2020 Honda Pilot: engine knocking or ticking

Filed Sep 10, 2026 · Engine · GA

After previously reporting that a connecting rod bearing noise developed after the timing belt maintenance package was performed near 100,000 miles, the connecting rod bearings failed around 3,000 miles later while going down the interstate with children in the car. Thankfully the Pilot, which was shaking and making noise, was able to be pulled over to side of the interstate and later towed to the dealer service. No symptoms other than the noise at low speeds usually from take off, which regional Honda said wouldn’t damage anything, but apparently it did.

Filed Jul 20, 2026 · Engine · 46,500 miles · TX

The contact owns a 2020 Honda Pilot. The contact stated that after starting the vehicle, there was an abnormal ticking sound coming from the engine. The vehicle was taken to the local dealer, who examined the engine and discovered metal shavings inside the oil pan and there was engine rod bearing damage. The contact was informed that the engine needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was provided. The contact was informed of the federal safety agency Action Number: PE25008 (ENGINE). The contact stated that the vehicle had experienced the failure listed in the federal safety agency Action Number. The failure mileage was 46,500.

Filed May 7, 2026 · Engine · GA

Per Honda, the standard maintenance of replacing a timing belt and tensioner has put more tension on the crankshaft, which causes a tapping noise from the connecting rod bearings when the vehicle is accelerating under load. The vehicle is available for inspection upon request. Honda has said that this does not harm the engine, but a noise of this kind is not normal and any noise of this kind associated with this particular part of the engine has the possibility of degrading the engine's life and causing a potential safety issue while driving down the road. Yes, the problem has been reproduced by the dealer. Dealer service department has been the only one to inspect it. No, there were no warning lamps, messages, or other symptoms of the problem prior to the failure. The issue first appeared right after getting the mandatory timing belt maintenance when driving away from the dealer service department.

Filed Dec 31, 2025 · Engine · OH

There was a snap like sound under my hood while driving. Shortly after, the check engine light engaged and the vehicle lost all ability to accelerate. This happened while merging onto a fairly busy road, with rolling hills. If there were vehicles around there would have been potential for an accident. If this happened on the freeway in a middle lane, the vehicle would not have been able to successfully exit without causing extreme danger to the passengers and other vehicles. The vehicle stopped on the side of the road. When the ignition was briefly reengaged, there were rolling error codes, including vehicle stability, all wheel drive failure, etc. The engine was noticeably knocking. The vehicle was towed and inspected by an independent mechanic. The 3rd cylinder in the engine will no longer hold compression. I now need to get the vehicle to an engine specialist for further inspection and repair.

Filed Dec 5, 2025 · Engine · CA

Transmission is sluggish and the RPM’s fluctuate between 1200 and 1400 at any speed going back and forth so the car has a back and fourth motion. Engine failure on 12/3/25 car stopped while driving. Makes a loud knocking sound. Most likely faulty bearings due to poorly engineered camshaft. White pear paint peeling since I purchased car. Capital Honda in San Jose unable to address any issue saying nothing is covered under warranty. These issues where taking place even while under warranty.

Filed Sep 9, 2025 · Engine · TX

Engine auto off at an intersection. Would not restart. Burned up starter. Towed to Honda dealership. Rod bearing spun causing catastrophic damage to engine. Honda Care Extended warranty is covering at least part of the cost to replace either the shortblock, or possibly replace entire engine. No decision on which just yet.

Filed Sep 6, 2025 · Transmission · MT

Last time I changed my oil I had bronze colored flakes of metal in my oil. It looked like parts of the main connecting rod bearing material. No running problems YET, but will likely fail soon. I've kept up on oil changes every 5-7K. 89K on vehicle. Please do something about a full recall on this issue and include this report into the affected VINs.

