While driving, I attempted to depress my clutch pedal in order to bring my vehicle to a stop. My clutch pedal only went halfway to the floor. I was able to force it down to the floor using a higher than usual amount of force. After bringing my vehicle to a stop I inspected my clutch pedal and found that it had side to side play resulting from a cracked weld where the clutch pedal was welded to a shaft on the clutch/brake pedal assembly. Upon further research online I discovered that other owners of similarly aged mustangs have had identical issues to what happened to me.
2015 Ford Mustang brakes problems
51 complaints (12% of all complaints for this car). Typical mileage when it fails: 22,943. 6 crashes reported.
- owner complaints
- 51
- of this car's complaints
- 12%
- typical mileage
- 22,943
- crashes
- 6
- recalls
- 2
Which part fails
- Pedals and linkages2
At what mileage
Complaints by mileage at the time of the problem.
0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+
Ford Mustang brakes problems in other years
Specific symptoms reported on the 2015 Ford Mustang brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Service brakes, hydraulic: pedals and linkages
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2014-2015 Fusion, Lincoln MKZ, and 2015 Mustang vehicles originally sold or ever registered, in Texas, Louisiana, Mississippi, Alabama, Florida, Georgia, South Carolina, North Carolina, Virginia and Hawaii. Exposure to certain environmental conditions, such as high temperatures, high humidity, and salt air can cause the brake pedal bumper to corrode and separate from the brake pedal.
- Risk
- A separated brake pedal bumper can cause the brake lights to illuminate continuously, causing confusion to other drivers and increasing the risk of a crash. On automatic transmission vehicles, a missing brake pedal bumper can allow the driver to shift the vehicle out of the "PARK" position without depressing the brake, allowing the vehicle to rollaway, increasing the risk of injury.
- Remedy
- Dealers will replace the brake pedal bumpers and clutch pedal bumpers, free of charge. Interim owner notification letters notifying owners of the safety risk were mailed on March 4, 2022. Owner notification letters were mailed on June 13, 2022. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 22S02.
Recall number 22V011000 · Recall details
Service brakes, hydraulic: foundation components: disc: caliper
- What is wrong
- Roush Performance Products, Inc. (Roush) is recalling certain model year 2015 Ford Mustang GT Roush Stage 3 vehicles manufactured April 1, 2015, to October 31, 2015, and equipped with Roush Extreme Duty Half Shafts. The affected vehicles have a brake caliper guide pin that may not have been sufficiently tightened during installation of the half shafts. As a result, the caliper guide pin may loosen while driving, reducing the vehicle's rear braking ability.
- Risk
- A partial loss of the rear braking system can increase the risk of a crash.
- Remedy
- Roush will notify owners, and Roush-authorized Ford dealers will tighten the caliper guide pin to the proper specification, free of charge. The recall began in February 2016. Owners may contact Roush customer service at 1‑800‑597‑6874.
Recall number 15V832000 · Recall details
What 2015 Ford Mustang owners say
Most recent owner complaints, unedited.
The contact owns a 2015 Ford Mustang. The contact stated that while driving 35 MPH and attempting to depress the brake pedal, the clutch pedal detached from the brake pedal assembly. Neither an independent mechanic nor a dealer was contacted. The vehicle was not taken to a dealer or independent mechanic to be diagnosed. The vehicle was not repaired; however, the vehicle was in the process of being repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 115,724.
The contact owns a 2015 Ford Mustang. The contact stated that the brake pedal bumper fractured, and the brake lights illuminated. The contact stated that the failure caused the battery to become drained. The accelerator pedal was stuck and drained the battery. The contact stated that the failure was related to the federal safety agency Campaign Number: 22V011000 (Service Brakes, Hydraulic). Additionally, the contact resides in North Carolina but had not transferred the New York vehicle registration. The contact called the local dealer and was referred to the manufacturer for assistance. The vehicle was not diagnosed or repaired. The manufacturer was contacted and referred the contact to the federal safety agency Hotline for assistance. The failure mileage was approximately 76,000.
