Ford Fusion Hybrid abs comes on

Filed Oct 20, 2026 · Brakes · 210,000 miles · SC

The contact owns a 2010 Ford Fusion Hybrid. The contact stated that while driving, the ABS warning light remained illuminated, and the Service AdvanceTrac warning message remained displayed. In addition, when depressing the brake pedal to come to a complete stop, the brake pedal extended to the floor, resulting in an extended stopping distance. The contact engaged the parking brake to bring the vehicle to a stop. The vehicle was taken to an independent mechanic, where it was diagnosed that the ABS control module had failed and required replacement. The manufacturer was notified of the failure; however, no assistance was provided. The contact associated the failure with the federal safety agency Campaign Number: 19V904000 (Service Brakes, Hydraulic). The failure mileage was 210,000.

Filed Oct 7, 2026 · Brakes · MD

I own a 2010 Ford Fusion Hybrid. The vehicle has a recurring loss-of-braking problem associated with the ABS/ AdvanceTrak system. While driving, the vehicle can suddenly lose normal braking ability and does not stop as it should when I press the brake pedal. The ABS, AdvanceTrak, traction control/hydroplaning and other warning lights illuminate at the same time. I have had to use the emergency/parking brake to help stop the vehicle.The exact underlying component causing the failure is UNKNOWN. The ABS module/ ABS hydraulic control unit (HCU) has been diagnosed and replaced more than once, and the vehicle has also been repeatedly reprogrammed and diagnostic codes cleared. The vehicle has been inspected by three different Ford dealerships for the same recurring problem. The dealerships have performed diagnostic work and repairs, including replacement of ABS-related components. Most recently, 1 paid approximately $1,600 to a Ford dealership for an ABS-related repair. I was told the vehicle was repaired and picked it up on [10-6-26]. Less than 24 hours later, while driving, the vehicle again lost normal braking ability. The same warning lights appeared, including ABS and Service AdvanceTrak, and I again had to use the emergency/parking brake to stop. The vehicle is available for inspection upon request. The recurring loss of braking creates a serious safety risk to me and other road users because the vehicle may not stop normally when the brake pedal is applied. I have not had a crash or injury from this failure, but I have had to take emergency action to avoid one.The warning lights and symptoms have occurred repeatedly before and after repairs. Previous Ford dealerships have diagnosed and attempted to repair the problem, but the failure continues to return. The most recent failure occurred less than 24 hours after the last repair.

Filed Sep 11, 2026 · Brakes, Electrical · CA

While driving my 2012 Ford Fusion Hybrid (VIN: [XXX]), the braking system suddenly failed. When applying the brake pedal, there was completely zero brake resistance, and the vehicle failed to engage proper braking power, creating an extremely hazardous driving condition. The vehicle was inspected by a certified Ford dealership (Lithia), which officially documented that the vehicle is "UNSAFE TO DRIVE due to having no brake resistance." The diagnostics confirmed that the ABS Hydraulic Control Unit (HCU), the ABS module, and the Brake Master Cylinder have failed and require total replacement. The dealership also noted that the necessary braking parts are currently completely unavailable (backordered/no parts available). This is the exact same safety defect covered under Ford's previous Safety Recall 19S54 (the federal safety agency Campaign 19V904) for older Fusion models. However, the recall was never expanded to include the 2012 models, despite them using the same problematic braking infrastructure and experiencing identical catastrophic failures. the federal safety agency needs to investigate and force Ford to expand the recall to 2011-2012 models before this braking defect causes fatal accidents. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Sep 10, 2026 · Brakes, Electrical · MD

I own a 2010 Ford Fusion Hybrid and am reporting a recurring and serious braking problem. On XXX, while driving to pick up my mom and my [XXX] son, I pressed the brake pedal to stop, but the vehicle did not stop normally. I repeatedly tried to brake, but the vehicle took much longer to stop than it should have. The brake pedal became spongy and did not have normal resistance. The BRAKE, ABS, and AdvanceTrac warning lights appeared. The vehicle’s computer/system was reset afterward, and the vehicle drove normally for several days. On XXX, the same braking problem happened again while i was driving to go pick up my [XXX] son from school. The brake pedal became spongy, and repeatedly pumping the brakes did not properly stop the vehicle. This time I had to use the emergency/parking brake to help bring the vehicle to a stop. The same BRAKE, ABS, and AdvanceTrac warning lights appeared.After this incident, the rear brakes were replaced and a new ABS Anti-Lock Brake Pump (part number 9E58-2C555-AF) was installed. The computer/system was also reset again. On XXX, the BRAKE, ABS, and AdvanceTrac warning lights came back on again despite the new brake components and computer reset. The mechanic who performed the repairs has been unable to determine the cause, so the vehicle is being taken to another repair shop for further diagnosis. I am concerned that this may be a safety defect involving the braking/ABS system of the 2010 Ford Fusion Hybrid. The vehicle has experienced an actual loss of braking ability, including an incident where I had to use the emergency/parking brake to stop. I am requesting that the federal safety agency investigate this issue. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Jul 27, 2026 · Brakes · CA

