The cooling fan clutch control wire is supported by a "wire support hose" between the engine block and the fan clutch. the cooling fan clutch control freely rotates on a raceway on the drive shaft. The purpose of the support hose is to prevent the fan clutch control from freely rotating, but allows the control a limited range of movement as the drive shaft changes speed with engine RPM. The idea is that this hose prevents undue stress on the control wire. Hose is normally a consumable part that may need replaced with age, heat, etc. The hose is not sold as a replacement part and can only be obtained by purchasing a new fan clutch. When the hose fails, the control wraps around the drive shaft causing damage to the fan clutch control and wiring requiring replacement. The circuit on which the fan clutch control sits is integrated with no less than 6 other critical vehicle systems including oil pressure. When the incident occurs, all these systems generate errors that put the vehicle into limp mode until repair can be made. The fan clutch control wiring support hose should be a bracket with a different mechanical linkage solution to support wire while allowing the necessary limited movement. This low-tech hose solution causes outsized damage when it fails, effectively disabling the vehicle which creates a safety concern and undue hardship from an unnecessarily cascading damage effect. Ford acknowledges this defect by redesigning this feature for 6G Rangers but will not proactively correct through manufacturer recall 5G Rangers. If Ford will not correct, I believe the federal safety agency should get involved and force Ford's hand at addressing this repair.
2019 Ford Ranger: stuck in gear or won't shift
6 of the 272 complaints about the 2019 Ford Ranger describe stuck in gear or won't shift.
- owner complaints
- 6
- of this car's complaints
- 2%
- recalls
- 2
Stuck in gear or won't shift by model year
- 20251
- 20241
- 20214
- 20202
- 20196
- 20112
- 20041
- 20032
- 20022
- 20013
- 20005
- 19992
- 19931
- 19921
What owners say
Truck has issue with crank position sensor issue caused due to defective design of on 2.3l ecoboost first incident shut off at 65 mph took the dealer was told it was defective crank position sensor second time a month later same thing happens third time three or four months later happens again take the dealer this time they said that it was oil permeation on the sensor itself said it was due to leak in front timing cover of motor whereas oil had ripped onto the sensor causing it to not be triggered therefore shutting down the truck completely no limp mode just dead no power also lost all systems including adaptive cruise control, anti-lock brakes, traction control, power steering, forward radar everything!! luckily all three times that this has happened have managed to not crash or get hit in the process of malfunction.my complaint is that this is a four-wheel drive truck and if the sensor is that touchy then maybe they should have shielded it now dealers requesting $2,200 to fix problem after already paying $1500 the first time to have it fixed
The vehicle skips gears when upshifting and does not shift through all the gears when in cruise mode. The truck will buck and bang jolting the passengers and appear to stall out without any warning. This has happened on numerous occasions and has even stalled out in the middle of a very busy intersection almost causing a collision by the truck not having enough power to coast through the intersection. Based on conversations with the dealership, this is not an isolated issue with our vehicle.
2019 Ranger went into limp mode in traffic at the worst possible time. Error code appeared and referred to transmission fault at roughly 38k. Was taken to ford and I was told PCM just needed updating. By 45k the transmission was right back to shifting rough with sudden shifts jerking the truck. Called Ford to say hey it’s not right still. It’s continuing to downshift from 10th gear at 65mph instantly down to 3rd gear nearly ripping the transmission out. Every Ford dealership within 3.5hrs from me all told me the same thing. “We are told to say it’s normal for the 10r80 to do hard shifts. Ford knows they are a problem but want issue a recall, the only thing you can do it blow up the transmission while your under 60k warranty so they have no choice but to replace it.” Now at 80k I’m screwed and have to spend nearly 8k to fix the transmission ford said was fine.
