Rusted rear strut mount causing a rear wheel "thump" Heard on mild to severe road ruts. Repair shop reported possible "control arm support" rust.
2011 Honda CR-V: ball joint or control arm failure
6 of the 555 complaints about the 2011 Honda CR-V describe ball joint or control arm failure.
- owner complaints
- 6
- of this car's complaints
- 1%
- recalls
- 0
Ball joint or control arm failure by model year
What owners say
The contact owns a 2011 Honda CR-V. The contact stated while driving 60 MPH, the rear driver's side wheel, the lower control arm, and the axle detached, causing the contact to almost lose control of the vehicle. The contact was able to veer to the side of the road. The vehicle was towed to the residence. The dealer was notified of the failure and informed the contact that the VIN was not included in a recall. The contact later received notification of the federal safety agency Campaign Number: 23V228000 (Structure) and contacted the manufacturer for the recall repair. The manufacturer advised the contact to tow the vehicle to the dealer. The vehicle was towed to the local dealer, where a regional field inspector from Honda determined that the vehicle was beyond repair due to severe frame corrosion. The manufacturer opened a case. The contact stated that the recall remedy also involved buying back the vehicle if the vehicle was beyond repair; however, the contact had not received a call back from the manufacturer since April 2023. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 115,000. Parts distribution disconnect.
Wheels are significantly misaligned causing tire wear and vibration while driving. Rear struts need to be replaced and are not functioning properly. Rear control arm needs to be replaced with adjustable control arm to achieve proper alignment. Wheel alignment is more that 2 degrees off with normal vehicle usage.
The contact owns a 2011 Honda CR-V. The contact stated while pulling forward at approximately 3 MPH, into his driveway, after the rotors, calipers and brake pads were replaced; there was an abnormally loud bang heard. The contact stated that the rear driver's side control arm had sheared off. The contact stated that the drivers' side wheel was almost detached from the axle. The contact became aware of extensive rust on the rear frame and suspension. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed nor repaired. The manufacturer had not been informed of the failure. The failure mileage was approximately 192,000. The VIN was not available.
2011 Honda CR-V. Excessive rear frame corrosion resulted in rear control arm separation from vehicle. This was subject of recall in Canada but Honda USA not recalling here (upstate NY). Honda has recalled the Ridgeline and Element for very similar issue. The Issue caused me to almost crash and could have been injured. Rear driver side wheel came loose and went sideways causing me to skid off road. Passenger side of vehicle is near failure also. Vehicle gave no indication of failure before it happened. I had recently had wheel alignment and annual NYS safety inspections. Have been talking to Honda and dealer for 5 months. Refusing to help.
I was on the highway driving straight and steady. The driver side rear wheel/ lower control arm went to a 30 degree angle and pulled the axle from the rear differential. The wheel locked up and the vehicle was very difficult to control. I skidded to the shoulder leaving a 400 foot skid mark. Thankfully there was no one near me as traffic was very light. If road or traffic conditions were any worse there would almost certainly been a serious accident. I have extensive mechanical experience and have never seen a 11 year old vehicle fail from corrosion in this manor. There is a recall in Canada for this exact issue and Honda is/has helped repair/replace many there vehicles with this issue. It has been inspected by NYS inspectors annually and never raised any flags. I was never notified by honda to check to check for this issue and the dealership it was bought from is refusing to help. The 2011 Crv appears relatively rust free other than the area that failed and the other side almost as bad. This is a serious safety issue and Honda needs to do something to prevent future injuries and deaths. This failure happened with no warning at all. Thank you.
Related recalls
No recalls on record for this model year.
Questions about the 2011 Honda CR-V ball joint
Is ball joint or control arm failure a common problem on the 2011 Honda CR-V?
6 of 555 owner complaints about the 2011 Honda CR-V (1%) mention ball joint or control arm failure. The model year with the most reports is 2006.
Is there a recall or service bulletin for this on the 2011 Honda CR-V?
There is no recall or service bulletin for this area of the car on record.
Other symptoms on the 2011 Honda CR-V
Door locks 27Oil consumption 17Key fob 14Check engine light 13Airbag light 10No deployment 9Sudden acceleration 9
VIN decoder
See the problems and recalls for an exact car
Buying a used 2011 Honda CR-V?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history