2013 Ford Focus: check engine light

Filed Sep 9, 2026 · Electrical · ME

RE: FAULTY THROTTLE WIRING / LOCATION CAUSING CORROSION 2013 FORD FOCUS - RECALL NEEDED To Whom It May Concern: My 2013 Ford Focus SE Flex with VIN [XXX] lost power while traveling from [XXX] to [XXX] a couple times before completely dying. My code reader was getting fixed throttle codes 2112, 2111 and pending codes 122, 223. I switched out the throttle body AND accelerator pedal position sensor. This did NOT resolve the issue. I had the Focus towed to Downey Ford in [XXX] where they found a Technical Service Bulletin stating endless Focuses had this issue with corroded wiring, which appears to be caused by TSB 15-0036, which is regarding the wiring harness rubbing against a sharp part of the intake, which can cause shorts in the cables. This Ford Dealership repair cost me $845.80 + grief + an extended stay at my hospitable parents in [XXX]. This concern should be escalated to RECALL status as it leaves your loyal customers stranded on the roadside. My request is a full refund from Ford for $845.80 CAD. See Downey Ford Invoice # SO # XXX attached. Source: [XXX] [XXX]: Bear with me, this is going to be a bit long. TL;DR: Car will not accelerate, CEL/MTC states problem with "accelerator pedal position sensor". Wiring harness has been cut into by rubbing on intake. I want to splice it to fix it, but need advice due to length/resistance requirements. Two weeks ago, my wife was driving my 2013 Ford Focus SE Hatchback and right as she got off the freeway, it instantly lost power, a message appeared on the screen stating "Engine Fault - Repair Now", and it idled super rough. She restarted the engine and it was fine until she tried accelerating more than a tiny bit, at which point the same symptoms occurred again. She was able to limp the car home. Having misplaced my OBD2 scanner, I limped it over to the local auto parts store and they read the code as INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Sep 2, 2026 · Electrical, Transmission · WI

I purchased a 2013 Ford Focus from Boucher Ford of Menomonee Falls, WI in February, 2026. A few months later, Ford issued a recall on this car that requires the Powertrain Control Module to be reprogrammed to avoid issues like a collapsed fuel tank or stalling while driving, potentially causing an accident. I had been informed by a mechanic that this car was sold to me with a custom tune on the PCM. This tune was not disclosed to me when I purchased the car and due to the PCM being modified, the recall cannot be performed without damage to the PCM rendering the car undriveable. I tried working with Jeff Samp (General Manager) at the dealership but he told me they were not required by law to check for tunes when a car is traded in and that he could have someone "look at the car" but if they damage the PCM performing the recall, they will not be held responsible. I opened a case with Ford Motor Company and was informed that they would escalate to some kind of dealership oversight department and that it might take a couple weeks to get a response. I never received a response so I called Ford to inquire and was told that they are not sure why I was told that, that no such department exists, and that all they can do is call the dealership on my behalf and "ask" them to deal with it. Facts: 1. They sold me a car with a modified Powertrain Control Module which can affect many things, even falsely disabling check engine lights. 2. A FEDERAL RECALL for my own safety cannot be performed on this vehicle IN THE CONDITION THEY SOLD IT TO ME, putting my safety, my passengers' safety, and the safety of other motorists at risk. 3. Boucher Ford will not remedy this issue or even contact the previous owner as I requested to find out what kind of tune is on this vehicle so that I can get it removed and this safety recall performed. I want the PCM replaced with a new unit, with the new software that complies with this recall.

Filed Jun 4, 2026 · Fuel system · NC

I had my purge valve replaced under 24N07 ford costumer satisfactory program and the faulty purge valve damaged my catalytic converter and caused my engine light to illuminate with P0420.

Filed May 17, 2026 · FL

While driving home from work, I was attempting to accelerate my RPMs showed 4000. However, my speed did not match the car. He hesitated and was doing a lot of jerking after I got home turned off the car turned it back on my check engine light came on and it threw a code P07A5.

Filed Feb 11, 2026 · Steering · VA

During recent freezing weather, upon starting the car and attempting to turn, I realized that the steering wheel was frozen solid. While researching what could have happened, the war warmed up enough to melt the water in the electric power assisted steering motor, allowing the vehicle to turn. Now, the EPAS is seized up completely. If I had been driving when it locked up completely, it could have proved fatal. The problem has not been reproduced, as it just happened in the last couple of weeks. I never got any check engine light pertaining to this issue. OBDII showed not errors for the EPAS.