While driving home, driving speed was 55 mph, car engine bogged down and orange wrench icon illuminated on dash. I was not far from home and was able to continue and "limp" home. Car would not go faster than 10-15 mph. When I parked car in garage and shut car off, the brake lights stayed on. There was no warning lights or anything wrong with car before incident. Car has not been inspected by dealer or service center. Doing further research online, I was directed to look at drivers floorboard for plastic pieces. I did find broken, yellowish colored plastic pieces on floor board. According to others, which have been experiencing the same issue, the brake light switch stop bumper pad has failed. I was able to find a recall (Safety recall 22S02) that has been issued for this problem, but the recall is region specific. I do not live in the regions listed in recall.
Brake lights don’t function brake switch bumper broke off and lights stay on but not bright when brake is depressed. Loss of power random misfire cut from loss of power. Brake switch fault in computer
There is a break pedal pad that is broken. It doesn't allow the car to accelerate correctly and car goes in limp mode. All break lights are illuminated when car is turned off. There is a recall for this, but I purchased my car in CA. I think the car was originally a Nevada car. Am I still eligible for the recall even if I didn't get the notification and my state of purchase was not mentioned?
Hi, I was driving on the freeway and suddenly my car stopped accelerating. I would push the acceleration pedal but it wouldnt speed up. And for a few times it would speed up very much. This was very rapid fluctuation. I also noticed that the cruise control was not working. This was very scary being on the highway with this kind of speed fluctuation. After i came back home, i noticed that the brake light wouldnt turn off at all. After doing some research i found that the brake light switch broke and the car was sensing that the brake was being applied and hence was doing acceleration fluctuations. I also found out that there are many other same vehicles which has the same issue.
Related to Regional Recall 22R01, the rubber bumper on my brake pedal that engages the brake light switch failed and placed the vehicle in a low power mode. This failure occurred while merging onto the interstate and almost resulted in my being rear-ended by a semi truck. Having never been notified of this regional recall, I was able to verify this was the case after searching forums and YouTube and identifying the pieces of the broken bumper in my floorboard. I find it to be HORRENDOUSLY unacceptable that this was allowed to be handled as a regional recall and no notice was ever produced, as it is a safety-related issue that could have resulted in grievous bodily harm. I am located in Kentucky, which is not part of the named region.
I was driving home from work and all the sudden it went into limp mode, I could barely get her home. Then I found yellow pieces of plastic in my floorboard. My brake light would not go off so I had to unplug the battery. Very scary to have that happen on the interstate, luckily I got off on an exit.
The brake pedal stop bumper in my car disintegrated in the middle of the day and fell off. The brake lights do not turn off anymore and the vehicle can be started and shifted without needing to press the brake. I found a recall # 22S02 for this exact issue but my vehicle is not covered by it (assuming due to region). The vehicle has not been inspected yet.
Questions about the 2015 Ford Mustang brakes
Does the 2015 Ford Mustang have brakes problems?
Owners have filed 51 complaints about the brakes of the 2015 Ford Mustang, 12% of all its complaints.
At what mileage do 2015 Ford Mustang brakes problems start?
The typical (median) mileage in owner complaints is 22,943 miles.
Was there a recall on the 2015 Ford Mustang brakes?
Yes, 2 recalls: 22V011000, 15V832000. Check your VIN to see if your car still needs the free repair.
What year does the Ford Mustang have bad brakes?
The Ford Mustang model years with the most brakes complaints are 2000 (63 complaints), 2015 (51 complaints) and 1999 (44 complaints).
Other 2015 Ford Mustang problems
Electrical 68Engine 51Driver assistance 50Body 45Lights 42Transmission 42Fuel system 32Airbags 23Locks 21Steering 18Wheels 16Acceleration 15Visibility 15Seat belts 10Seats 10Suspension 9Tires 2
VIN decoder
See the problems and recalls for an exact car
Buying a used 2015 Ford Mustang?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history