I was driving to drop my fiancé off at work when the "Steering fault, Service now" warning came on. Went home, parked the car. Start it up to go pick him up later, the wheel locked and "Steering loss, stop safely" warning came on. I just recently had my car inspected and had two new lower ball joints replaced. The one employee said my cars steering was working fine, and it was driving okay with no issues until today. Same thing just happened. You can't turn the wheel.
Ford Focus ball joint problems
125 of the 22,111 owner complaints about the Ford Focus describe ball joint or control arm failure, most of them for the 2001 model year.
- owner complaints
- 125
- worst model year
- 2001
- typical repair cost reported
- $600
- typical mileage
- 30,422
By model year
Often reported together
Jerking 10Stalling 6Tire blowout 5Power steering loss 5Grinding brakes 5Pulling 4Harsh shifting 4Fuel pump 4
Trouble codes mentioned
P0457 1C1947 1B2438 1B2434 1B1881 1B1318 1
What owners say
The oil pump control arm failed. There is an open recall with no remedy. We were originally told Q2 2024 and now it's Q1 2025. This is unacceptable as this recall was issued in January 2024 with no remedy.
The contact owns a 2012 Ford Focus. The contact stated while driving 30-35 MPH, the vehicle lost power steering functionality. There was no warning light illuminated. The contact was able to veer across a parking lot. The contact stated after investigating the failure online, she turned off the vehicle for a moment. The contact then restarted the vehicle while turning the steering wheel and the vehicle responded as needed; however, the failure reoccurred increasingly while driving. The message "Loss of Power Steering Assist" was displayed. The vehicle was towed to an independent mechanic, where it was diagnosed that the electronic power steering rack and pinion and outer tie rod needed to be replaced. The contact related the failure to Ford Campaign Number: 15S08. The dealer and the manufacturer were not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 50,000.
The welded retainer of the front bushing on the right side lower (control) arm had rusted through. This allowed the control arm to separate from the frame and the right front wheel to turn outward (while I was traveling straight ahead). The drive shaft was pulled from the transmission and some parts hit the ground. Luckily, I was approaching a stop sign and traveling at less than 30 miles per hour. (The day before I was on I95 at 65 mph) Upon inspection you can see that the control arm is forged in the shape of a "C" from very thick metal where the bushing rests against the arm. However, the bushing is retained by a much thinner metal, welded across the arm forming the other side of the "C". It is that thinner welded retainer that had rusted out. We live in an area where salt is routinely used on the roads during the winter. I know the car is very old. However, this design is inadequate from a safety perspective in the Northeast.
I drive a 2002 Ford Focus Sedan. My engine light is on, warning light for trunk door ajar light is on (even though the trunk is securely locked, my front headlights due not work consistently (sometimes work, sometimes don't). My trunk does not always latch secure after I close it as well. I took my car to Advanced Auto Parts and had my engine light diagnosed. Engine codes that resulted were: B1318, B1881, C1947, B2438, B2434, P0457. The representative tested my battery and found that the voltage was slightly lower than it should be. My concern is for my safety as well as the safety of others. Do we have some manufacturer defects on this particular vehicle? Have other concerns which could be the result of vehicle wear and tear, or/and due to manufacturer defects as well. Inner tie rods need replaced as well as control arms/bushings, as reported to me by a mechanic. I have seen recall reports related to the 2002 Ford Focus in which there has been issues directly related to what I'm reporting, which is another reason I'm filing a report. Thank you. The contact wanted to add that the wipers are experiencing an electrical issue as well. When in use, the wipers cannot be switched off when it is at the highest position because it will not return in the downward position.
The contact stated that her mother-in-law owns a 2007 Ford Focus. The contact stated that while her mother-in-law was driving at an unknown speed, the front passenger’s side wheel detached from the vehicle. The vehicle was towed to the independent mechanic who diagnosed the failure as a control arm failure. The contact stated that the vehicle was repaired. The contact stated that 2 weeks later the driver’s side wheel detached. The vehicle was towed back to the independent mechanic who stated that the control arm had detached from the vehicle. The vehicle was repaired. The contact stated that 3 months later while stopped at a traffic light, the driver was unable to control the vehicle as the front passenger’s side wheel detached from the vehicle as well as the transmission slid into the engine. The transmission observation was by the tow truck company. The vehicle was towed to the owner's residence. The failure cause was not diagnosed by the dealer or an independent mechanic. The contact stated that the tow company informed her that the vehicle was unable to be towed on the flatbed due to the fact that the front end of the vehicle might detach. The contact stated that the headlights would also flicker on and off while driving. The contact stated that the independent mechanic replaced the light bulbs however, the failure continued. The manufacturer was not made aware of the failure. The failure mileage was unknown.
At 153,000 Miles my car began to slip gears in the third and 5th and the transmission and a week after that started happening I lost complete steering all steering went out the ball joint had sounded rough for a couple of days and then and just went out the car was stuck at the hospital then I was at luckily I wasn't on the main road when it happened I was in a parking lot otherwise that could have been very very bad however my car doesn't fit in your little spectrum of August 8th to whatever it was August 15th of 2014 for manufacturer date for the steering and obviously my car is over $150,000 for the powertrain either thing could cost a collision and the steering thing I could have been majorly hurt but the recall doesn't include my car
Control Arm bushings are bad.
The contact owns a 2001 Ford Focus. The contact stated that while driving her vehicle at approximately 35 MPH, the ball joint snapped on the vehicle's passengers side. The contact stated there were no warning lights illuminated nor any indication of a failure prior to the ball joint snapping. The contact stated that when the failure happened to her vehicle it caused her to crash into a ditch. The contact stated that no injuries were sustained and the vehicle was towed to the residence where it remains currently. The contact stated that she did contact the dealer as well as the manufacturer who advised her to contact the federal safety agency. The failure mileage was 190,000.
I started having a lot of issues with balance and the vehicle bouncing while driving. I replaced the inner and outer tie rods. Suddenly, on the way to get an alignment, I got a warning on my screen that stated “STEERING LOSS STOP SAFELY”. I was told by a mechanic that the electronic rack and pinion needed replaced. Doing research on this problem, I find that this is actually an extremely common issue with this year make and model. The vehicle had to be towed back to my residence costing me $125! If I had not been an experienced driver, this could have been a very deadly situation as I was traveling at 65mph at the time that I lost steering.
Related recalls
No recalls on record for this model year.
Questions about the Ford Focus ball joint
Which Ford Focus years have ball joint or control arm failure problems?
The model years with the most reports are 2001 (27 complaints), 2000 (23 complaints) and 2002 (19 complaints).
How much does it cost to fix ball joint or control arm failure on the Ford Focus?
Owners who mentioned a price put the repair at about $600 (median of 16 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Ford Focus?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history