Filed Jul 31, 2025 · Transmission · 60,000 miles · TN

The contact owns a 2013 Ford Focus. The contact stated while driving approximately 20 MPH on two occasions, the vehicle lost motive power. The check engine warning light was illuminated. The vehicle was steered to the side of the roadway and restarted. The contact stated that after the first failure, the vehicle was taken to a dealer however, the failure could not be replicated; however, the failure recurred. The contact stated that on the second failure, the vehicle was able to restart; however, the failure persisted upon restarting the vehicle. The vehicle was towed to another unknown dealer, where it was diagnosed that the Transmission Control Module had failed and needed to be replaced. The vehicle was not repaired. The contact related the failure to an unknown recall. The manufacturer was notified of the failure. The failure mileage was approximately 60,000.

Filed Jun 30, 2025 · Engine, Transmission · 126,000 miles · FL

The contact owns a 2013 Ford Focus. The contact stated that while attempting to accelerate from a stop, the transmission was slipping, with the check engine warning light illuminated. The vehicle was taken to a local dealer where the vehicle was diagnosed, and the contact was informed that the transmission was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 126,000.

Filed Jun 17, 2025 · Engine, Transmission · 103,000 miles · WI

The contact owns a 2013 Ford Focus. The contact stated while driving at an undisclosed speed and attempting to accelerate, the vehicle shuddered and hesitated. The vehicle returned to normal functionality, but the failure became a regular occurrence. The contact stated that the check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the transmission. The contact was informed that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the federal safety agency Hotline for assistance. The failure mileage was 103,000.

Filed Jun 13, 2025 · Transmission · 169,000 miles · OH

The contact owns a 2013 Ford Focus. The contact stated that while driving 70 MPH, the transmission unexpectedly shifted into neutral(N), and the message “Transmission Overheated - Pull Over for 5 Minutes” was displayed. The contact coasted to the side of the road and waited before continuing to drive. The contact stated that while attempting to restart the vehicle, the vehicle failed to start immediately, causing the contact to make several attempts to restart the vehicle. The contact stated that while driving at an undisclosed speed, the transmission was hesitating, and the vehicle was jerking while downshifting. The contact stated that the check engine warning light was illuminated. The vehicle was taken to a certified mechanic who diagnosed failures with dual clutch, engine failure, Clutch A failure, and a failure with the Transmission Control Module(TCM). The vehicle was not repaired. The dealer was contacted and confirmed that the vehicle was not included in the federal safety agency Campaign Number: 13V523000 (Power Train). The contact drove the vehicle to work and while attempting to restart the vehicle, the vehicle failed to immediately start, and the vehicle became inoperable. The manufacturer was informed of the failure and confirmed that VIN was not included in the federal safety agency Campaign Number: 13V523000 (Power Train). The manufacturer referred the contact to the federal safety agency Hotline to report the failure. The failure mileage was approximately 169,000. The VIN was not available.

Filed May 16, 2025 · Transmission · 130,000 miles · PA

The contact owns a 2013 Ford Focus. The contact stated that occasionally upon starting up the vehicle, the transmission was difficult to shift into gear. The contact stated that while attempting to reverse, the vehicle failed to respond. The contact shifted into neutral and was able to push the vehicle because the reverse(R) was inoperable. The contact stated that the check engine warning light illuminated and remained illuminated. The vehicle was taken to a local dealer where it was diagnosed, and the contact was informed that the transmission was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 130,000.

Filed Apr 29, 2025 · Transmission · 103,000 miles · WI

The contact owns a 2013 Ford Focus. The contact stated that the check engine warning light remained illuminated. The contact received notification of the federal safety agency Campaign Number: 18V735000 (Fuel System, Gasoline); and the vehicle was taken to a local dealer where the recall repair was performed. The contact was concerned that the dealer had not properly completed the recall repair. The contact stated that the recall remedy was incomplete, and that the powertrain control module (PCM) should have been updated, and the evaporative emissions canister purge valves and the evaporative emission canister should have been replaced; however, the dealer had not performed the additional repairs. The manufacturer was contacted, and the contact was informed that no additional repairs were available because the recall repair had been deemed completed. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 103,000.

Filed Mar 6, 2025 · Engine, Transmission · 24,000 miles · CA

The contact owns a 2013 Ford Focus. The contact stated that while driving at an undisclosed speed, the vehicle briefly lost motive power before suddenly jolting forward. The vehicle returned to normal functionality, but the failure became a regular occurrence. The check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed failures with the clutch, slave cylinder, and shift levelers. The vehicle was not repaired. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the federal safety agency Hotline for assistance. The failure mileage was 24,000.