This truck we have had in the shop for the transmission 5 different times the truck at all different speeds jerks like the gear is not igniting in then starts to shake the shop has reported that it does not shift properly then yesterday Dec 24th, 2022 the trucks wrench came on the breaks locked up and the power train locked up I have all documents we purchased the truck in March 2022 and have been having this transmission issue since I have contacted Ford numerous times and also emailed numerous times the dealership we purchased the truck from has done nothing except keep reprogramming the computer in the system which is not the issue the transmission is under warranty to 60000 miles and we have been having this issue since June 2022. Now that everything locked up on the vehicle we are not safe to even take the truck out on the road we do not want to get injured no the defective issue causing an accident and someone else getting injured. Ford has done nothing to fix or solve the issue at this point the vehicle has 59105.3 miles on it should not be having these issues and the dealership automotive repair shop not fixing the issue at this point need to buy this vehicle back and not sell it it is to dangerous and can cause injuries. We have been trying since June 2022 to get this truck fixed. 3 months after purchasing it and sales rep that sold it to us at Parkway Nissan, Ford Chrysler just says have to take it to their shop which has not done a thing to fix the issue. 12/24/2022 the power train wrench light came on breaks locked up we had a hard time to even start the truck then the breaks was not properly working and started making a noise.
I am certain my vehicle does not shift correctly. It often seems to be in the wrong gear for the terrain and according to the dashboard seems to skip gears. Also it seems to not get the power to the road as if the transmission slips. It is intermittent. The start stop feature which I usually turn off, sometimes does not work correctly. I have only had this vehicle for about 5 months. When the start stop feature is off the vehicle still acts as if its on. I have read blogs of many people having similar transmission issues. A local Ford dealer told me it drove fine, nature of the beast and it shifts that way to save fuel. Also on off the gas there is a hard clunk which seem to harsh. I feel like at some point something is going to fail.
Service bulletins that may apply
- For 20172026 vehicles equipped with a 10R transmission, a revision to the Road Testing Vehicle procedure...
- Various vehicles equiped with 10R80/10R80 MHT/10R100/10R140 transmissions may require replacement of the...
- This article supersedes TSB 24-2046 to update the Service Procedure LTIS statement
- Harsh/delayed engagement and/or harsh/delayed shift, an illuminated malfunction indicator lamp (MIL) with...
- Whine noise at idle and/or while driving
- This article supersedes TSB 22-2428 and 23-2176 to update the Issue, Action and Service Procedure
- Shudder/vibration when accelerating
- Harsh/delayed engagement and/or harsh/delayed shift
Related recalls
Power train: automatic transmission: lever and linkage: floor shift
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2019 Ranger vehicles. The fasteners that attach the transmission shifter cable bracket to the transmission may loosen allowing the transmission to be in a different gear than indicated by the gear shift lever position.
- Risk
- If the gear shift lever position does not match the actual transmission gear, the vehicle may move in an unexpected direction. Additionally, despite selecting 'Park', if the parking brake is not applied before the vehicle is exited, the vehicle may roll. Either scenario increases the risk of crash or injury.
- Remedy
- Ford will notify owners, and dealers will inspect and tighten the transmission shift cable bracket fasteners as necessary, and verify the proper transmission shift operation, free of charge. The recall began July 1, 2019. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 19S15.
Recall number 19V366000 · Recall details
Power train: automatic transmission
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2019 Ranger vehicles equipped with 10-speed automatic transmissions. In some of these vehicles, the transmission shift lever can be moved from the "Park" position without the key in the starting system and without depressing the brake pedal. As a result, these vehicles fail to comply with Federal Motor Vehicle Safety Standard (FMVSS) number 114, "Theft Protection."
- Risk
- If the vehicle can be shifted out of Park without the brake applied, the vehicle may unexpectedly move. Unintentional vehicle movement can increase the risk of injury or crash.
- Remedy
- Ford has notified owners, and dealers will inspect and repair the transmission floor shift selector interlock assembly, as necessary, free of charge. The recall began February 22, 2019. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 19C02.
Recall number 19V071000 · Recall details
Questions about the 2019 Ford Ranger won't shift
Is stuck in gear or won't shift a common problem on the 2019 Ford Ranger?
6 of 272 owner complaints about the 2019 Ford Ranger (2%) mention stuck in gear or won't shift. The model year with the most reports is 2019.
Is there a recall or service bulletin for this on the 2019 Ford Ranger?
There are 2 recalls and 25 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2019 Ford Ranger
Jerking 25Harsh shifting 22Check engine light 15Loss of power 12Sudden acceleration 12Slipping 11Stalling 11Transmission failure 11Backup camera 9Hesitation 9Adaptive cruise 8Misfire 8Collision warning 6Engine failure 6No deployment 5Grinding brakes 5Knocking 5Fire or smoke 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2019 Ford Ranger?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history