Dt*: the contact stated while driving 5 MPH, the brake pedal was depressed and there was no brake pressure. This occurred with no warning. The transmission was put into low gear and the engine was turned off. The vehicle was towed to the dealership, where it was determined the proportioning valve failed causing a rupture in the brake line and loss of brake fluid. The valve and brake line are being replaced.
1995 Ford Taurus: brake failure
12 of the 1,202 complaints about the 1995 Ford Taurus describe brake failure.
- owner complaints
- 12
- of this car's complaints
- 1%
- recalls
- 1
Is there a fix? There is 1 recall and 13 service bulletins for this area of the car. See below
Brake failure by model year
What owners say
While driving 55 MPH driver applied brake and pedal went to the floor. Driver was able to pull over by using the emergency brakes. Consumer had vehicle towed to the dealer for analysis, and mechanic noticed that the brake line wire broke. Also, rotors needed to be replaced.
Consumer applied brakes at 40 MPH, brake pedal went to the floor. Consumer was able to stop vehicle after pumping brakes. Mechanic determined that brake lines were deteriorating and leaking brake fluid. Two months after brake line repairs, consumer noticed leak again.
Brakes stopped working properly and started making a squeaking noise. Took vehicle to mechanic, they adjusted brakes, and replaced pads. This problem occurred every six months.
1. Radiator - failed due to design defect in plastic to aluminum core joint, causing loss of coolant, replacement failed within one day. Replacement for that one lasted only about 20,000 additional miles, so a total of three identical radiator failures with loss of coolant in about 25,000 miles on the same car. Same problem on son's 1995 taurus sedan with same engine. Original radiator failed, replacement failed within 1,000 miles of installation. This experience seems to indicate a fundamental design defect in the taurus radiator. 2. Brake failure. Defect in design of rear calipers used with ABS system on the taurus results in rainwater intrusion causing rusting of caliper pins that then impedes proper retraction of the brake pads. Excessive pad wear results in metal to metal contact between the caliper piston and the pad backing plate with greatly reduced braking efficiency.
While driving and applying the brakes pedal goes all the way to the floor, and the brakes begin to shake violently.dealer was contacted, and stated that this was a very common problem.
Attempted to stop vehicle at an exit into an intersection and brakes failed. Vehicle lost control and went into intersection, but there were no other vehicles there. Put vehicle in reverse to stop it.
Brake failure caused consumer to have an accident. Tt
Abs, failure of the ABS systems, and computer sensor failure, pedal went to the floor, to stop vehicle use the emergency brake to stop vehicle. Tt
The disc brakes failed and caused an accident. Please describe. Tt
Brakes failed, causing accident.
Abs brakes failure. Tt
Service bulletins that may apply
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Some vehicles may cycle when brakes are applied on rough roads or on an incline while making a sharp turn
- Service tip information regarding elimination of sanding rotors and drums
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- A squealing noise may come from the rear brakes on some vehicles when braking
- Availability of hub-mount brake rotor machining equipment
- Subject regarding the availability of hub-mount brake rotor machining equipment
Related recalls
Service brakes, hydraulic: pedals and linkages
- What is wrong
- The retainer clip which holds the master cylinder push rod to the brake pedal arm is missing or not completely installed. The push rod can separate from the brake pedal arm.
- Risk
- This can result in loss of braking ability and an accident.
- Remedy
- Dealers will inspect and, if necessary, install the retainer clip.
Recall number 94V198000 · Recall details
Questions about the 1995 Ford Taurus brake failure
Is brake failure a common problem on the 1995 Ford Taurus?
12 of 1,202 owner complaints about the 1995 Ford Taurus (1%) mention brake failure. The model year with the most reports is 1998.
Is there a recall or service bulletin for this on the 1995 Ford Taurus?
There is 1 recall and 13 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1995 Ford Taurus
Stalling 73Overheating 54Fire or smoke 33Engine failure 32Coil spring 29Fuel pump 26Transmission failure 26Adaptive cruise 25Jerking 25No deployment 22ABS 18Loss of power 16Slipping 16Grinding brakes 15Sudden acceleration 15Tire blowout 15Power steering loss 14Won't start 14Airbag light 11Wipers 10Headlights 9Door locks 8Harsh shifting 8Won't shift 8Hesitation 7Steering lock-up 7Check engine light 6Knocking 6Pulling 6Fuel smell 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Ford Taurus?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history