Filed Apr 28, 2025 · Engine · MD

My 2020 Honda Pilot has 53k miles on it. I have have the vehicle for 8ths and 8k miles. The vehicle engine light suddenly began flashing and the vehicle began running rough. A loud knocking sound was coming from the engine when accelerating. The vehicle was taken to a Honda dealer and analyzed. The testing showed that the camshaft and cylinder #2 rod bearing was damaged to the point of the engine needing replacement. Upon research of the problem and damage found by the dealer, it matches a major issue found on many Honda's and Accura's. A manufacturing defect in the crankshaft leads to excessive wear and failure of the connecting rod bearings. This problem can cause the engine to suddenly seize or fail. Honda is currently refusing to cover the repair cost because the VIN of my vehicle isn't on the recall list.

Filed Apr 7, 2025 · Engine · KS

Our 2020 Honda Pilot has 96,000 miles on it. We were traveling on the interstate and the engine light came on and an immediate grinding and knocking sound was heard. We pulled over on an exit ramp. We called AAA and had the vehicle towed 35 miles to the nearest city. The vehicle was determined to have a connecting rod bearing failure that required the engine to be replaced. I understand there is a potential recall for this issue for Honda vehicles, that includes the 2020 Honda Pilot. I wanted to provide this information to support the federal safety agency's findings that there are issues with this engine that should not occur.

Filed Feb 27, 2025 · Engine · PA

[XXX]: While driving on [XXX] in Pennsylvania, my check engine light illuminated in a tight construction zone with jersey barriers & speed limit of 55 mph during inclement weather. I chose to remain behind a tractor trailer driving under the speed limit for the remainder of the construction zone approximately 1 mile. Once out of the construction zone, I attempted to pass the truck in front of me; however, when I moved into the passing lane, my vehicle would not accelerate to pass the truck placing myself and my 2 children in danger on [XXX] in inclement weather. Fortunately, I was able to safely return to the travel lane & then exited at the next exit which was about 2 miles away. I proceeded to a pull off right after the exit ramp & called my spouse. When he arrived, we decided to attempt to drive the vehicle home an alternate route; however, while driving about 2-3 miles the check engine light remained on & I was not able to accelerate beyond 35 mph. We decided to pull into our HS parking lot where I shut off my car for about 5 minutes. When the vehicle was restarted, the check engine light was no longer on, so we drove around the parking lot & the vehicle appeared to be operating normally allowing acceleration to occur, so we attempted to return home. While driving about 3 miles, the check engine light once again displayed as well as a series of other warnings. The vehicle began to shake and various noises were produced from the front end of the vehicle including what sounded like metal on metal grinding. ASAP, I proceeded to a parking lot to ensure safety for myself & children to stop the car and have it towed to a local mechanic, then to a Honda Dealership. After initial diagnostics, we were informed our engine failed & needed replaced due to what they suspected was a connecting rod bearing issue. Our engine is currently being replaced, but we informed them we wanted the defective engine held to be available for inspection for this investigation. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATIO

Filed Jan 8, 2025 · Engine · OH

We were driving down [XXX] in Columbus, Ohio and the cars started to lose power and felt a explosion or slip, right after all the dash board warning lights came on and oil light stating no oil, as I pulled over you could see tire width of oil 1/2 mile down the interstate and showing where I pulled and engine has seized up, I turned engine off , all lights stayed on and dash board, and engine was smoking bad, I got out until help arrived. husband opened hood and oil was everywhere, and car would not start. It was towed to Honda Dublin, Ohio and they inspected. Stated the engine had a hole in it and rod bearing had overheated and shot out of the block destroying the engine. WHY ARE THERE NO RECALLS. THIS CAR IS A 2020 UNDER $100K NOTHING WAS WITH IT AND STILL OWE $18K YET CAN'T BE DRIVEN. HAS THERE BEEN ANY SOLUTIONS? [XXX] if anyone else has experienced this please email me on what the end result was please. [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Dec 12, 2024 · Engine · FL

Engine developed a knocking, then started to sputter and ultimately stalled. No codes showed. Sent to dealership, they said I need a new engine, but could not tell me why. Again No codes drove car for 1 day, engine completely failed.