it most often also describe jerking or lurching, shudder or vibration when accelerating and won't start.
Which Ford Fiesta years have aBS light or ABS activating problems?
The model years with the most reports are 2014 (5 complaints), 2019 (5 complaints) and 2011 (4 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Ford Fiesta?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history