I purchased my vehicle used in 2019 and immediately noticed a loud creaking noise from the front passenger area, especially in colder weather when driving over bumps at low speeds. By 2024, the noise became louder, more frequent, and occurred in all temperatures. In October 2024, I lost control of my vehicle and nearly flipped. Warning lights briefly appeared, indicating possible suspension issues, but they disappeared before I could diagnose the problem. Unfortunately, I had no choice but to continue driving despite the safety risk. In February 2025, I had a flat tire on the front passenger side and discovered it was nearly bald—far more worn than the other tires of the same age. Upon removal, it became clear that the front lower control arm was in a dangerously unnatural state and needed replacement. I recalled seeing a 2012 recall for this exact part in my Honda account, but when I entered my VIN, it stated the recall didn’t apply—likely due to age rather than the actual defect. This is a life-or-death issue that could easily lead to a fatal crash. Honda must address this immediately.
2006 Honda CR-V: ball joint or control arm failure
7 of the 398 complaints about the 2006 Honda CR-V describe ball joint or control arm failure.
- owner complaints
- 7
- of this car's complaints
- 2%
- typical mileage
- 92,000
- recalls
- 1
Ball joint or control arm failure by model year
What owners say
The contact owns a 2006 Honda CR-V. The contact stated that while driving at an undisclosed speed and attempting to complete a right turn, he heard an abnormal popping sound coming from the front passenger’s side of the vehicle. The contact also stated that while driving over a bump, the vehicle briefly drifted to the right. No warning lights were illuminated. The vehicle was taken to an independent mechanic, who diagnosed a failure with the passenger’s side front lower control arm. The vehicle was not repaired. After investigating the failure, the contact related it to the federal safety agency Campaign Number: 12V124000 (Suspension), but the VIN was not included. The manufacturer was notified of the failure but referred the contact to the federal safety agency hotline for assistance. The failure mileage was 178,000.
Honda dealer in flagstaff, az, indicated that the front compliance bushings are torn on my2016 honda crv and need to be replaced. I have learned that the honda bushings are not made of a solid/quality component and are failing at unusual rates which equate to unsafe driving and costly repair for the consumer. Is there a concern for suspension/alignment and steering problems due to torn bushings and is this related to the control arm bushing recall for honda crv 2006 id#12v124000?
Tl* the contact owns a 2006 honda cr-v. The contact stated that the vehicle was taken to the dealer to be serviced under the federal safety agency campaign number: 12v486000 (electrical system, visibility) when the technician alerted the contact that the stamp on the passenger-side front lower control arm was fractured and needed to be replaced. The technician made the contact aware that recall the federal safety agency campaign number: 12v124000 (suspension) was related to the failure but the vehicle was not included. The vehicle was repaired. The manufacturer was made aware of the failure. The failure mileage was 65,022.
I took my vehicle to the honda dealer for its 90,000 service. At this time honda dealer recommended work but did not perform replace front lower arm compliance bushing, ball joints boot torn. Honda did not mention the federal safety agency campaign id 12v12400, (suspension front control arm lower arm). I felt like the honda rep did not explain my options, and did not listen to my concerns. I had it repaired at another auto care center. On 9-13-2012, the AC system went, compressor locked up. It needed an entire new AC system. At this time, the mechanic made me aware of the federal safety agency campaign id 12v12400 as well as many complaints on line of honda AC compressor problems and the class action lawsuit (now over). One part ruined the entire AC system. Honda was less than honest in wanting to charge me for the suspension front control arm lower arm). These repairs totaled $2500.
Tl* the contact owns a 2006 honda cr-v. While driving approximately 50 MPH, the contact drove over a road bump and the front passenger side of the vehicle began to vibrate and jerk to the right. The vehicle was not taken to the dealer for diagnostic testing. The contact referenced the federal safety agency campaign id number: 12v124000 (suspension:front:control arm:lower arm) but was advised by the manufacturer that the VIN was not included in the recall. The vehicle was not repaired. The approximate failure mileage was 114,000.
2006 honda cr-v. Consumer states lost control of vehicle while driving *tgw the consumer stated he had to struggle to keep the vehicle on the road. Fortunately, he was able to direct the vehicle onto a wide, grassy patch and bring it to a stop. Upon inspection of the front wheel assembly, it was apparent the entire right front suspension, including the axle had come loose and were resting on the underside of the fender. The consumer has since received a recall letter regarding a problem with the control arm.
Service bulletins that may apply
Related recalls
Suspension: front: control arm: lower arm
- What is wrong
- Honda is recalling certain model year 2006 cr-v vehicles. The weld strength attaching the sub-frame bushing collar to the passenger-side front lower arm is insufficient. The collar can separate from the arm due to vibration while driving.
- Risk
- As a result, a loss of steering can occur, increasing the risk of crash.
- Remedy
- Honda will notify owners, and dealers will inspect the production lot stamp on the passenger-side front lower arm and, if necessary, replace the lower arm, free of charge. The safety recall is expected to begin on or about april 17, 2012. Owners may contact honda customer service at 1‑800‑999‑1009.
Recall number 12V124000 · Recall details
Questions about the 2006 Honda CR-V ball joint
Is ball joint or control arm failure a common problem on the 2006 Honda CR-V?
7 of 398 owner complaints about the 2006 Honda CR-V (2%) mention ball joint or control arm failure. The model year with the most reports is 2006.
Is there a recall or service bulletin for this on the 2006 Honda CR-V?
There is 1 recall and 1 service bulletin for the same area of the car. Check them below with your VIN.
Other symptoms on the 2006 Honda CR-V
Headlights 116ABS 21No deployment 12Fire or smoke 11Seat belt 8Stalling 8Sudden acceleration 8Jerking 7Check engine light 6Pulling 6Airbag light 5Tire blowout 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Honda CR-V?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history