SUBJECT: Fraudulent Recall Completion / Incomplete Remedy resulting in Component Failure (Recall 19S54 / the federal safety agency 19V904) I am writing to file an emergency safety complaint regarding a fraudulently cleared safety recall on my 2010 Ford Fusion Hybrid. According to Ford's internal OASIS database, Safety Recall 19S54 (the federal safety agency Campaign 19V904) was marked as "completed" under a previous owner. However, physical inspection of the vehicle proves that the mandatory federal remedy was never executed. The master cylinder still retains the original factory DOT 3 cap, and the system was never upgraded to DOT 4 fluid. Because the servicing dealership falsified the repair documentation and left the corrosive DOT 3 fluid in the system, my vehicle has now suffered the exact catastrophic safety failure the recall was meant to prevent. The ABS Hydraulic Control Unit (HCU) internal valves have seized. The brake pedal is heavily compromised, and the vehicle is an active, severe safety hazard to drive. I am the second owner of this vehicle. I unknowingly purchased a car with a fraudulently cleared safety defect. Because this failure is a direct result of an incomplete federal safety recall remedy, I demand that Ford Corporate reopen this VIN file under "Related Damage / Incomplete Remedy." I require Ford to: 1. Arrange a complimentary tow to a certified Ford dealership. 2. Replace the ruined ABS/HCU module entirely free of charge. 3. Perform the mandatory DOT 4 pressure flush and install the correct reservoir cap. 4. Provide a complimentary rental car while this safety hazard is being resolved. I have taken photographic and video evidence of the DOT 3 cap and the failed braking system to support my legal claims. Fairway Ford of Yorba Claimed it had already been done when clearly it hasn't and pushed it off like nothing.

Filed Jul 2, 2026 · Brakes · CA

Abs module failed

Filed Jun 16, 2026 · Brakes, Electrical · MO

There have been many recalls on the 2010 Ford Fusion Hybrid, according to Ford mine has already had the repairs done yet the issues I’ve been having all match recalls. I’ve had issues with my passenger seat, the air bag system light is always on and the seat controls no longer work. The clockspring system is pure trash, there is no reason I’ve had to replace it twice now in the 2 months I’ve had this car. My ABS system keeps going in and out and says service advancetrac system. My hybrid battery rarely goes into hybrid anymore causing my mpg to drop. There were a few other things but that’s what’s coming out mind now.

Filed Aug 23, 2025 · Brakes, Electrical · TX · crash

I am reporting a serious safety issue with my 2018 Ford Fusion Hybrid SE that affects the braking system and related electronics: 1.The ABS stopped functioning previously. 2.Recently, the car displayed a “Brake Malfunction” warning for the first time, which appears when making sharp turns. 3.The TPMS (tire pressure monitoring system) stopped working some time ago. These issues are extremely dangerous. The electronic brake booster and ABS module are critical for safe braking, especially in emergency situations. With the ABS and brake assist compromised, the pedal can suddenly become rock hard or soft, stopping distance increases dramatically, and traction control/ABS is unavailable during hard braking. I am concerned this is a systemic issue with the 2018 Ford Fusion Hybrid SE braking system and not isolated to my vehicle. This failure could put drivers, passengers, and others on the road at serious risk. I request that the federal safety agency investigate this issue for potential recall action to protect the safety of drivers nationwide.

Filed Apr 8, 2025 · Brakes · 100,000 miles · WA

The contact owns a 2010 Ford Fusion Hybrid. The contact stated that upon coming to a complete stop, the brake pedal suddenly depressed all the way to the floorboard. The contact became aware that the brakes were no longer functioning properly. The vehicle returned to normal functionality, but the failure became a regular occurrence. The ABS and traction control warning lights were illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. After investigating the failure, the contact related the failure to the federal safety agency Campaign Number: 19V904000 (Service Brakes, Hydraulic). The manufacturer was notified of the failure, and a case was opened. The failure mileage was 100,000.

Filed Mar 18, 2025 · Brakes · 162,000 miles · CA

The contact owns a 2010 Ford Fusion Hybrid. The contact stated that while driving 15 MPH and depressing the brake pedal, the brake pedal went to the floorboard. The contact stated that the brake system, ABS, and traction control warning lights were illuminated. Additionally, the message "Brake System Failure" was displayed. The contact drove with caution to the residence, and then had the vehicle towed to an independent mechanic to be diagnosed. The contact was informed that further diagnostic testing was needed to determine the cause of the failure. The vehicle was not repaired. The contact referenced the federal safety agency Campaign Number: 19V904000 (SERVICE BRAKES, HYDRAULIC) as a possible cause for the failure. The manufacturer was notified of the failure. The approximate failure mileage was 162,000.